EXTERIOR LIGHTING:BRAKE LIGHTS; EXTERIOR LIGHTING:TAIL LIGHTS
2004 Ford F-550 Sd Recalls
Safety recall campaigns filed with NHTSA that cover this model year
Data refreshed
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govRecall campaigns
3 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is
EQUIPMENT:ELECTRICAL
ELECTRICAL SYSTEM:WIRING
What a recall is
- Safety recall
- A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
- Safety investigation
- NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
- Manufacturer communication
- Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Safety investigations
NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.
ENGINE STALLING
IN A JUNE 7, 2005 LETTER, FORD NOTIFIED ODI THAT IT WOULD BE CONDUCTING A SAFETY RECALL OF APPROXIMATELY 180,000 FORD F-SUPER DUTY, EXCURSION AND E-SERIES VEHICLES EQUIPPED WITH 6.0L DIESEL ENGINES TO CORRECT TWO WIRING RELATED CONDITIONS THAT COULD RESULT IN ENGINE STALL (NHTSA RECALL NO. 05V-270, FORD NO. 05S34).THE AFFECTED VEHICLES WERE BUILT BETWEEN SEPTEMBER 29, 2003 AND MAY 31, 2004.ACCORDING TO FORD, VEHICLES WITH THE CONDITIONS MAY STALL WITHOUT WARNING AND MAY OR MAY NOT RESTART.FORD WILL INSTRUCT OWNERS OF VEHICLES INCLUDED IN THE RECALL TO TAKE THEIR VEHICLES TO A DEALER TO HAVE THE FUEL INJECTOR CONTROL MODULE WIRE HARNESS UPGRADED OR REPLACED AND OR HAVE A NEW INJECTION CONTROL PRESSURE SENSOR CONNECTOR INSTALLED.DURING A MAY 2005 PRESENTATION TO ODI, FORD IDENTIFIED A NUMBER OF POTENTIAL FAILURE MECHANISMS THAT COULD AFFECT ENGINE PERFORMANCE IN VARIOUS SEGMENTS OF THE SUBJECT VEHICLE POPULATION, INCLUDING THE WIRING CONDITIONS ADDRESSED BY 05V-270.THE WIRING CONDITIONS, WHICH BOTH AFFECT ENGINE FUELING, WERE THE MOST LIKELY CONDITIONS TO RESULT IN ENGINE STALL.THE RECALLED VEHICLES COMPRISE APPROXIMATELY 43% OF THE SUBJECT VEHICLE POPULATION AND ACCOUNT FOR 75 OF THE 113 ODI REPORTS THAT HAVE A VALID VIN (66%).THE VOQ COMPLAINT RATE FOR THE RECALL POPULATION IS 45/100K WHILE THE RATE FOR VEHICLES OUTSIDE THE RECALL POPULATION IS 17/100K AND THEIR TREND (BY DATE OF RECEIPT) IS DECLINING.BASED ON THE ANALYSIS, ODI BELIEVES FORD?S ACTIONS ARE SUFFICIENT TO ADDRESS THE CURRENT SAFETY RISKS AND THE INVESTIGATION IS THUS CLOSED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT A SAFETY RELATED DEFECT DOES NOT EXIST.FURTHER ACTION WILL BE TAKEN IF WARRANTED BY FUTURE CIRCUMSTANCES.
Elsewhere on this vehicle
Data sources
- NHTSA Office of Defects Investigation — recall campaigns and safety investigations
Data on this page last refreshed .