RoadVitals

2008 International 4200

Recalls, owner-reported complaints, investigations and safety data

Data refreshed

Owner complaintsComplaints are reports submitted to NHTSA by owners and drivers. NHTSA does not verify most reports before publishing them, and a complaint does not establish that a defect exists. Volume is influenced by how many of a vehicle were sold, how long it has been on the road, and how much attention an issue has received.
1
Latest May 29, 2014
Safety recallsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
3
Latest Jun 15, 2010
InvestigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
Crash or fire reportedComplaints whose submitter recorded that a crash or a fire occurred. These are the reporter's own answers on the NHTSA form, not verified findings.
0

Overview

Our database contains 1 NHTSA owner-reported complaint for the 2008 International 4200, most frequently naming the electrical and engine categories. 3 safety recalls have been issued covering this model year; and 95 manufacturer communications are on file.

Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.

What owners report

Complaints grouped by the component NHTSA recorded

  • Electrical150.0%
  • Engine150.0%

Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.

Safety recalls

3 campaigns cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
10V267000

VEHICLE SPEED CONTROL

Jun 15, 2010
2,085 units potentially affected
The defect: NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2003 THROUGH 2010 INTERNATIONAL TRUCKS AND IC COMMERCIAL BUSES MANUFACTURED FROM DECEMBER 4, 2001 THROUGH DECEMBER 14, 2009 EQUIPPED WITH INTERNATIONAL VT365 ENGINES HAVING ENGINE CALIBRATION PAN2PVR0, PAN2PVR1, OR PAN2PWR. THE ENGINE NORMALLY RESPONDS TO A FAILED OPEN ACCELERATOR POSITION SENSOR CIRCUIT FAULT BY RETURNING THE ENGINE TO LOW IDLE SPEED OF 800 RPM AND DISABLING THE DRIVER'S ABILITY TO INCREASE THE ENGINE SPEED. HOWEVER IF THE OPEN CIRCUIT CORRECTS ITSELF WITHIN 30 SECONDS OF INITIATION, ENGINE SPEED COULD SUDDENLY INCREASE TO A HIGH IDLE SPEED OF 1200 RPM.
The risk: THIS INCREASE TO HIGH IDLE SPEED MAY OCCUR WITHOUT WARNING CAUSING A SUDDEN AND UNEXPECTED SHIFT IN VEHICLE POSITION POSSIBLY RESULTING IN PROPERTY DAMAGE, PERSONAL INJURY, OR DEATH.
The remedy: NAVISTAR WILL NOTIFY OWNERS AND DEALERS WILL REPAIR THE VEHICLES FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JULY 1, 2010. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.
NAVISTAR, INCManufacturer number 10512View on NHTSA.gov
10V104000

SERVICE BRAKES, HYDRAULIC

Mar 16, 2010
87 units potentially affected
The defect: NAVISTAR HAS NOTIFIED NHTSA ABOUT A DEFECT IN CERTAIN MODEL YEAR 2010 AND 2011 IC CE, HC, AND BE COMMERCIAL BUSES AND INTERNATIONAL 1300, 3200, 3300, 4100, 4200, 4300, 4400, AND MXT TRUCKS MANUFACTURED FROM NOVEMBER 19, 2003 THROUGH FEBRUARY 9, 2010. THE PARKING BRAKE MAY RELEASE IF THE BRAKE SYSTEM ELECTRONIC CONTROL UNIT (ECU) SOFTWARE MISINTERPRETS INPUT SIGNALS GENERATED FROM CYCLING THE IGNITION SWITCH MORE THAN ONCE AT A SPECIFIC FREQUENCY.
The risk: RELEASE OF THE PARKING BRAKE MAY CAUSE SUDDEN, UNEXPECTED SHIFT IN VEHICLE POSITION POSSIBLY RESULTING IN PROPERTY DAMAGE, PERSONAL DAMAGE, OR DEATH.
The remedy: NAVISTAR WILL NOTIFY OWNERS AND WILL REPAIR THE VEHICLES BY REPROGRAMMING THE VEHICLE'S BRAKE SYSTEM ECU FREE OF CHARGE. THE SAFETY RECALL BEGAN ON APRIL 14, 2010. OWNERS MAY CONTACT NAVISTAR AT 1-260-461-1890.
NAVISTAR, INCManufacturer number 10505View on NHTSA.gov
07V179000

