Reports submitted to NHTSA by owners and drivers, shown in full
Data refreshed
Our database holds 342 NHTSA owner-reported complaints for the 2017 Chevrolet Bolt EV. Each one is a report filed by an owner or driver and published by NHTSA without most of them being verified. A complaint is not a confirmed defect, not a recall and not a manufacturer bulletin. Narratives are shown exactly as filed.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Showing 1–25 of 342 · page 1 of 14
I am experiencing a commonly reported issue with the steering rack binding and failing to self-center after a turn. Turning the steering wheel left and right has become increasingly more stiff over time. Unreliable steering, especially during turns could potentially lead to an accident/collision.
Steering is binding, does not return to center when turning, it has play in the steering, and rattles and shakes when driving in the highway. Dealer said it needs a steering shaft replacement. The car has been doing this since it had less than 50k miles. There were no warning lamps or messages. Since this is steering, it is dangerous and puts others at risk. The steering binding is a safety issue, and if left along long enough it might fully bind up causing an accident, and also reduces my ability to sense road traction conditions and make fine adjustments; I feel a recall is warranted because of the serious nature of this problem.
Infotainment unit did not come on. Connection error displayed. Backup camera did not display when in reverse.
Infotainment unit did not boot up. Had a communications error. No rear back up camera view when put car in to reverse.
Component or system that failed/malfunctioned: The Electric Power Steering (EPS) Gear / Steering Rack Assembly. The component has not yet been removed from the vehicle and is available for physical inspection upon request. How safety is put at risk: When navigating low-speed turns or accelerating from a stop where the steering wheel is rotated to approximately 45 degrees, the steering gear mechanically binds and catches. The wheel completely fails to self-center or return to a straight position on its own. The driver must apply sudden, manual physical force to yank the wheel back to center. This creates an immediate loss-of-control and lane-departure hazard during low-speed maneuvers. Because this is a progressive mechanical wear issue, there is a severe risk of a total steering lockup at higher highway speeds. Confirmation by dealer/independent center & manufacturer inspection: The vehicle has not yet been inspected by a dealer, independent service center, or the manufacturer due to the high out-of-pocket cost of the repair. The owner is operating the vehicle with extreme caution while awaiting a formal safety recall regarding this documented steering gear defect. Warning lamps, messages, or prior symptoms: No electronic dashboard warning lights or error messages have illuminated. The primary prior symptom was a subtle, rotational scraping/friction noise heard coming from the front driver-side wheel well when passing roadside walls or barriers, indicating ongoing mechanical friction within the steering assembly. The 45-degree steering binding first appeared several months ago and has progressively worsened.
Backup camera failed to turn on.
While slowing to a stop, the vehicle suddenly experienced multiple (3–4) violent jerks. The vehicle fought against my firm brake pedal application, overpowered the brakes, and accelerated uncontrollably, resulting in a crash. During the impact: • The driver frontal airbag and pretensioners deployed. • The driver seatbelt unlatched mid-impact and then locked/retracted in a way that prevented it from latching again, even while I was sitting in the driver’s seat post-crash. I have only been provided with the limited Airbag Control Module (SDM) data, which shows the brake switch as “Off” and low accelerator pedal readings. This data does not match the events I experienced. I have formally requested full downloads from all other modules (Powertrain/PCM, ABS/EBCM, BCM, etc.) from both the insurance company (ESIS) and GM, but they have only provided the single SDM report. This appears to be a sudden unintended acceleration event combined with a brake override failure and seatbelt restraint system malfunction.
The steering has become stiff; the steering wheel does not return to center after a turn without driver assistance.
