RoadVitals

2022 Terex TL Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
2
Newest Dec 2, 2022
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

2 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

22V893000

EQUIPMENT:MECHANICAL:BOOM/CRANE/LADDER

Dec 2, 2022
431 units potentially affected
The defect: Terex South Dakota, Inc. (Terex) is recalling certain 2022 C4000, C5000, C6000, C7000, General, and Trans TL vehicles. A seam in the boom structure may have been improperly welded, causing the weld to crack.
The risk: A cracked weld may lead to the boom failing, increasing the risk of an injury.
The remedy: Dealers will replace or repair the boom, free of charge. Owner notification letters were mailed on February 8, 2023. Owners may contact Terex's customer service at 1-605-882-4000. Terex's number for this recall is SN715.
Terex South Dakota, Inc.Manufacturer number SN715View on NHTSA.gov
22V674000

EQUIPMENT:MECHANICAL:BOOM/CRANE/LADDER

Sep 8, 2022
194 units potentially affected
The defect: Terex South Dakota, Inc. (Terex) is recalling certain 2019-2022 TL80, TL80/112, and TL100 aerial devices. The welds for the platform leveling cylinder support bosses may crack, which can cause the cylinder support pin to fail and allow the platform to tip.
The risk: A platform that tips during use increases the risk of an injury.
The remedy: Dealers will install reinforcement plates to the boom tip platform leveling cylinder bosses, and, all TL80/112 aerial devices will have the hydraulic storage latch for the elevator replaced, free of charge. Owner notification letters were mailed on October 13, 2022. Owners may contact Terex's customer service at 1-605-882-4000. Terex's number for this recall is SN712.
Terex South Dakota, Inc.Manufacturer number SN712View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources