2016 Hyundai Sonata Plug-In Hybrid

NHTSA received a petition on or about July 18, 2022, requesting that Federal Motor Vehicle Safety Standard (FMVSS) 141 be applied to all electric and hybrid vehicles operating in the United States. The petition can be reviewed at NHTSA.gov under ODI Number 11486072. FMVSS 141 establishes performance requirements for pedestrian alert sounds for motor vehicles. The standard applies to hybrid and electric vehicles that have a gross vehicle weight rating of 4,536 KG or less or are defined as low-speed vehicles. The standard became fully applicable to all such vehicles manufactured on or after March 1, 2021.On January 27, 2023, NHTSA opened Defect Petition (DP) 22-005 to evaluate the subject matter described in the petition. On June 24, 2023 and as supplemented on June 25, 2023, the petitioner notified NHTSA he was withdrawing his petition. The petitioner indicated that, based on his review of data, there is no justification for asserting potential benefits that could be derived from actions sought by my petition. Based on the petitioner's withdrawal, DP22-005 is closed. Closure of this DP does not represent a determination by NHTSA regarding the subject matter of the petition.

The National Highway Traffic Safety Administration (NHTSA) received a letter dated July 13, 2022, petitioning the Agency to initiate a safety defect investigation into loss of motive power allegations attributed to oil drain pan assembly failures on certain Hyundai Motor America, Inc. and Kia America, Inc. vehicles spanning Model Years (MY) 2005-2021. The Petitioners cited examples of complaints indicating that the subject vehicles were experiencing rapid loss of engine oil due to oil drain plug back outs, resulting in loss of motive power and/or catastrophic engine damage. Additional complaints were provided which alleged that the oil drain pans lack sufficient structural integrity and are susceptible to cracking. The petition itself can be reviewed at NHTSA.gov under ODI number 11481745. On September 12, 2022, the Office of Defects Investigation (ODI) opened Defect Petition (DP22-003) to evaluate the Petitioners’ request. The Petitioners have provided additional complaints within four supplemental letters dated January 31, 2023, March 21, 2023, May 23, 2023, and August 4, 2023. ODI’s evaluation included the review and analysis of the complaints and supporting information submitted by the Petitioners, as well as additional complaints submitted directly to NHTSA which referenced either the oil drain plug or a crack in the oil pan. After reviewing the available data, ODI has not identified evidence that would support opening a defect investigation into the oil drain pan assemblies of the subject vehicles. Based on a review of the available information, a loss of motive power resulting from an oil drain plug back out has not occurred between the initial sale of a vehicle and the completion of its first oil change. If during an oil change service, a technician fails to remove the existing drain plug gasket before installing a new gasket, it is likely that a proper seal between the drain plug and the oil pan will not be made. An improper seal between the drain plug and oil pan could lead to the backing out on the drain plug, resulting in the sudden loss of oil while driving. Additionally, the provided examples of oil pan cracks were localized to the immediate vicinity of the oil drain plug and/or appeared to be the result of direct-contact with a tool during servicing.  There is no information to support that a vehicle-based defect exists relating to the oil pan assembly, and instead the documented incidents are related to the failure to follow the proper maintenance procedures during oil change service. In October 2023, Hyundai published a Technical Service Bulletin (TSB) that provided detailed instructions for oil change service on its gasoline powered vehicles, specifically highlighting the need to remove and replace the existing drain plug gasket prior to reinstalling the drain plug. After a thorough review of the material submitted by the petitioner, the information already in NHTSA's possession, and the potential risks to motor vehicle safety implicated by the petitioners' allegations, NHTSA does not believe that a formal investigation is warranted. Therefore, the petition is denied. A Federal Register Notice (FRN) further detailing NHTSA’s reasons for denial of the petition will be published. The reference numbers for the complaints to NHTSA cited by the petitioner can be found in the petition submission documents in the public file for DP22-003. To review those complaints and the additional complaints ODI added to its evaluation which are cited in the Closing Resume ODI Report Identification Number document, go to NHTSA.gov.

