POWER TRAIN:MANUAL TRANSMISSION
2016 Can-Am Spyder F3
Recalls, owner-reported complaints, investigations and safety data
Data refreshed
Overview
Our database contains 2 NHTSA owner-reported complaints for the 2016 Can-Am Spyder F3, most frequently naming the brakes category. 1 safety recall has been issued covering this model year; and 17 manufacturer communications are on file.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Complaint activity over time
When owners filed reports about this model year
Not enough dated records to plot a meaningful trend — 2 months of data.
What owners report
Complaints grouped by the component NHTSA recorded
- Brakes1100.0%
Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.
Safety recalls
1 campaign cover this model year
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govRecent owner complaints
Reports submitted to NHTSA, shown in the owner's own words
2016 CanAm Spyder F3 Limited had a bad front sprocket. Began making noise & vibrating when on the road. Took it to the dealer & it was the front sprocket that is now under recall. I had the Spyder repaired at the cost of $465.46. I notified CanAm of my expenses to replace the sprocket & provided the bill from the dealer. They are refusing to now refund my expenses for the repair. They want to give me a credit towards CanAm products which I do not want any CanAm products. I want a refund for what I spent to fix the Spyder which is now under recall & the new sprocket will have to be replaced because it is also a defective sprocket.
- NHTSA ID
- 11468576
- Incident
- Oct 21, 2021
ON SATURDAY MAY 6, 2017 I TEST DROVE A 2016 CAN AM SPYDER F3. IT WAS A CLEAR, BUT CHILLY AND WINDY DAY IN NORTH EAST GEORGIA. I HAD PREARRANGED A TEST RIDE WITH MOUNTAIN MOTORSPORTS IN BUFORD, GA. THE MACHINE WAS PREVIOUSLY OWNED, BUT HAD LESS THAN 1000 MILES ON THE ODOMETER. THE ISSUE: WHILE TRAVELING IN THE RIGHT-MOST LANE IN I 85 NORTH, ON CRUISE CONTROL AND TRAVELING AT APPROXIMATELY 69 MPH, THE TRAFFIC WELL AHEAD OF ME STARTED TO SLOW DOWN. I IMMEDIATELY DISENGAGED THE CRUISE CONTROL AND BEGAN TO COAST THE MACHINE. I THEN NOTICED THE TRAFFIC AHEAD OF ME WAS STOPPED. I REACHED WITH MY RIGHT FOOT TO DEPRESS THE BRAKE PEDAL. I COULD NOT 'FIND' THE BRAKE PEDAL. AT THIS POINT THE TRAFFIC AHEAD OF ME WAS STOPPED AND I WAS FORCED TO TAKE EVASIVE MANEUVERS. I BEGAN TO DOWNSHIFT FRANTICALLY AND ENTERED THE EMERGENCY SHOULDER ON THE RIGHT OF I 85. I SUCCESSFULLY PASSED SEVERAL VEHICLES ON THE RIGHT WHILE IN THE EMERGENCY SHOULDER LANE. //THANKFULLY, I WAS ABLE TO SUCCESSFULLY BRING THE MACHINE ALL THE WAY DOWN TO 1ST GEAR AND LESS THAN 10 MPH WITHOUT STRIKING ANY VEHICLES OR OTHER OBJECTS. //AFTER STOPPING IN THE EMERGENCY SHOULDER AND GATHERING MY COMPOSURE, I LOOKED DOWN AT THE BRAKE PEDAL. I NOTICED THAT IT HAD FLIPPED BACK (UPSIDE DOWN) AND WAS INOPERABLE. //AFTER SUCCESSFULLY GETTING THE VEHICLE TO REST AGAINST A CURB IN A CONVENIENCE STORE PARKING LOT, I INVESTIGATED THE BRAKE ISSUE MORE CLOSELY. SEE ATTACHED PICS! //AS YOU SHOULD BE AWARE, THIS SINGLE POINT OF FAILURE RENDERS THE BRAKES ON THE MACHINE COMPLETELY INOPERABLE AND LEAVES THE OPERATOR AT EXTREME RISK! //HAD I BEEN HEADING INTO A BUSY INTERSECTION, OR TRAVERSING A SERIOUS CURVE OR ANY NUMBER OF OTHER REAL, ON-ROAD SCENARIOS, I CANNOT IMAGINE WHAT COULD HAVE HAPPENED? I AM ONLY HAPPY TO BE ALIVE AND NOT INJURED!
- NHTSA ID
- 10983890
- Incident
- May 6, 2017
- Mileage
- 900 mi
Manufacturer communications
A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.
POWER TRAIN
The front sprocket might be stuck on the mainshaft upon disassembly
ELECTRICAL SYSTEM; ENGINE AND ENGINE COOLING
Engine Oil Level reading Issue Impossible to read the oil level on the dipstick.
ELECTRICAL SYSTEM; POWER TRAIN
Revision of TST 140875 P0730 Active Fault Fault code can be triggered if the unit has the wrong rear sprocket or a different wheel size. The cluster will stop displaying the gear indication and check engine light came on (limp home condition) and the gearbox won't shift.
POWER TRAIN
Spyder P0730 Active Fault - This fault code can be triggered if the unit has the wrong rear sprocket or a different wheel size. The cluster will stop displaying the gear indication and check engine light came on (limp home condition) and the gearbox won't shift.
ENGINE AND ENGINE COOLING; FUEL SYSTEM, GASOLINE
Missing or damaged scavenge pump components could lead to poor engine performance on 1330 engines.
POWER TRAIN
Front Sprocket Wear- Interim Solution As covered in the SAFETY CAMPAIGN BULLETIN 2019-10, The front sprocket may be defective and may be subject to premature wear.
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Compare model years
Complaint and recall counts across every year of this model
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.