2022 Mercedes-Benz GLB 250

Recall reported since July, still no remedy available on Nov.

NHTSA ID

11775318

Incident

Nov 2, 2026

The contact owns a 2022 Mercedes-Benz GLB-250. The contact received notification of NHTSA Campaign Number: 26V481000 (Latches/Locks/Linkages); however, the part to do the recall repair was not yet available. The dealer was contacted. The dealer confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue.

NHTSA ID

11775137

Incident

Nov 2, 2026

When driving on the highway going 65mph the car slipped in neutral and error showed on dashboard "transmission malfunction stop." I could steer and break, but not accelerate. Pulling over on side of highway, I was able to put in park and then drive. I pulled off the exit and the car did the same thing within 10 mins. Car was towed to Mercedes dealership in Warwick, RI. I was made aware after inspection that there was nothing wrong with the vehicle nor the transmission, but rather there was a needed software update that was causing the issue that had been identified previously. Regular service was due, but no indication whatsoever of the error I saw nor any other error codes. No error showed up for the technicians in inspecting the car. I was further informed, after research, that the software update was being drafted and that it would have to pass NHTSA governance. So I'd like to know if this is accurate? If NHTSA is aware? If the software update is sitting with you for approval? What is Mercedes obligation to share this with drivers noting they were aware of issue? If my [XXX] was driving she could have been killed. If I was accelerating on the highway or turning in front of a vehicle legally, I could have been killed. Thank you. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11727263

Incident

Mar 16, 2026

My fuel injection has been replaced 2 times in 3 years. Was advised that it could cause damages to other parts

NHTSA ID

11681871

Incident

Aug 7, 2025

Brake over heats because of rust caused by rain which builds up causing brakes to freeze up. Explanation from dealer. In fact told us we need to dry brakes off if we drive in rain and park in garage for more than 2 days or we will have it happen again. Brakes freeze and car locked up and can’t move it. We bought the car used had it inspected by a MBD in Atlanta G. Bulkhead , told breaks were like new. Mileage 23,666 miles. Put on about 4000 miles now brakes gone froze up from rain. Garage kept. While driving car we were noticing almost like the breakers were on but not stepping on break. A pulling like action. Seemed like emergency brake was on. Car at dealership now in Greenville SC Mercedes Benz dealer.

NHTSA ID

11680547

Incident

Aug 14, 2025

Despite maintaining the vehicle according to the recommended schedule, I have encountered ongoing performance issues (electrical, rear shocks, fan motor etc.) that are not in line with the standard of quality I expect from a brand of your reputation. Window not going down all the way on the driver side. Radio not working but was fixed. These issues have caused inconvenience and concern regarding the reliability of the vehicle. To address my concerns, I spoke with a Mercedes-Benz representative who informed me that, due to the problems I’ve experienced, I may be eligible for either an extended warranty or a credit toward the purchase of a new vehicle. After careful consideration, I opted for the extended warranty. However, I was later informed that this option had not been approved—despite it initially being presented as available. This contradiction is both confusing and frustrating, and it has significantly diminished my confidence in the customer service process.

NHTSA ID

11668913

Incident

Sep 20, 2024

this car really has a lot of issues and honestly if I didn’t know what to do last night and didn’t know about cars, it could have seriously cost me my life but luckily I was able to move out the way of a truck that was coming fast behind me while I was at a traffic light and when the light turned green the car would not start back up from the automatic stop when you make stops and because the auto shut off never came back on and I had to literally make a split second decision and put it in park and start up again and go quick. The check engine light has been on since July 14,2024 and I bought the car on July 13,2024 and the dealership has not done anything about this issues and this morning these are all the codes that came up and there’s a lot of codes and Mercedes hasn’t called me back even after the calls and emails I’ve sent them, no one is calling me back.

NHTSA ID

11607732

Incident

Aug 9, 2024

Coordinate this complaint with previous complaints reference 11569682 and 11569502, As of last night the car has 1136 miles. I have thoroughly tested the car to the best of my ability and set and reset the settings. The hill decent has only engaged twice. The car is supposed to read speed limit signs and it does show up in the instrument panel but the car speeds up randomly i.e. from 35 to 50 and above to not limited to 35. The adaptive speed control at random will malfunction the car will not slow down and brake. This has happened several times. When turn signal is engaged and you enter turning lane the car may slow down or not. This vehicle I was told is a MBUA corporate vehicle held back at MBUSA for over 2 years then auctioned. Fletcher Jones Las Vegas had the vehicle on the lot with 47 miles and sold it to me with 48 miles. There is no maintenance or service record the driver assist system, hardware, software system was checked, calibrated, repaired or tested. Given the mileage the car was not road tested. " THIS VEHICLE IS A ROAD HAZARD WAITING FOR AN ACCIDENT TO HAPPEN" It needs to be repaired, road tested, and certified safe by MBUSA and Fletcher Jones. What is the secret and reason why MBUSA held back this car and then 2 years later auction it off? My wife nearly rearended a car that had slowed down and. The driver assist failed to slow down and stop the car. I have experienced this and other experience's listed above several times and sometimes 50% of the time and have to manually engage the brake to slow down, stop, and disengage driver assist system.

