2008 Chrysler Crossfire

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

Back window separated from soft top on both side and part of the bottom

NHTSA ID

11421662

Incident

Jun 19, 2021

TL* THE CONTACT OWNS A 2008 CHRYSLER CROSSFIRE. THE CONTACT STATED THAT WHILE DRIVING APPROXIMATELY 15 MPH, THE VEHICLE SUDDENLY SHUTOFF. THE VEHICLE WAS TOWED TO THE LOCAL DEALER HAYES CHRYSLER JEEP LOCATED AT 3115 FRONTAGE RD, GAINESVILLE, GA 30504 WHO REPLACED THE BATTERY. AFTER RETRIEVING THE VEHICLE AND DRIVING APPROXIMATELY 2 MILES, THE ENGINE SHUTOFF A SECOND TIME. THE CAUSE OF THE FAILURE WAS NOT YET DETERMINED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE VIN WAS NOT AVAILABLE. THE FAILURE MILEAGE WAS 12,000.

NHTSA ID

11387751

Incident

Jan 10, 2021

Mileage

12,000 mi

REAR WINDOW IN CONVERTIBLE TOP FELL OUT WHILE IN DRIVEWAY 3 DAYS AGO

NHTSA ID

11231904

Incident

Jul 12, 2019

Mileage

23,116 mi

TL* TAKATA RECALL. THE CONTACT OWNS A 2008 CHRYSLER CROSSFIRE. THE CONTACT RECEIVED A RECALL NOTICE FOR NHTSA CAMPAIGN NUMBER: 16V081000 (AIR BAGS). DESERT 215 SUPERSTORE (8030 RAFAEL RIVERA WAY, LAS VEGAS, NV 89118) AND THE MANUFACTURER WERE NOTIFIED ON MULTIPLE OCCASIONS AND STATED THAT THE TOOLS NEEDED TO INSTALL THE REPLACEMENT PART WERE NOT AVAILABLE. THE CONTACT HAD NOT EXPERIENCED A FAILURE. PARTS DISTRIBUTION DISCONNECT.

NHTSA ID

11229331

Incident

Feb 1, 2016

THE HEADLINER ON THE ROOF IN MY 2008 CHRYSLER CROSSFIRE HAS DETACHED COMPLETELY EXCEPT FOR THE SIDE AND REAR COMPARTMENT UPPER EDGES AND HAS SUNKEN/FALLEN IN FRONT OF ME AND MY PASSENGERS FIELD OF VIEW COVERING OUR EYES AND RESTING ON OUR HEADS PLUS BLOCKING MY DRIVERS REAR VIEW MIRROR TO THE BACK WINDOW FIELD OF VIEW AS WELL. THIS IS CERTAINLY A SAFETY HAZARD AND APPARENTLY CAUSED FROM A POOR QUALITY APPLICATION OF HEADLINER GLUE/DECOMPOSING FABRIC. THIS CAR IS KEPT IN PRISTINE SHAPE AND COVERED ALMOST CONTINUOUSLY. THERE HAVE BEEN NO EXTERNAL FORCES, MISTREATMENT, NOR CHEMICAL APPLICATIONS CAUSING THE SOURCE OF THE PROBLEM. IT OCCURRED WHILE IT WAS PARKED IN MY DRIVEWAY, NOT ON THE PUBLIC STREET DURING A TWO-WEEK PERIOD OF NON-USE. I AM UNABLE TO DRIVE IT AT THIS TIME.

NHTSA ID

11221326

Incident

Jun 14, 2018

Mileage

45,000 mi

2008 CHRYSLER CROSSFIRE. CONSUMER WRITES IN REGARDS TO TAKATA AIRBAG INFLATOR SAFETY RECALL. *LD THE CONSUMER STATED AFTER THE AIRBAG INFLATOR RECALL WAS COMPLETED THE SRS LIGHT ILLUMINATED. THE MANUFACTURER WAS NOTIFIED. *JS

NHTSA ID

11032392

Incident

Apr 26, 2017

WHILE VEHICLE WAS AT THE DEALER FOR ROUTINE MAINTENANCE I WAS TOLD THE REAR WINDOW OF MY CONVERTIBLE FELL OUT AND WAS LAYING ON THE REAR SHELF. WAS TOLD THERE WAS NOTHING CHRYSLER COULD DO ABOUT THIS. SEEMS THIS IS QUITE COMMON WITH THE TOPS. A RECALL WAS ISSUED FOR THE 2005 MODELS BUT SEEMS THE PROBLEM STILL EXIST. WAS ALSO TOLD TO HAVE THE TOP REPLACED ($2500) AND KEEP THE RECEIPT IF THERE IS A RECALL I WOULD BE REIMBURSED. THERE HAVE BEEN HUNDREDS OF COMPLAINTS ABOUT THIS. HOW MANY DOES IT TAKE?

NHTSA ID

11010550

Incident

Jul 18, 2007

Mileage

50,000 mi

TL* THE CONTACT OWNS A 2008 CHRYSLER CROSSFIRE. THE CONTACT RECEIVED NOTIFICATION OF NHTSA CAMPAIGN NUMBER: 016V081000 (AIR BAGS); HOWEVER, THE PART FOR THE RECALL REPAIR WAS UNAVAILABLE. THE CONTACT STATED THAT THE MANUFACTURER EXCEEDED A REASONABLE AMOUNT OF TIME FOR THE RECALL REPAIR. THE CONTACT HAD NOT EXPERIENCED A FAILURE. THE MANUFACTURER WAS NOT MADE AWARE OF THE ISSUE. VIN TOOL CONFIRMS PARTS NOT AVAILABLE.

NHTSA ID

10943805

Incident

Jan 9, 2017

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Transmission Kit with Torque Converter 1. All Promaster (VF) 3.6L/62TE equipped vehicles. If the transmission bracket to the transmission case fasteners are removed during servicing, the fasteners (Part Number 06511385A$) are one-time usage. Vehicles built prior to 10/23/2015 requires Service Kit PN 68461214AA; includes Transmission Isolator PN 68264483AA, and Adaptation Bracket 68264479AA and Fastener Service Kit PN 68329056AA Vehicles built after on or after 10/23/2015 will require only the Fastener Service Kit PN 68329056AA. 2. All 3.6L/62TE equipped vehicles. If the vehicle you are repairing has a crack in the flex plate or failed pump bushing inspect and confirm that both (2) dowel pins are present in the engine block, which align the transmission center line to the crank shaft centerline and visually inspect the dowel alignment holes in the transmission case. If the holes are damaged or elongated the transmission should be replaced to prevent further damage to the transmission/flexplate or pump bushing due to the inability to properly align the engine to the transmission during the repair. 3. All 62TE equipped vehicles. If pump bushing is scored or damaged and the dowel pin alignment holes are ok, replace the pump assembly as opposed to complete transmission. 4. All 62TE equipped vehicles. If vehicle is jerking/slipping with MIL code(s) P0740 or P2764, check TCC Solenoid operation. If TCC Solenoid is ok, the codes are indicative of a torque converter failure. Replace the torque converter.

Convertible Switch Lamp Flashes When Attempting To Operate The Power Convertible Top, Convertible Top Does Not Operate to Open

Convertible Switch Lamp Flashes When Attempting To Operate The Power Convertible Top, Convertible Top Does Not Operate to Open

Disinfectant Solution Recommended for COVID-19