2017 INFINITI Q50

The contact owns a 2017 Infiniti Q50. The contact stated that while driving at an undisclosed speed, the air bag warning light illuminated. The vehicle was taken to an independent mechanic, where it was diagnosed with air bags failure. The contact was informed that the air bag needed to be replaced. The vehicle was not repaired. The contact was informed of an unknown recall; however, the VIN was not associated with a recall related to the failure. The contact was advised to contact the NHTSA Hotline to report the failure. The contact stated that the vehicle failed to pass State Inspection due to the failure. The manufacturer was not made aware of the failure. The failure mileage was unknown.

NHTSA ID

11753934

Incident

Jul 31, 2026

Affected: Steering/Electrical/Direct Adaptive Steering, 50K miles While driving my 2017 Infinity Q50s under normal driving conditions, the vehicle suffered an instantaneous, catastrophic, and total failure of the power steering assist system without any prior warning or dashboard fault indicators. The sudden loss of steering assist immediately caused the steering wheel to become incredibly heavy and virtually locked, requiring extreme, dangerous physical exertion to maintain minimal control over the direction of the vehicle. Due to the violent and unpredictable change in steering dynamics at speed, I was forced out of my lane and ran over a curb and came moments away from experiencing a severe, life-threatening collision. The vehicle was rendered entirely undrivable and presents an immediate, catastrophic crash hazard. It had to be flatbed-towed to Infinity Valencia dealership. I am the original owner of this vehicle, and it has been meticulously maintained with exceptionally low mileage of 50,000 mile. Infinity previously issued mandatory federal safety recalls identical Direct Adaptive Steering (DAS) "steer-by-wire" software and module failures on the 2014-2016 model years (e.g., NHTSA Campaign number 16V433000). While the manufacturer asserted that the underlying engineering and software defects were fully resolved for the 2017 production year, this incident definitely proves that the catastrophic safety defect remains active, unmitigated, and present in the 2017 model year. Infinity Consumer Affairs and corporate databases currently lack proactive safety campaign for this specific VIN, leaving consumers entirely expose to a known, severe safety liability. I am filing this formal complaint to urge the National Highway Traffic Safety Administration (NHTSA) to open a formal defect investigation into the 2017 Infinity Q50/Q50s steering architecture and compel the manufacturer to expand the safety recall before this unmitigated defect results in fatal accident.

NHTSA ID

11744293

Incident

May 1, 2026

I have had several major problems with this car's engine. Once it shut down (was detecting no oil but was full) while on the interstate. Had to replace the radiator fan assembly and module. Coolant Leaks

NHTSA ID

11739745

Incident

Apr 29, 2022

The passenger seat occupant sensor is on. Dealer confirmed the code is related to a bad sensor so even if someone is sitting in the passenger seat and we are in an accident the airbag will not deploy. The dealer said a recall exists for earlier models but not for the 2017 even though they say it’s the same components. They want to charge me between $6,000 to $8,000 to repair which is almost as much as the car is worth. This unfortunately is cost prohibitive at this time so we are driving with the known risk. The light has been on for a couple of years now as we were hoping an additional recall would come out but it hasn’t which is why I am submitting this report.

NHTSA ID

11723190

Incident

Mar 9, 2026

The problem is on the recall, I understand my car is not on the VIN recall list but it's the same problem. Potential Recalls for 2017 Q50: Fuel Pump Control Module (2.0L engines): Improper software may cause the engine to stall.