NHTSA ID

11569783

Incident

Feb 2, 2024

Complaint Slight creaking noises when steering. Cause Noises may come from one or more sleeves of the horn contact plate. Remedy Remove the horn contact plate and check the sleeves for noise; see attached video. If necessary, apply lubricant to the sleeves.

Complaint Repeat workshop visit for vehicle vibration while braking from 60MPH. NOTE: Although the symptom is similar to a tire or wheel vibration, it is usually readily noticeable that it is distinctly different if it happens at all times or only while braking. Cause Although the cause of the vibration is most likely due to excessive lateral runout on the rotor or hub/wheel bearing, the system as a whole needs to be checked for other possible contributors. 1. Prior collision damage. 2. Excessive vehicle sitting times without rotating components. 3. Wheel bearing/hub lateral runout. 4. Wheel mating interface has been overtightened (did not follow WIS torque procedures). 5. Mating interfaces have been excessively modified (painted, gouged, bent, etc...). Remedy Read through the entire attached worksheet prior to performing. After performing, please review the final page and perform work accordingly. NOTE: This document is not pre‑authorization or otherwise dealing with warranty. This is intended for diagnostic purposes only. If there are any questions on how to proceed OR The work sheet has been performed and the vehicle has returned with the same concern. Please perform the measurements as seen in the worksheet again and open a TIPS case to the Body, Chassis, and Entertainment team.

Complaint Radio station cover art does not refresh when switching stations. The UI continues to show the old station’s artwork instead of updating to the new one. Cause When a new station change request is triggered, a temporary glitch is causing the Head Unit application to fail to overwrite the previous request. This glitch is causing the cover art mismatch in the Radio application. Remedy Please do not replace any parts. Please update the Head unit software to E505.9

Complaint Clanking noise from the area of the speakers in the doors. Cause Under analysis. Remedy To narrow down the cause, first of all remove the door trim. • If the noise continues to occur even with the door trim removed, then continue the diagnosis working towards the speaker and if necessary, create a TIPS case with an informative video as an attachment. Note: Please refer to this document in the warranty claim and, once diagnosis is completed, select the damage code depending on the component part that is causing the issue. • If the noise stops when the door trim is removed, please proceed in accordance with LI72.10‑P‑067691. Information: In this case, do not use a damage code for the speakers in the warranty claim!

Complaint Temporary no start condition with check engine light and multiple warning messages. When performing a quick test, the following fault code is stored in Y3/14 ‑ Transmission control for 8‑speed dual‑clutch transmission (DKG): P24F100 The wake‑up line of the control unit has a short circuit to positive. Cause Possible signal timing between EZS control unit and Transmission Control Unit (DKG) Remedy As of 7/15/2026, new SCN coding is available for the EZS control unit. IPR will advise to open a TIPS case for EZS (N73), this is due to GLA models requiring support for SCN coding procedure. GLB (X247) and CLA (118) No TIPS case necessary. 1. SCN coding of EZS Control Unit 2. Clear all faults and perform extended road test with multiple drive cycles GLA (H247) Special function password required. 1. Verify if special procedure Central Locking ‑ Development Data is present in EZS (figure 1) 2. Submit a TIPS case to the Powertrain Inbox with the following information: ‑ Initial Quick Test w/ freeze frame data ‑ IPR Result ‑ DKG Control Unit Log ‑ EZS Control Unit Log ‑ Initial EEPROM data ‑ EZS special procedure menu If the vehicle has had this LI performed and P24F100 has returned, please submit a TIPS case to the Powertrain Inbox.

Complaint Intermittent shift feel or thud/clunk noise perceived, such as a brief jerk or transmission reaction during certain driving situations. May be most noticeable when transitioning from a coasting condition to accelerator pedal application. May occur in all drive modes. Cause Dual‑clutch transmissions (DCT) inherently exhibit more dynamic shifting behavior compared to other types of transmissions. This is due to the use of physical clutches for starting and gear changes. In certain situations, dynamic driving behavior can lead to a slight jerk sensation which is a normal technical characteristic of the transmission. A typical example is a "Change of Mind" situation: • The customer is coasting towards a red traffic light. • The traffic light turns green while the vehicle is still coasting. • The customer then presses the accelerator pedal. In these situations, a slight jerk may occur briefly because the transmission must quickly engage the appropriate gear and control the clutches accordingly. Since shift forks are responsible for engaging the gears during shifting, a slight shifting noise may also be noticeable. Please note driving programs S, S+, and M are designed to provide sportier vehicle behavior and are not optimized primarily for maximum comfort, so this operation may be more audible. Remedy Verify the customer's concern and confirm proper transmission operation. If no faults or abnormal operating conditions are identified by IPR (Intelligent Predictive Repair), no hardware replacement is necessary. Inform the customer that the transmission has been designed to provide direct gear engagement and responsive vehicle performance. Under certain operating conditions, brief shift sensations may be perceptible and are consistent with the operating characteristics of the dual‑clutch transmission