The contact owns a 2016 Hyundai Sonata Plug-In Hybrid. The contact stated that on three separate occasions while driving approximately 65 MPH, the “Check Hybrid System - Turn Off Engine” message was displayed. The check engine warning light illuminated. The contact then stated that the vehicle decelerated and went into LIMP Mode. The vehicle was towed to the dealer however, the failure could not be duplicated. The contact stated that the failure recurred. The vehicle was taken back to the dealer but the failure could not be duplicated; however, the contact stated that he provided diagnostic test data to the technician that displayed error codes however, the failure could not duplicated. The vehicle was not repaired. The manufacturer was notified of the failure and the contact was provided a case number. The failure mileage was approximately 65,000.

NHTSA ID

11529173

Incident

Apr 12, 2023

Mileage

65,000 mi

While driving the car getting error message on dashboard "Check Hybrid System Turn Off Engine", The Gas engine turn off and switch to continue on electric till able to pull on the side of the road. Turn Off engine, wait a min. Start car again and working fine. This issue appears randomly many times in the last two years while driving. Car was at dealer shop multiple times with no repair, was told we don't see active error message or they can't re-create the error. however scan show P261F error. Open Ticket with Hyundai #21018148 while car at the dealers for weeks at the time. each time told check engine got back on but not the message they are looking for.

NHTSA ID

11514685

Incident

Nov 15, 2022

While driving the hybrid system warning light comes on and says to check hybrid system, vehicle goes into limp mode will not accelerate over 25 mph and codes need to be cleared before vehicle van be driven. This has caused me to almost have several accidents. The vehicle slows down and gives no warning prior to this occurring. It has started happening more frequently vehicle currently has 85k miles.

NHTSA ID

11500417

Incident

Jan 6, 2023

The contact owns a 2016 Hyundai Sonata Plug-In Hybrid. The contact stated while driving 70 MPH or faster in Hybrid Mode, the vehicle stalled. The HEV error warning light was displayed on the instrument panel. The check engine warning light was also illuminated. The contact turned off the vehicle and disengaged the HEV Mode for the vehicle to restart and function as intended. The failure occurred three times. The vehicle had been taken to the dealer however, the mechanics were unable to determine the cause of the failure. The vehicle was not repaired. The manufacturer was made aware of the failure and opened a case. The approximate failure mileage was 66,000.

NHTSA ID

11490124

Incident

Oct 10, 2022

Mileage

66,000 mi

My 2016 plug in hybrid Sonata repeatedly inidcates that there is "high system temperature switching to hybrid mode." This first happened on my first long trip in the car in 10/21 and has happened repeatedly since. This happens at all temperatures, including moderate temperatures (mid 70s). It seems to happen randomly, such as when battery has several miles of charge left in it, when it is fully discharged, and repeatedly when the car is already running in hybrid mode, which a driver could interpret means that the engine is about to shut down, as I did on a long trip. I have taken it to two separate dealers, and the only thing they did was replace the fuel pump, which did not solve the problem. In addition, the battery life has reduced greatly, despite the fact that I always fully discharge and recharge the batter. As you can see from the attached Hyundai forum comments, this appears to be a prevalent problem for this make and model car and no relief from the manufacturer appears to be on the horizon.

NHTSA ID

11478763

Incident

Oct 5, 2021

The contact owns a 2016 Hyundai Sonata Plug-In Hybrid. The contact stated while the vehicle was approaching a stop sign, the vehicle stalled. The contact stated there was no warning light illuminated. The vehicle was not drivable. The contact stated he manually pushed the vehicle to the side of the roadway. The contact went back with his trailer and trailered the vehicle to the local dealer where it was diagnosed with needing the Hybrid control unit to be replaced. The vehicle was not repaired. The manufacturer had been informed of the failure. The failure mileage was approximately 120,000.

