2012 Peterbilt 587 Problems
Owner-reported complaints filed with NHTSA, grouped by component
Data refreshed
What this page shows
Everything below is an owner-reported complaint submitted to NHTSA about the 2012 Peterbilt 587, grouped by the component NHTSA recorded on the report. These are not confirmed defects, and they are not recalls. NHTSA does not verify most reports before publishing them, and a category with more reports in it is not evidence that a part is defective.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Reports by component
Ranked by how many owner reports name each component category
- Electrical250.0%
- Engine125.0%
- Fuel system125.0%
Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.
Each component in detail
What the reports in each category say, in the owners' own words
Electrical
Reports naming the electrical system — wiring, battery, charging, control modules, infotainment and electrical accessories.
From owner reports, verbatim
2012 PETERBILT TRACTOR. CONSUMER WRITES IN REGARDS TO POTENTIAL FIRE DEFECT. *SMD THE CONSUMER STATED HE RECENTLY INVESTIGATED THE CAUSE OF A FIRE IN THE TRACTOR AND DETERMINED THE CAUSE TO BE RELATED TO A POTENTIAL DEFECT IN THE MANNER IN WHICH THE BATTERY CABLES WERE SUPPORTED. THE BATTERY CABLES PASSED FROM THE BATTERY BOX ON THE DRIVER SIDE OF THE TRACTOR, AT A POSITION BEHIND THE CAB, TO THE ENGINE COMPARTMENT. AT THE LOCATION WHERE THE BATTERY CABLES PASSED THE ELECTRONIC CLUTCH ACTUATOR, THEY WERE HELD IN PLACE BY A PLASTIC TIE. DUE TO DRIVE TRAIN VIBRATION AND MOVEMENT, THE PLASTIC TIE USED TO SECURE THE BATTERY CABLES TO THE CLUTCH ACTUATOR SHIELD WERE PRONE TO FAILURE. THE PLASTIC TIE BROKE AT SOME TIME DURING ITS SERVICE LIFE AND THE WEIGHT OF THE BATTERY CABLES CAUSED THEM TO MIGRATE TOWARD THE BOTTOM OF THE CLUTCH ACTUATOR SHIELD. MOVEMENT BETWEEN THE UNSECURED CABLES AND THE SHIELD, WHICH OCCURRED OVER TIME, ABRADED THE INSULATION OF ONE OF THE POSITIVE CABLES. ONCE THE ELECTRICAL INSULATION FAILED, THE CABLE ARCED AGAINST THE SHIELD, ENERGIZING THE ENGINE AND TRANSMISSION. UPDATED 7/1/13 ...UPDATED 10-24-13 *BF
TL* THE CONTACT OWNS A 2012 PETERBILT 587. THE CONTACT STATED THAT HE NOTICED SMOKE COMING FROM THE UNDERCARRIAGE. THE CONTACT EXITED THE VEHICLE AND DISCOVERED THERE WAS A FIRE. THE CONTACT WAS ABLE TO EXTINGUISH THE FIRE WITH A FIRE EXTINGUISHER. AFTER FURTHER INSPECTION, IT WAS DETERMINED THAT THE BATTERY CABLE HAD IGNITED. THE CABLES WERE ATTACHED TO THE ELECTRONIC CLUTCH ACTUATOR, WHICH HAD A PLASTIC COVER. THE PLASTIC TIE FRACTURED AND CAUSED THE BATTERY CABLES TO FAIL, ENERGIZING THE TRANSMISSION AND ENGINE BLOCK. THE HIGH HEAT CAUSED IT TO BECOME COMBUSTIBLE. THE VEHICLE WAS NOT REPAIRED. THE FAILURE MILEAGE WAS UNKNOWN BECAUSE OF THE FIRE DAMAGE. *TR UPDATED 7/2/13 *CN THE CONSUMER STATED DUE TO THE VIBRATION AND MOVEMENT, THE PLASTIC TIE USED TO SECURE THE BATTERY CABLES TO THE CLUTCH ACTUATOR SHEILD IS PRONE TO FAILURE. UPDATED 11/1/2013 *JS
Too few reports in this category for a page of its own — they appear in the full complaint list.
Engine
Reports naming the engine itself — including stalling, misfires, oil consumption, cooling and internal engine components.
From owner reports, verbatim
The contact owns a 2012 Peterbilt 587. The contact stated while driving 65 MPH, the vehicle stalled. The contact was unaware of a warning light being illuminated. The contact pulled over to the side of the road where the vehicle failed to restart. The vehicle was towed to West Truck Services Center, where it was diagnosed and determined that the fuel pump had failed. The vehicle was then towed to the dealer, where it was diagnosed that the fuel pump plungers had fractured and intruded the engine. Additionally, the dealer informed the contact that there were metal shavings inside the oil filter. The dealer determined that the fuel pump and engine rod bearings needed to be replaced. The vehicle was being repaired. The contact related the failure to TSB Number: 140019. The manufacturer was notified of the failure and a claim was filed; however, the claim was denied. The failure mileage was 468,742.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Fuel system
Reports naming fuel storage or delivery — tanks, pumps, lines, injectors and fuel leaks.
From owner reports, verbatim
The contact owns a 2012 Peterbilt 587. The contact stated while driving 65 MPH, the vehicle stalled. The contact was unaware of a warning light being illuminated. The contact pulled over to the side of the road where the vehicle failed to restart. The vehicle was towed to West Truck Services Center, where it was diagnosed and determined that the fuel pump had failed. The vehicle was then towed to the dealer, where it was diagnosed that the fuel pump plungers had fractured and intruded the engine. Additionally, the dealer informed the contact that there were metal shavings inside the oil filter. The dealer determined that the fuel pump and engine rod bearings needed to be replaced. The vehicle was being repaired. The contact related the failure to TSB Number: 140019. The manufacturer was notified of the failure and a claim was filed; however, the claim was denied. The failure mileage was 468,742.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Elsewhere on this vehicle
Data sources
- NHTSA Office of Defects Investigation — owner-reported complaints and the components recorded on them
Data on this page last refreshed .