I started losing Regen braking intermittently, when this happens the brakes themselves don't work well and there's no warning, you lift of the pedal expecting the car to stop and its rolling freely, to push brake and its not stopping like you expect, then it thuds and lunges forward a bit and stops. It was rarely happening, now the car can barely be driven. I have not got it into a shop yet. It throws DTC P182B, P182D, P1840, and U0401 every time. Clearing them, even while still moving brings it all back to normal, except an image of my previous drive will be frozen on infotainment that I have to hard reset to get it to work. Also backup camera does now work when these codes are active. I have found 1 person online that is having this exact issue. It's terrifying to approach a stop light and used to 1 pedal driving and I'm rolling freely instead. the first incident of it was 03/05/26 and has progressively worsened. My code scanner keeps records of when I clear the codes,
The steering gear (rack and pinion) assembly exhibits clunking when turning the steering wheel at low speeds, and does not return to center at higher speed (stays in turned position when let go). This is available for inspection upon request. Our safety is put at risk because the steering feels strange and does not behave as with other cars, requiring force to return the wheel to center in a turn at speed. This problem has been confirmed by a qualified service center and they attempted to fix it by replacing the intermediate steering column, but it did not resolve the issue. There were no warning messages.
Sometimes, when driving in a turn, either direction, and hands are released from the steering wheel, the vehicle does not return to center. Force is required to cause the steering to begin returning to center. Once it begins returning to center, seems to always continue to center. This is a dangerous departure from decades of common vehicle operation. An unsuspecting driver can drive into an obstacle or people.
I am reporting a safety issue involving the high-voltage battery system of my vehicle. Vehicle: 2017 Chevrolet Bolt EV VIN: [XXX] Mileage: 87,125 miles The vehicle has generated a P302F diagnostic trouble code, which indicates high-voltage battery cell imbalance. This condition may pose a safety risk related to battery performance and thermal stability. The authorized Chevrolet dealership has refused to diagnose the issue under warranty unless I pre-authorize a $600 diagnostic fee. The vehicle is covered under an active GM buyback warranty and a 10-year / 100,000-mile battery warranty due to a recall battery replacement. Due to the safety implications of a high-voltage battery fault, I believe refusal to diagnose the issue under warranty may pose a risk and warrants review. I am submitting this complaint to document the issue and request investigation. Thank you. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Vehicle started to surge while driving (both small acceleration forward and large deceleration) without any change in brake or accelerator position. Eventually a "Propulsion Power Reduced" message was presented on the console followed immediately by no forward propulsion (accelerator completely unresponsive) and forced to coast to a stop on the side of the highway. Car refused to shift out of park or neutral following breakdown. Car taken to dealer to troubleshoot and was told that a P0A3F code was present and that the engine harness needed to be replaced in accordance with NHTSA bulletin 19-NA-220. This bulletin calls out that the harness was likely damaged during initial install at factory and the dealer representative confirmed that the pins were damaged as described. Car was given back to drive home after harness was checked (owner decided to explore options before scheduling repair), but broke down due to surging and complete loss of power within 2 miles of dealer. Troubleshooting to confirm harness damage is suspected to have worsen the condition and made un-commanded accel/deceleration followed by complete loss of power likely. Uncertain why this condition would be exempt from recall if OEM is aware of installation issues at factory. Driving with this condition was as bad or worse than other type model loss of power conditions that have been recalled. Recommend at least clarifying that cars confirmed to fall under this bulletin and associated inspection should not be deemed roadworthy until a repair is made.
Steering rack broke, wheel won’t return to center. Dealer wants $3k dollars to fix. This should be recalled as the amount of cars it happens to is significantly high.
My wife of [XXX] and grandson were driving our Chevrolet Bolt, crossing a busy 4 lane highway when suddenly and w/o any prior warning, the Bolt lost propulsion. Caught blocking 2 of those lanes, she was fortunate that men stopped their trucks and pushed her car up hill and into a church parking lot. She called me and I tried resetting everything to factory settings, and the Bolt seemed okay-for a short time. I hooked a diagnostic unit to the car and found an error code that indicated either the failure of the pre-charge resistor or the HV contactor-both in the battery pack. This was a pack replaced by the dealership back when Bolts were randomly catching fire and destroying themselves and nearby property. Now these packs are failing again and there are service bulletins addressing this fact and that it is common in 2017 and 2018 Bolts. GM however has not sent out warnings to its unfortunate customers warning them of this common failure and life- threatening problem. Luckily today I'm dealing with the Bolts warranty rather than two funerals. All of that took place on 11/22/25. In the hour following the first failure, this situation repeated itself 4 more times. The last time there was no restarting it, or the car would shake if put into drive or reverse. As it was Saturday we had to wait until today 11/24/25 to get it towed to the dealership for $140. This failure will require dropping the battery pack and running three tests, then replacement of the faulty components. This should be under warranty according to our and the dealerships records, but this issue need to hit the national news and all Bolt owners should be sent letters warning of sudden and unpredictable failures. This was life threatening for us and will be for many others. Imagine this happening at interstate speeds in heavy traffic. Lives will be lost. This is the second and more dangerous failure for these horrible vehicles, and GM should at this point replace these or refund every owner. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATI
The steering on the car does not return to center and sticks to the position turned and has to be manually pushed back to center. This is an issue with the steering rack.
