2007 Chevrolet Avalanche

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

IN A LETTER DATED AUGUST 27, 2008, GENERAL MOTORS CORP. (GM) NOTIFIED NHTSA THAT IT WILL CONDUCT A SAFETY RECALL (NHTSA RECALL NUMBER 08V-441) TO ADDRESS A SAFETY RELATEDDEFECT THAT CAN RESULT IN ENGINE COMPARTMENT FIRE IN APPROXIMATELY 850,000 VEHICLES EQUIPPED WITH A HEATED WINDSHIELD WASHER FLUID OPTION.THE SUBJECT VEHICLES OF THIS INVESTIGATION COMPRISE OVER THREE-QUARTERS OF THE RECALL POPULATION. ACCORDING TO GM, A SHORT CIRCUIT ON THE PRINTED CIRCUIT BOARD FOR THE WINDSHIELD WASHER FLUID HEATER MODULE MAY OVERHEAT THE CONTROL-CIRCUIT GROUND WIRE. THIS MAY CAUSE OTHER ELECTRICAL FEATURES TO MALFUNCTION, CREATE AN ODOR OR CAUSE SMOKE AND IN RARE CASES IT MAY CAUSE A FIRE.AS A REMEDY, GM DEALERS WILL INSTALL A WIRE HARNESS WITH AN IN-LINE FUSE. IN ADDITION TO THE SUBJECT VEHICLES, SEVERAL OTHER GM MODELS WITH THE HEATED WINDSHIELD WASHER FLUID OPTION ARE INCLUDED IN RECALL 08V-441: MY 2006-2008 BUICK LUCERNE (MANUFACTURED AUGUST 2005 THROUGH NOVEMBER 2007); MY 2008 BUICK ENCLAVE (MANUFACTURED FEBRUARY 2007 THROUGH APRIL 2007); MY 2006-2008 CADILLAC DTS (MANUFACTURED MAY 2007 THROUGH NOVEMBER 2007); MY 2007-2008 SATURN OUTLOOK (MANUFACTURED AUGUST 2006 THROUGH APRIL 2007); AND MY 2007-2008 GMC ACADIA (MANUFACTURED AUGUST 2006 THROUGH APRIL 2007) VEHICLES.GM IS INSTRUCTING OWNERS TO TAKE THEIR VEHICLE TO A DEALER FOR SERVICE IF THEY EXPERIENCE SYMPTOMS OF WINDSHIELD WASHER HEATER MODULE SHORT CIRCUITS. GM'S RECALL RESOLVES THE SAFETY DEFECT CONCERNS PURSUED BY THIS INVESTIGATION.THIS ENGINEERING ANALYSIS IS CLOSED.

Traveling hiway on cruise. My 5.3l down shifted to accelerate to go up an incline. Shortly after that there was low to almost no power. Check engine light then came on. I was able to do 30mph on freeway to get it home. Took it to a local garage since gray Daniels chevy wouldn’t service it since I recently transitioned to MS. The problem was the #4 lifter had collapsed. It costed me just shy of $4k out of pocket. I’ve read that this was a recall item for my vehicle, I was never notified. I would like to be compensated if this was indeed a recall item

NHTSA ID

11732748

Incident

Jan 10, 2022

First recall, Only dealer on Island (Hawaii) went out of business and couldn't be done by a GM dealer. Windshield washer fluid heater was removed by a mechanic shop at my own expense. Second recall, The passenger airbag inflator hasn't been done due to the fact that 2007 - 2014 Chevy Avalanche, Tahoe, Suburban & GMC Yukon are known for cracked dashboards which includes my Avalanche. My dashboard was cracked before the airbag recall and I covered the dashboard with fiberglass mat and resin to repair it as a new dashboard was not covered by warranty and exceeded over $2,000.00 to replace. The area to access the airbag is sealed and would require a new dashboard. There is now a new Chevy dealer here that can do the recall but I would have to pay the cost to replace the dashboard so it hasn't been done as I'm not able or willing to pay for the additional expense.

NHTSA ID

11667854

Incident

Jun 18, 2025

Airbag warning won't go says my airbag is disabled

NHTSA ID

11667269

Incident

Jun 16, 2025

Code p2128 Code p2122 Have replaced TPS, THROTTLE BODY, ACCELERATOR PEDAL (×3) AND bypassed connectors WITH DIRECT WIRING from ACCELERATOR PEDAL TO ECM Continue to get codes with CHECK ENGINE LIGHT with DECREASED ENGINE POWER, CHECK STABILITRAK, and STABILITRAK DISABLED. HAVE TO CLEAR CODES WITH BLUEDRIVER MULTIPLE TIMES EVEN WHILE DRIVING SHORT DISTANCES AND SOMETIMES ON START UP.

NHTSA ID

11598334

Incident

Jul 2, 2024

The contact owned a 2007 Chevrolet Avalanche. The contact stated that while driving at approximately 60 MPH, he lost control of the vehicle after driving over a pothole and crashed into a telephone pole. The pole fell on the vehicle and the fire department had to remove the contact from the vehicle. The front passenger's side of the vehicle was damaged. The air bags in the vehicle failed to deploy during the impact. The contact sustained three fractured ribs and one lacerated lung which required medical attention via hospital. The vehicle was towed and deemed destroyed. A police report was filed. The contact mentioned that the vehicle was previously serviced for an unknown NHTSA Campaign Number for the Air Bags prior to the crash. The manufacturer was not notified of the failure. The failure mileage was approximately 100,000.

NHTSA ID

11593712

Incident

May 21, 2024

Mileage

100,000 mi

Was going down the road and there was a big load bang or pop that sounded like a bomb went and the seatbelts sucked us back and locked us in place and then the service airbag light came on the light stays on the seatbelts are locked up can remove and it was like the air bags says will no longer deploy/work and now can't use the seatbelts and the law says no seatbelt use we get a ticket so now can't drive truck unless I want a ticket. So what do I do now I am disabled and this my only vehicle that I need to get to the doctors with so how to get it fixed is the manufacturer responsibility. My email is [XXX] My phone number is [XXX] Would like someone to contact me ASAP PLEASE INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11574539

Incident

Feb 27, 2024

Dash is cracked in so many spots and missing peices to where it is unsafe. In an accident those loose and broken peices can hurt a passenger/driver. Can't even get the airbag recall taken care of because the dash is too damaged.

NHTSA ID

11554131

Incident

Nov 8, 2007

The contact owns a 2007 Chevrolet Avalanche. The contact stated that while the vehicle was at the dealer for a service appointment, the contact was informed that the subframe was severely corroded. The contact was informed that the subframe and parts connected to the frame would also need to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 125,675.

NHTSA ID

11553865

Incident

Sep 2, 2023

Mileage

125,675 mi

This Preliminary Information communication provides information to the technician about vehicles that have an intermittent no crank, no start, or start stall concern with the security light coming on. Technician may find Diagnostic Trouble Codes B3055, B3060, B3935, C0750, C0755, C0760, C0765, and/or C0775.

This PI communicates the requirement to provide a pico file to receive diagnostic assistance from TAC.

This Preliminary Information communication provides information to the technician about the use of J-35616-64B and Mini 50 terminal test probe, replacement terminals, and terminated leads.

This Preliminary Information communication provides information to the technician about the use of J-35616-64B and Mini 50 terminal test probe, replacement terminals, and terminated leads.

This Preliminary Information communication provides information to the technician about the use of J-35616-64B and Mini 50 terminal test probe, replacement terminals, and terminated leads.

This service bulletin provides a procedure to flush and bleed power steering system to correct a power steering noise or fluid leak concern that is caused during extremely low temperatures.