NHTSA ID

11472475

Incident

Jun 11, 2022

Mileage

120,000 mi

In January of 2022, my vehicle experienced a complete power loss while driving to work, leaving the car coasting down the road. A Check Hybrid System warning came up on the dashboard, along with several other warning lights, including Check Engine. Luckily, I was able to pull over without an accident occurring. Once stopped, the vehicle did restart and got me to and back from work. A diagnosis effort made at a local Hyundai dealership was unsuccessful as they could not replicate the problem and found no error codes in the auto's CPU system. I continued to drive the vehicle, hoping it was a one time deal, but since then, the identical situation has occurred three more times. I was extremely lucky that I had been in a position to safely pull off to the side of the road. The car has not been driven since March 19, 2022. After researching this scenario online, it appears to be the exact situation reflected in the Hyundai Recall campaign 175 from 2018, where the dealership remove the original VPD module and replace it with a Battery Management System (BMS) that contains an Overvoltage Protection Device (OPD). The recall is said to have been done on my vehicle, but the exact situation has reoccurred. Every time time the car lost power, it was preceded by a shuttering feel in the car, an alarm would go off and the propulsion system would just shut down and the Check Hybrid light would come on. Hyundai's only response has been to drive the car until it fails again (can you believe that?) and bring it in again for diagnosis. Even if that were to be done, the technicians and others on the road, would then be put at risk, as well, if they drove the vehicle in an attempt to get it to fail. I am the second owner of this car and the recall was supposedly done prior to my purchase. I now wonder if the dealer knew of the problem and that is why it was $2K below KBB. I cannot safely drive the car and can't sell it without loss once this safety issue is revealed. Thank you.

NHTSA ID

11461197

Incident

Jan 20, 2022

This is a plug-in hybrid. Charging light on the dash blinks red indicating there is an issue (per manual). Also blinks while driving. Should be green. Still charges. Taken to two Hyundai dealerships. Computer produces no codes. Dealership does not know how to proceed. Safety concern is it’s unknown if battery is dangerous to charge? Is it dangerous to drive? How does a car indicate a problem but then give no codes.

NHTSA ID

11454948

Incident

Jan 3, 2022

The National Highway Traffic Safety Administration (NHTSA) has issued an urgent safety advisory regarding dangerous, counterfeit driver‑side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN), that have been identified in U.S. vehicles following prior crashes, theft, or non‑certified airbag replacements. These inflators are not approved for use, may rupture during deployment, and have caused serious injuries and fatalities. Please see attached announcement, provided by NHTSA, for more details.

The National Highway Traffic Safety Administration (NHTSA) has identified the presence of substandard and dangerous driver’s-side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN). These inflators were not supplied, approved, or authorized by the vehicle manufacturers and have primarily been found in vehicles that previously experienced a crash and underwent airbag replacement using non-genuine parts. These dangerous inflators have ruptured during deployment, posing a serious risk of injury or death due to metal fragments entering the vehicle cabin. To date, Hyundai is aware of three people who have died while driving a Hyundai vehicle with one of these substandard replacement airbag inflators that deployed in what likely would have been a survivable crash. NHTSA has issued a public advisory urging vehicle owners and service professionals to have vehicles inspected if there is reason to believe that a non-genuine replacement airbag may have been installed. Vehicles with salvage or rebuilt titles, prior airbag deployments, or unknown repair histories may present a higher risk. NHTSA strongly cautions against self-inspection by vehicle owners and recommends inspection by trained technicians.

This TSB references the Op codes to use for claim submission and the Parts required based on the vehicle’s inspection results from TSB 22-01-023H-2 (DTC P1326 – Engine Bearing Inspection/Engine Replacement) or the latest version.

This TSB references the Op codes to use for claim submission and the Parts required based on the vehicle’s inspection results from TSB 22-01-023H (DTC P1326 – Engine Bearing Inspection/Engine Replacement) or the latest version.

This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.

Some vehicles may exhibit a loss of connectivity or interruptions in the middle of using Bluelink Service functions. This may be due to an irregular disconnection on Verizon’s communication network. Follow the procedure in this TSB to reestablish the connection via the AVN pinhole reset method.