2007 Chrysler Crossfire

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

The contact owns a 2007 Chrysler Crossfire. The contact stated that while driving approximately 70 MPH, the heated rear glass window separated and detach from the convertible top of the vehicle. The contact stated that the rear glass was glued to the convertible cloth top of the vehicle. The vehicle was taken to the local dealer who informed the contact that the entire convertible top needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure, but no assistance was provided. The failure mileage was 30,500.

NHTSA ID

11748000

Incident

Jul 1, 2026

Mileage

30,500 mi

The contact owns a 2007 Chrysler Crossfire. The contact was advised of NHTSA Campaign Number: 16V081000 (AIR BAGS). The vehicle was taken to several dealers; however, the dealers refused to complete the recall repair. The contact was informed that since the vehicle was an older model, the dealers did not have the appropriate equipment to code the vehicle. The vehicle was not repaired. The manufacturer was made aware of the issue and advised the contact that a Takata field inspector would reach out. The contact was informed that the air bag sensor had failed; however, due to the age of the vehicle and the equipment not being available, the air bag sensor would fail. The failure persisted, and the vehicle remained at the residence unrepaired. The vehicle was no longer driven out of safety concerns. The failure mileage was approximately 13,400.

NHTSA ID

11715862

Incident

Jan 5, 2025

Mileage

13,400 mi

The contact owns a 2007 Chrysler Crossfire. The contact received a recall notice from the manufacturer for NHTSA Campaign Number: 16V081000(Air Bags). The contact had taken the vehicle to several local dealers, where the contact was informed that the special tool needed to complete the recall repair was unavailable. The contact stated that the air bag warning had illuminated recently. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was contacted, but the contact had not received a call back. The failure mileage was 17,726.

NHTSA ID

11708294

Incident

Nov 28, 2025

Mileage

17,726 mi

My car has 47,800 miles on it and is a convertible. Its a known problem among crossfire owners and it hasn't been resolved. The problem is the rear window is coming undone and just falls out. The dealerships won't fix it and auto repair shops want thousands of dollars. It's not only a quality issue but a HUGE safety issue as well. If that window was to fall while someone is driving the car it could injure them while they are driving or possibly fall onto the road and causing countless problems and injuries to the other motorists driving behind the car. Its not an issue of the owner of the car being negligent or miss using the vehicle, its a quality and safety issue.

NHTSA ID

11442645

Incident

Nov 1, 2021

Hello, I have installed Ground Control adjustable camber arms on my vehicle to permit camber adjustment to within factory recommendations. These same model camber arms are failing on a number of vehicles which are identical to mine (Chrysler Crossfire). My vehicle has not yet failed. A photo is attached. They pose an extreme safety hazard, as they can cause complete loss of vehicle control. There have been no injuries yet, but it is only a matter of time. Thank you for considering my report.

NHTSA ID

11421766

Incident

Jun 15, 2021

CONVERTIBLE TOP REAR WINDOW SEPARATED FROM THE TOP. CALLED CHRYSLER CUSTOMER CARE. NOTHING THEY COULD DO. NO WARRANTY. NO RECALL. IN MOTION WHEN SEPARATED ON RURAL ROAD. *TR

NHTSA ID

11330323

Incident

Jun 23, 2020

Mileage

52,900 mi

ON MAY 18, 2020 AS I WAS DRIVING AT ABOUT 25 MPH, I HEARD A SCRAPING NOISE COMING FROM THE REAR GLASS AREA. I PULLED OVER TO DETERMINE WHAT WAS THE PROBLEM. I THEN NOTICED THE REAR GLASS WINDOW HAD FALLEN INTO THE CAR, HELD INTACT BY THE REAR DEFROSTER CORD CATCHING IT AND LOOSELY DANGLING IN THE BREEZE. I INFORMED CHRYSLER OF THIS PROBLEM (CHRYSLER CUSTOMER HOTLINE 1-800-992-1997, CASE NUMBER 76293394), BUT THEY OFFERED NO ASSISTANCE, EVEN THOUGH I HAVE RESEARCHED THIS ISSUE AND HAVE FOUND MANY COMPLAINTS THROUGH GOOGLE AND YOUR OWN WEBSITE, NHTSA.GOV. IF I HAD BEEN DRIVING AT AN INTERSTATE SPEED OF 65 MPH, THE GLASS COULD HAVE ENTERED THE VEHICLE AND KILLED ME! I HAVE ALSO LEARNED THAT CHRYSLER GAVE A 10 YEAR/100,000 MILE WARRANTY TO OWNERS OF 2005 CROSSFIRES WITH THE SAME ISSUE! I DEMAND NOT ONLY AN APOLOGY FROM CHRYSLER ALONG WITH A NO CHARGE REPAIR OF THIS CONDITION, BUT ALSO THE SAME TREATMENT 2005 OWNERS RECEIVED, THE 10 YEAR/100,000 MILE WARRANTY. THIS VEHICLE HAS BEEN METICULOUSLY MAINTAINED SINCE DELIVERY, DRIVEN SPARINGLY, AND GARAGED NIGHTLY. THANK YOU FOR YOUR ASSISTANCE IN THIS MATTER. *TR

NHTSA ID

11326920

Incident

May 18, 2020

Mileage

36,500 mi

TL* THE CONTACT OWNS A 2007 CHRYSLER CROSSFIRE. WITHOUT WARNING, THE REAR WINDOW FRACTURED. THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE DEALER WAS NOT CONTACTED. THE FAILURE MILEAGE WAS NOT AVAILABLE. THE CONSUMER STATED THE REAR WINDOW CAME COMPLETELY UNGLUED FROM THE CONVERTIBLE TOP. THE VEHICLE WAS TAKEN TO AN INDEPENDENT SHOP TO REGLUE THE WINDOW. THERE WAS NO GUARANTEE THE FAILURE WOULD NOT RECUR. *JS *BF *TR

NHTSA ID

11218529

Incident

Jun 5, 2019

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Transmission Kit with Torque Converter 1. All Promaster (VF) 3.6L/62TE equipped vehicles. If the transmission bracket to the transmission case fasteners are removed during servicing, the fasteners (Part Number 06511385A$) are one-time usage. Vehicles built prior to 10/23/2015 requires Service Kit PN 68461214AA; includes Transmission Isolator PN 68264483AA, and Adaptation Bracket 68264479AA and Fastener Service Kit PN 68329056AA Vehicles built after on or after 10/23/2015 will require only the Fastener Service Kit PN 68329056AA. 2. All 3.6L/62TE equipped vehicles. If the vehicle you are repairing has a crack in the flex plate or failed pump bushing inspect and confirm that both (2) dowel pins are present in the engine block, which align the transmission center line to the crank shaft centerline and visually inspect the dowel alignment holes in the transmission case. If the holes are damaged or elongated the transmission should be replaced to prevent further damage to the transmission/flexplate or pump bushing due to the inability to properly align the engine to the transmission during the repair. 3. All 62TE equipped vehicles. If pump bushing is scored or damaged and the dowel pin alignment holes are ok, replace the pump assembly as opposed to complete transmission. 4. All 62TE equipped vehicles. If vehicle is jerking/slipping with MIL code(s) P0740 or P2764, check TCC Solenoid operation. If TCC Solenoid is ok, the codes are indicative of a torque converter failure. Replace the torque converter.

Convertible Switch Lamp Flashes When Attempting To Operate The Power Convertible Top, Convertible Top Does Not Operate to Open

Convertible Switch Lamp Flashes When Attempting To Operate The Power Convertible Top, Convertible Top Does Not Operate to Open

Disinfectant Solution Recommended for COVID-19