NHTSA ID

11723136

Incident

Feb 9, 2026

I experienced an ongoing grinding/rattling noise from the wheel/brake area. The vehicle was serviced multiple times by a franchised dealer, which diagnosed the issue as brake-related and performed brake repairs. The noise was not resolved, and the vehicle was returned in the same condition. Shortly after service, an independent mechanic discovered a cracked/broken brake pad installed on the vehicle. Due to safety concerns, the manufacturer authorized inspection at a separate franchised dealership under different ownership. That inspection confirmed aftermarket brake pads, rotors, and related components of unknown origin installed on both the front and rear, missing OEM hardware, improper lubrication, and wheel bearing issues contributing to the noise. The inspecting dealer documented that the braking system must be returned to OEM specifications before safe operation and further diagnosis could continue. Despite this, the manufacturer has declined to require OEM remediation, and the vehicle continues to operate with unauthorized aftermarket brake components. The grinding noise has continued and has since shifted toward the rear. The condition is reproducible, documented by video, and confirmed by independent inspection. I believe the vehicle was returned to service in an unsafe condition involving a critical braking system.

NHTSA ID

11711898

Incident

Sep 6, 2025

I had a passenger seat belt light on and took it to Jim Coleman Infiniti in Bethesda,MD. They then were going to charge me a diagnostic fee to fix it, but instead proceeded to perform a zero point seat reset and got the error code B00A0 and then the passenger air bag light came on. They subsequently said that the vehicle was not covered under any recall or warranty and said that the seat needed to be replaced and informed me that it would be around $8000 at that time. Now it must be more. Looking at the recall campaign 16V244000 my vehicle does not qualify since it is one model year later, but I have seen others have the same issue that I have with the 2017 Q50. There is infact one in Florida that has a similar experience as mine. Talking to the dealer and Infiniti neither wanted to do a goodwill jesters and would only reduce the cost by a few thousand dollars. That still meant that I would need to put out more than $4000 to get a safety issue that should be covered. The symptoms and error codes are exactly the same. So I ask that you extend the recall campaign to the 2017 model year as well for the Q50. It is a safety hazard that will be present on the streets. The dealer also refuses to do the module reset saying that it will fail again. Pleas ask Infiniti to cover the cost of ensuring this critical safety for the passenger side is resolved for all model years that have the error code from the recall.

NHTSA ID

11700915

Incident

Sep 12, 2024

My vehicle has been stalling and burning/leaking oil internally for some time now with white smoke coming from the rear. Well Infiniti sent a post card and stated that the emission warranty is extended for 120,000 miles which my vehicle has had the issue for some time and it was already over 120k miles at the time of the loss. The issue Infiniti reported in their postcard is, you may experience issue with the turbocharger, Overtime there is a possibility for the turbocharger thrust bearing to wear and leak oil internally. The most likely conditions you will experience are excessive white smoke from the exhaust, MIL-On an in rare cases reduced engine power or damage to the internal components. My vehicle is experiencing all these issues reported and the company, Infiniti, knows this is an issue and did not issue a recall the extended warranty instead, most people will not qualify for which will require people to thousand of dollars replacing the turbocharger assembly and engine control model. I got a quote and was told 8000 dollars unfortunately I cannot have repairs done. I believe it was January 2025 when the post card came from Infiniti identifying the issue

NHTSA ID

11700285

Incident

May 31, 2023

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Infiniti by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

TELEMATICS SERVICE INFORMATION See ITB19-029 for models built after those listed above for a different Service Procedure. SERVICE INFORMATION The Applied Vehicles are equipped with a wireless communication device called a Telematics Communication Unit (TCU). With an active Infiniti Connection® or Infiniti InTouch Services™, the TCU communicates with the Infiniti Data Center to provide various security and convenience services. This bulletin contains important service procedures that must be performed properly in order to set-up and maintain the telematics system for the Applied Vehicles. Ø A table has been provided on the next page that lists the model and year specific steps required to successfully configure a TCU after it has been replaced. Ø A check OFF sheet has been provided on page 21 to print and check off steps as they are performed. Please staple the completed Check OFF Sheet to the repair order.

