2014 Dodge Charger Police

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

FUEL PUMP ELECTRICAL CONNECTOR KEEPS BURNING THE FUEL PUMP PLASTIC AT THE ELECTRICAL CONNECTORS AND CAUSES A FUEL LEAK INTO THE CAR CABIN, UNDER THE REAR SEAT. REPLACED BURNED FUEL PUMP 3 TIMES AND IS BURNED UP AGAIN AND LEAKING FUEL WITHIN SIX MONTHS. THERE IS A DEFECTIVE ISSUE, HUNDRED OF COMPLAINTS I SEE ONLINE, WITH NO RESOLUTION TO FIX THE ISSUE. THIS IS VERY DANGEROUS, I HOPE MY CAR DOES NOT EXPLODE KILLING MY FAMILY.

NHTSA ID

11180931

Incident

May 1, 2018

Mileage

105,000 mi

TAKATA RECALL IT'S A VERY COMMON PROBLEM THAT I CAME TO FIND OUT AFTER SEARCHING IT OWN GOOGLE THE CAR WELL RANDOMLY BECOME NON RESPONSIVE TO ACCELERATING THE RPMS WELL RISE BUT THE SPEED WON'T ITS VERY DANGEROUS WHEN TRYING TO MERGE ON THE HIGHWAY CHANGE LANES OR A PULL OUT FROM A STOP SIGN IT'S HAS CAUSED ME TO GET INTO A CAR ACCIDENT BECAUSE MY CAR JUST STOP GOING MIDWAY THROUGH A INTERSECTION

NHTSA ID

11166165

Incident

Jan 1, 2018

Mileage

73,000 mi

WAS DRIVING 25 MPH THEN STEERING SHUTS DOWN ON ME AND THEN ALMOST GOT KILLED TRYING TO STOP AND TURN TO A SAFE AREA. LOOK UNDER THE HOOD AND SEEMS FUSE IS BLOWN

NHTSA ID

11130810

Incident

Sep 22, 2018

Mileage

67,000 mi

Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On

LIFTER, Hydraulic Roller Deactivating Please do not replace MDS lifters because the disconnecting pin is not lined up, this is normal and not a defect.

LIFTER, Hydraulic Roller Deactivating Please do not replace MDS lifters because the disconnecting pin is not lined up, this is normal and not a defect.

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Warranty Bulletin D-16-03 - "Can / Am" Warranty Coverage - 594 / 595 / 596 WCC (Rev. B)