The steering does not self-center after making a turn. It feels stiff and remains in the turned position, requiring manual effort to bring it back to center.
Steering doesn't return to center after turning. In sweeping turns, it is quite dangerous as the vehicle wants to push harder into the turn and requires operator to push the wheel back toward center to keep the vehicle on the road
The steering wheel in the Chevrolet Bolt fails to return to center on its own. This is due to the steering rack grease hardening over time. This is a common issue with these cars but I am willing to offer my car for inspection on request. This is a safety and usability issue - my wife has carpal tunnel and struggles to properly return the vehicle to center when making a turn without pain. This does not show any specific warning lights. The component in this car has not been inspected, but the symptoms are always apparent, so it is always reproducible. This is very similar to if the power steering in a gas car were to fail. We have not had the issue fixed yet, but will likely need to do so in order to continue using the car safely.
Steering wheel sticks and doesn't return to center. Service center says the steering rack need to be replaced. The issue creates a significant safety hazard by impeding my ability to control the vehicle during turns, potentially leading to accidents.
Sticking steering wheel. Does not return to center, stiff steering. If steering wheel is not manually return to center, vehicle will continue to turn.
On August 17th, 2025, my wife was driving our 2017 Chevrolet Bolt EV at low speed, pulling into a parking spot. The vehicle suddenly accelerated forward with enough force to cause significant damage to a fixed barrier. She does not recall pressing the accelerator at that moment. The degree of acceleration was disproportionate for a brief accidental press. Immediately after impact, smoke or dust was visible rising through the center console area. No airbags deployed, but it appeared similar to smoke from pyrotechnic devices. My wife sustained seatbelt-related bruising across the chest and thighs. The vehicle remains drivable. I have included photos detailing damage to the car and the fixed barrier. We are aware of the GM accessory all-weather floor liner recall (21E-089), but are not certain if our vehicle’s liner was part of that campaign. We are reporting this incident to ensure there is a record in case this reflects unintended acceleration or another defect.
This tends to only happen below 74 degrees Fahrenheit and happens excessively between 72 and 74 degrees Fahrenheit. While driving with one pedal engaged (labeled as low on the shifter since they re-used another model's shifter for the first several years of the Bolt EV), the cruise control will randomly disengage and force the vehicle to immediately slam on the brakes. Usually its not a big deal, but when it happens at highway speed as you're just passing a semi or large vehicle and merging back into the lane in front of it, it becomes dangerous very quickly, which has happened a couple of times now. I would venture a guess that its not related to the cruise control directly, but some system that its relying on is forcing it to deactivate the cruise control. The only other issue this vehicle is having that might be related is that the blind spot detection system is not working correctly on the left side. I know there's a TSB for the aluminum Butyl tape becoming damaged or missing, but if that's causing my car to slam on its brakes in front of fully loaded semis, Chevy should probably be persuaded into re-coding how their cruise control gets disengaged. Especially since this blind spot detection system issue seems somewhat common. Either way, something is causing my car to randomly slam on its brakes in the middle of the highway and Chevy says there's nothing they can do about it because its not setting a code. This is definitely a dangerous safety issue that they should be forced into actually diagnosing more than just plugging a computer in and saying: "whelp, nothing to see here." and returning it to the customer with a "we can't do anything, sorry."
STEERING WILL NOT RETURN TO CENTER. STIFF AND SLUGGISH.
Steering wheel is not returning to center after a turn. It can be dangerous in certain situations where you would expect the steering to center after making a turn. Took it into a mechanic and they said its a common issue on the bolts. Power steering rack is faulty. This needs to be investigated.... Lots of complaints online!
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Categories with enough reports to have a page of their own
Data on this page last refreshed .