2022 GMC Canyon Problems

The contact owns a 2022 GMC Canyon. The contact stated that while the gear shifter was shifted to park(P), the contact was unable to remove the key from the ignition switch. The contact stated that after turning the steering wheel to the right in a certain way, the key was able to be removed from the ignition switch. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure, and a complaint was filed. The failure mileage was approximately 30,000.

2022 GMC Canyon AT4 Crew Cab. After the vehicle is shifted into Park and the engine is shut off, the ignition key cannot be removed from the cylinder. The key is physically locked, the steering wheel will not lock, and the vehicle cannot be reliably secured. The only workaround is to restart the engine and cycle the shifter repeatedly until the interlock releases the key. Recurring. Safety implications: operator cannot reliably power the vehicle off in an emergency, cannot lock the steering column, and may be forced to leave an unattended vehicle in accessory mode — fire, electrical, and theft risk. The defect is documented in GM's own literature. GM Bulletin PI1429 and GM TSB 19-NA-206 address this exact symptom on the Canyon/Colorado platform. NHTSA-archived GM TSB MC-10113734 (March 2015), "Ignition Key Cannot Be Removed and/or Does Not Rotate to the 'Off' Position," names the 2015 GMC Canyon and Chevrolet Colorado. The 2022 Canyon uses the same shifter and ignition-interlock architecture. Documented cause: failure of the transmission control lever microswitch that signals "Park" to the interlock solenoid. Documented fix: replace the shifter assembly. Reported to an authorized GMC dealer while still under the New Vehicle Limited Warranty. Dealer recorded the concern verbatim — "key stays locked in ignition when shifting to Park" — and closed it "unable to duplicate," no repair, despite the open bulletins. A second GMC dealer later refused to inspect, with the service advisor stating on the service drive that there is no fix, that they see this on Canyons and Colorados all the time, and that he had seen another such vehicle the day before. No diagnostic, no repair order. GM's Technical Assistance Center has since taken the position that the bulletins above do not apply to this vehicle, which is inconsistent with the bulletins themselves. No crash, no injury, no fire. Reporting a manufacturer-documented ignition-interlock defect GM is refusing to repair.

After driving vehicle and parking vehicle turn key off key will not turn all the way off to pull key out of ignition switch. The vehicle had 35,750 miles when brought to dealership I had told them this has happened multiple times I had to restart vehicle move vehicle shift vehicle manually or drive around block park again and then key would turn all the way off and come out, When I was contacted from the GMC dealership they said they could not duplicate the problem but I have paperwork from them and the mileage during drop off which was 35,750 miles and pickup at 35,751 miles I also told them to drive the truck it is not going to happen sitting in the dealership parking lot but they only went 1 mile, The warranty for this problem will be up at 36,000 miles. I drove the vehicle 8 miles from the dealership to my house no problems drove another drove another 6 miles to the car wash and went through the car wash went to park to vacuum and wipe exterior the key would not turn all the way off stuck in the accessory position had to back up and move vehicle to another spot park and then the key turned all the way off so I could get key out

While driving out of a parking lot, my power steering stopped working and I had to regain control to manually steer the vehicle. After stopping and turning off the engine to check the serpentine belt, the power steering came back on, but the lane departure assist function was no longer working. It appears to be the same problem that some of the 2015 and other GMC Canyon models had. Took it to my GMC dealer for warranty evaluation.

2022 GMC Canyon AT4 Crew Cab. After the vehicle is shifted into Park and the engine is shut off, the ignition key cannot be removed from the cylinder. The key is physically locked, the steering wheel will not lock, and the vehicle cannot be reliably secured. The only workaround is to restart the engine and cycle the shifter repeatedly until the interlock releases the key. Recurring. Safety implications: operator cannot reliably power the vehicle off in an emergency, cannot lock the steering column, and may be forced to leave an unattended vehicle in accessory mode — fire, electrical, and theft risk. The defect is documented in GM's own literature. GM Bulletin PI1429 and GM TSB 19-NA-206 address this exact symptom on the Canyon/Colorado platform. NHTSA-archived GM TSB MC-10113734 (March 2015), "Ignition Key Cannot Be Removed and/or Does Not Rotate to the 'Off' Position," names the 2015 GMC Canyon and Chevrolet Colorado. The 2022 Canyon uses the same shifter and ignition-interlock architecture. Documented cause: failure of the transmission control lever microswitch that signals "Park" to the interlock solenoid. Documented fix: replace the shifter assembly. Reported to an authorized GMC dealer while still under the New Vehicle Limited Warranty. Dealer recorded the concern verbatim — "key stays locked in ignition when shifting to Park" — and closed it "unable to duplicate," no repair, despite the open bulletins. A second GMC dealer later refused to inspect, with the service advisor stating on the service drive that there is no fix, that they see this on Canyons and Colorados all the time, and that he had seen another such vehicle the day before. No diagnostic, no repair order. GM's Technical Assistance Center has since taken the position that the bulletins above do not apply to this vehicle, which is inconsistent with the bulletins themselves. No crash, no injury, no fire. Reporting a manufacturer-documented ignition-interlock defect GM is refusing to repair.