AEB WARNING LIGHT IS ON WITH WARNING MESSAGES DISPLAYED ON COMBINATION METER APPLIED VEHICLES: 2015-2024 Q50 (V37) 2015-2018 Q50 Hybrid (HV37) 2017-2022 Q60 (CV37) 2015-2019 Q70 (Y51) 2015-2018 Q70 Hybrid (HY51) 2019-2024 QX50 (J55) 2022-2024 QX55 (FJ55) 2015-2021 QX60 (L50) 2022-2024 QX60 (L51) 2015-2019 QX60 Hybrid (L50H) 2015-2024 QX80 (Z62) SERVICE INFORMATION The AEB system is designed to turn itself OFF during driving conditions (e.g., rain, snow, fog, etc.) that obstruct its sensors. This behavior is normal, and no repairs should be performed. When the AEB system performs an intentional shutdown, the customer may state the following:  The ICC stopped working while driving,  The AEB/FEB warning light is ON, or turned ON, while driving (Figure 1),  The message “Unavailable Front Radar Obstruction” or “Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner's Manual” has displayed while driving (Figure 2). AND  DTC C1A16, C1A16-97, C2582, or C2582-97 is the ONLY DTC stored. Figure 1 Figure 2 Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner’s Manual

MIL ON WITH DTC(S) STORED IN THE ECM This bulletin is no longer active. Please discard previous versions of ITB17-050.

***** Retailer Announcement ***** INFINITI is committed to providing the highest levels of product quality and customer satisfaction. Therefore, INFINITI is conducting a warranty extension to Full Useful Life (FUL) of 10 years or 120,000 miles, whichever occurs first, if white smoke or oil leak occurs with MIL-On condition that requires replacement of the turbocharger assembly on model year 2016-2018 Q50 and model year 2017-2018 Q60. All other warranty terms, limitations, and conditions remain unchanged. On some model year 2016-2018 INFINITI Q50 and 2017-2018 Q60 vehicles there is a possibility that the turbocharger bearing may leak engine oil internally due to premature wear. The internal turbocharger oil leak may cause one or more of the following: Excessive smoke from the exhaust, Service Engine Soon (MIL) light and in severe cases, lack of engine power or damage to the internal components of the turbocharger. During the limited emission warranty extension period, owners are eligible for free replacement of the Turbocharger if it is determined to be required by an INFINITI trained technician. Owners of eligible vehicles will receive notification of this limited emission warranty extension during February 2025. ***** What Retailers Should Do ***** 1. Verify if vehicles are eligible for this Warranty Extension using the warranty extension page of Service Comm. Then, proceed with the instructions in item (2) below. 2. If a client contacts the retailer with a Turbocharger concern in an owned or leased vehicle, retailers should use the Electronic Service Manual (ESM) and appropriate Technical Service Bulletins (TSB) to diagnose the root cause of the customer concern and identify the correct repair to resolve the customer concerns. NOTE: Retailers will need to follow the warranty process and obtain pre-approval when the repair cost exceeds a Retailer’s Claims Administration/Authorization Limits (DCAL). CONFIRM: With the vehicle at operating temperature excessive smoke from exhaust, the Service Engine Soon (MIL) light on (with DTC P0106) due to excessive oil in the intake system from a turbocharger, or other damage to the turbocharger due to unusual bearing P4A05/P4A06 | Original Document wear and oil leakage. Proceed to replace the affected turbocharger(s) and update the vehicle to the latest engine software.

TURBOCHARGER REPLACEMENT PROCEDURE APPLIED ENGINES: VR30DDTT IF YOU CONFIRM One or both turbochargers require replacement. ACTION 1. Replace the affected turbocharger(s).  Refer to the SERVICE PROCEDURE in this bulletin for the updated procedure. IMPORTANT: You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair. 2. Refer to step 212 in the SERVICE PROCEDURE to confirm if the ECM needs to be reprogrammed.  2016-2024 Q50 and 2017-2021 Q60 will require ECM reprogramming at the end of this SERVICE PROCEDURE. 3. If the ECM part number is in Table A (page 61 and 63), reprogram the ECM. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.