2022 GMC Canyon Electrical Problems

The contact owns a 2022 GMC Canyon. The contact stated that while the gear shifter was shifted to park(P), the contact was unable to remove the key from the ignition switch. The contact stated that after turning the steering wheel to the right in a certain way, the key was able to be removed from the ignition switch. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure, and a complaint was filed. The failure mileage was approximately 30,000.

NHTSA ID

11753239

Incident

May 1, 2024

Mileage

30,000 mi

2022 GMC Canyon AT4 Crew Cab. After the vehicle is shifted into Park and the engine is shut off, the ignition key cannot be removed from the cylinder. The key is physically locked, the steering wheel will not lock, and the vehicle cannot be reliably secured. The only workaround is to restart the engine and cycle the shifter repeatedly until the interlock releases the key. Recurring. Safety implications: operator cannot reliably power the vehicle off in an emergency, cannot lock the steering column, and may be forced to leave an unattended vehicle in accessory mode — fire, electrical, and theft risk. The defect is documented in GM's own literature. GM Bulletin PI1429 and GM TSB 19-NA-206 address this exact symptom on the Canyon/Colorado platform. NHTSA-archived GM TSB MC-10113734 (March 2015), "Ignition Key Cannot Be Removed and/or Does Not Rotate to the 'Off' Position," names the 2015 GMC Canyon and Chevrolet Colorado. The 2022 Canyon uses the same shifter and ignition-interlock architecture. Documented cause: failure of the transmission control lever microswitch that signals "Park" to the interlock solenoid. Documented fix: replace the shifter assembly. Reported to an authorized GMC dealer while still under the New Vehicle Limited Warranty. Dealer recorded the concern verbatim — "key stays locked in ignition when shifting to Park" — and closed it "unable to duplicate," no repair, despite the open bulletins. A second GMC dealer later refused to inspect, with the service advisor stating on the service drive that there is no fix, that they see this on Canyons and Colorados all the time, and that he had seen another such vehicle the day before. No diagnostic, no repair order. GM's Technical Assistance Center has since taken the position that the bulletins above do not apply to this vehicle, which is inconsistent with the bulletins themselves. No crash, no injury, no fire. Reporting a manufacturer-documented ignition-interlock defect GM is refusing to repair.

NHTSA ID

11740040

Incident

Feb 16, 2026

At various times key can not be removed from the ignition. I understand this to be a common problem on these trucks, but dealer does not agree.

NHTSA ID

11726344

Incident

Dec 10, 2025

The contact owns a 2022 GMC Canyon. The contact stated that after starting the vehicle, the instrument cluster failed operate as designed and the speedometer, tachometer, fuel gauge, and turn signals failed to display as intended. The contact stated that a message to service several systems was displayed. The radio screen was blank, and the back over prevention system was inoperable. The vehicle was taken to the local dealer to be diagnosed, and it was determined that several software updates were needed; however, it was then determined that all the software was up to date. A software refresh was performed, and the vehicle was repaired. The manufacturer was notified of the failure. The failure mileage was 39,500

NHTSA ID

11717480

Incident

Feb 9, 2026

Mileage

39,500 mi

The contact called on behalf of her son who owned a 2022 GMC Canyon. The contact stated while her son was driving at an undisclosed speed, the brake pedal was depressed, and the brakes failed to engage. Additionally, the infotainment screen was inoperable. The front camera module warning light was illuminated. The vehicle was taken to an independent mechanic where it was diagnosed and determined that the front camera module needed to be replaced. The dealer made the contact aware of NHTSA Campaign Number: 24V133000 (ELECTRICAL SYSTEM, FORWARD COLLISION AVOIDANCE); however, the VIN was not included in the recal. The vehicle was not repaired. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline to report the failure. The failure mileage was unknown.

NHTSA ID

11703949

Incident

Dec 6, 2025

Error code p0494 conducted upon check engine light coming on.

NHTSA ID

11632364

Incident

Dec 25, 2024

The ECU electric control model has now burned up 3 times and the dealership just keeps replacing it the only thing they keep saying not to fill up the gas tank all the way? The gas gauge just goes dead

NHTSA ID

11632317

Incident

Dec 12, 2024

Key gets stuck in ignition when attempting to turn off vehicle. This leaves people stranded with their vehicles in hot/cold weather, dangerous areas, etc... Many people have been bypassing this problem by removing steering column and disconnecting a wire that allows the key to be released. But disconnection of said wire allows the key to be removed and shut off at any time, including driving down the highway at 70mph, serious safety hazard for driver and those on the road. Dealer has confirmed this issue and currently working on repairing my vehicle but it is a widespread issue with certain GM vehicles to include the canyon, colorado, camaro, and equinox.

NHTSA ID

11608098

Incident

Aug 8, 2024

Service Power Steering, Drive with care warning comes on, vehicle looses all power steering. First time it happen was around November 2023. This will happen randomly, at various speeds, sometimes going straight, sometimes turning. Power steering will come back after a few minutes sometimes, a few times vehicle had to be turned off for a hour, but was out for over 3 days one time. During that incident we ran OBD scanner, C0800 code was showing for Power Steering Control Module, recommended repair was the replace battery, even though the battery was good. We went ahead and replaced the battery anyways, issue was not immediately resolved but after running the truck for an hour and then going for a test drive power steering returned a mile down the road. That was around May 11th. Issue hadn’t returned until today, June 22nd where it’s went on and off a handful of time before totally loosing power steering for over 5 hours now. 2015 model years had an issue the power steering rack wiring, dealer said they assume it could be same issue. Connections to the steering rack where check and corrosion was found but they won’t fix because it’s not a recall even though it’s the same corrosion issue the 2015 models had.

NHTSA ID

11597806

Incident

Jun 22, 2024

The contact owns a 2022 GMC Canyon. The contact stated that while attempting to start the vehicle, the contact became aware of a failure by removing the key from the ignition. The contact stated that in 15 to 20 minutes he was able to remove the key. The contact had to restart the vehicle several times and switch gears until the key was removed. There was no warning light illuminated. The vehicle was taken to the dealer where the diagnostic result was undisclosed. The contact was informed that the ignition switch needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure and referred the contact to the NHSTA Hotline for assistance. The failure mileage was approximately 36,746.

NHTSA ID

11592104

Incident

Jun 3, 2024

Mileage

36,746 mi

The truck smokes constantly, dash board faulty frame has a problem I suspect the engine head gasket is blown radio constantly needs adjusting seats look as if they may be separating from the floor terrible fuel consumption gear shift sticks and more and battery charging problem

NHTSA ID

11568637

Incident

Jan 29, 2024