At first start the first gear slips this has been going on for 2 years. Is been serviced 3 times and no one seems to know what the problem is. The services tech did discover the issue but couldn't figure out what the problem is. I only have 19,000 mile and its on warranty I'm hoping this matter can be resolved. Thanks, [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

At various times key can not be removed from the ignition. I understand this to be a common problem on these trucks, but dealer does not agree.

The contact owns a 2022 GMC Canyon. The contact stated that after starting the vehicle, the instrument cluster failed operate as designed and the speedometer, tachometer, fuel gauge, and turn signals failed to display as intended. The contact stated that a message to service several systems was displayed. The radio screen was blank, and the back over prevention system was inoperable. The vehicle was taken to the local dealer to be diagnosed, and it was determined that several software updates were needed; however, it was then determined that all the software was up to date. A software refresh was performed, and the vehicle was repaired. The manufacturer was notified of the failure. The failure mileage was 39,500

Error code p0494 conducted upon check engine light coming on.

The ECU electric control model has now burned up 3 times and the dealership just keeps replacing it the only thing they keep saying not to fill up the gas tank all the way? The gas gauge just goes dead

Error code p0494 conducted upon check engine light coming on.

The truck smokes constantly, dash board faulty frame has a problem I suspect the engine head gasket is blown radio constantly needs adjusting seats look as if they may be separating from the floor terrible fuel consumption gear shift sticks and more and battery charging problem

Vehicle doors are uneven. Crooked. Headlights/taillights get foggy to the point where you cannot see the lights. Doors wont shut properly. Powertrain issues. Vibration after certain speeds. Transmission delays gear switching. Transmission kicking and banging. Exhaust has a hole in it. I can provide more videos details via the email if possible.

Rear extended door ajar dashboard icon and dome light turns on while driving. This is corrected by closing hard the rear extended door before driving the automobile.

To Whom It May Concern, This letter is submitted to report a safety-related defect involving an airbag sensor failure on a 2022 GMC Canyon. The vehicle experienced a failure of an airbag sensor that is part of the Supplemental Restraint System (SRS). The sensor is required for proper airbag deployment and system readiness. Failure of this component compromises the operation of the airbag system and presents a potential safety risk to vehicle occupants. The failure occurred on a vehicle approximately four years in service and was diagnosed as an airbag sensor defect. The sensor assembly includes an integral gasket, and the failure of that gasket resulted in sensor malfunction and airbag system fault indications. General Motors and the administrator of the GMC Platinum Protection Plan were notified of the defect. Coverage for the repair was refused on the basis that a component of the sensor assembly was allegedly excluded, despite the fact that the gasket is integral to the sensor and the failure affects a federally regulated safety system. As a result of this refusal, a safety-related defect involving an airbag system was not repaired. The matter was treated as a contractual coverage issue rather than addressed as a potential defect impacting occupant protection. This submission is intended to notify NHTSA of a failure involving an SRS component that may affect other similarly manufactured vehicles. An airbag sensor failure raises concerns regarding component durability, system reliability, and compliance with applicable Federal Motor Vehicle Safety Standards (FMVSS). This complaint is submitted for logging, review, and any action the Office of Defects Investigation deems appropriate.

The contact owns a 2022 GMC Canyon. The contact stated that while driving at 45–50 MPH, he was blinded by the sun and crashed into the rear of a 2010 Volkswagen Jetta. The air bags did not deploy. The contact noticed that the service air bag message was displayed on his app after the crash. The contact sustained injuries to his head and cervical spine, and medical attention was provided. A police report was filed. There was no reported fire. The vehicle was towed to a tow lot. The local dealer was not contacted. The manufacturer was not notified. The failure mileage was approximately 14,000.

Vehicle doors are uneven. Crooked. Headlights/taillights get foggy to the point where you cannot see the lights. Doors wont shut properly. Powertrain issues. Vibration after certain speeds. Transmission delays gear switching. Transmission kicking and banging. Exhaust has a hole in it. I can provide more videos details via the email if possible.

The contact called on behalf of her son who owned a 2022 GMC Canyon. The contact stated while her son was driving at an undisclosed speed, the brake pedal was depressed, and the brakes failed to engage. Additionally, the infotainment screen was inoperable. The front camera module warning light was illuminated. The vehicle was taken to an independent mechanic where it was diagnosed and determined that the front camera module needed to be replaced. The dealer made the contact aware of NHTSA Campaign Number: 24V133000 (ELECTRICAL SYSTEM, FORWARD COLLISION AVOIDANCE); however, the VIN was not included in the recal. The vehicle was not repaired. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline to report the failure. The failure mileage was unknown.