SUSPENSION:REAR:AXLE:NON-POWERED AXLE ASSEMBLY

Apr 24, 2007
1,172 units potentially affected
The defect: ON CERTAIN TRUCKS, ONE OR BOTH REAR AXLE HOUSINGS MAY CONTAIN THINNER MATERIAL THAN WHAT IS NECESSARY FOR NORMAL VEHICLE OPERATION. OVER TIME, THIS THINNER MATERIAL MAY RESULT IN A FATIGUE FAILURE OF THE REAR AXLE HOUSING, POSSIBLY IN THE LOCATION OF THE BRAKE FLANGE.
The risk: A CRACK IN THE BRAKE FLANGE LOCATION OF THE REAR AXLE HOUSING MAY RESULT IN A WHEEL END LOCKUP OR WHEEL SEPARATION POSSIBLY RESULTING IN PROPERTY DAMAGE, PERSONAL INJURY, OR DEATH.
The remedy: DEALERS WILL INSPECT THE VEHICLE'S REAR AXLES AND, IF NECESSARY, REPLACE THE AXLE HOUSINGS. THE RECALL BEGAN ON MAY 18, 2007. OWNERS MAY CONTACT INTERNATIONAL AT 1-800-448-7815.
INTERNATIONAL TRUCK & ENGINE CORPORATIONManufacturer number 07505View on NHTSA.gov

Recent owner complaints

Reports submitted to NHTSA, shown in the owner's own words

ElectricalEngine
Filed May 29, 2014

ENGINE START HARNESS HAS A 40 AMP FUSE INSTALLED IN A 30 AMP RATED FUSE HOLDER. HOLDER WILL OVER HEAT (MELT) WITHOUT BLOWING FUSE, CAUSING THE METAL CONTACTS TO CHAR / LOOSEN,CAUSING AN OPEN RUN CIRCUIT, WHICH CAUSES THE ENGINE TO STALL. THIS CAN HAPPEN AT ANY TIME, IDLE, RUNNING IN STOP AND GO TRAFFIC AND AT FREEWAY SPEEDS. WHEN THIS OCCURS YOU LOOSE ALL ENGINE BASED ASSIST, ELECTRICAL, POWER STEERING,LIGHTING. NAVSTAR (INTERNATIONAL) HAS ADDRESSED THIS ISSUE ON SCHOOL BUS CHASSIS, BUT SAYS THE PROBLEM DOESN'T EXIST ON APPROXIMATELY 250 CHASSIS SOLD TO GULF STREAM MOTORHOMES FOR FITTING OF THE COACH. THE DEALER FIX IS TO REPLACE THE FAILING FUSE HOLDER WITH THE SAME FAILING PART UNTIL WARRANTY EXPIRES,THEN THEY RECOMMEND THE REPLACEMENT WIRING HARNESS PROVIDED TO SCHOOL BUS OWNERS AT NO COST, FOR A COST OF APPROX. $600 PARTS AND LABOR.THIS FUSE ASSEMBLY HAS BEEN REPLACED BY INTERNATIONAL 2 TIMES AND I HAVE REPLACED IT TWICE MYSELF. I ALWAYS CARRY SPARES AS I HAVE EXPERIENCED A FAILURE LAST JULY IN SOUTHERN ARIZONA IN 107 DEGREE HEAT. *TR

NHTSA ID
10594727
Incident
Jul 13, 2009

Manufacturer communications

A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.

IK2600090

ENGINE

New CARB Idle Reduction Change Request

IK4300035

ELECTRICAL SYSTEM

This tool is designed to compare Diamond Logic feature data across multiple vehicle configuration files. It allows users to quickly load files either manually or directly from the Diamond Logic Builder Vehicles folder using VIN-based selection. As files are added or removed, the comparison runs automatically with no manual action required. The program presents results in an interactive table that shows feature codes, descriptions, access levels, and whether each feature is present in each selected file. Built-in search, filtering, and sorting make it easy to locate specific features or focus only on differences between files. Column visibility can be customized to show or hide descriptions and access information as needed. Users can remove files individually or clear all files at once, with results updating instantly. The tool also includes reporting and export options that reflect exactly what is visible on screen, allowing results to be printed, copied, saved as text, or exported to CSV for use in Excel or other spreadsheet tools. Overall, the program streamlines the process of comparing vehicle feature configurations, helping users quickly identify differences, validate setups, and document results without manual comparison or external tools.

IK2600047

ENGINE

Engine replacements for all International engines will need to follow this procedure.

IK1600272

STRUCTURE:BODY

This document will guide the user through a step-by-step procedure for detecting water leaks in vehicle cabs and windshields using an ultrasonic sound detector.

IK0600030

POWER TRAIN

This document will guide the user through understanding Prop Shaft Codes and understanding the variations of prop codes. (Metric Prop codes start with the number a 4 and Non metric Prop codes start with a 2.)

IK1201009

STRUCTURE:BODY

In some geographic areas, ambient temperatures reaching below 15°F (-10 °C), including high levels of humidity, an operator may experience engine stalling, low performance, and or poor aftertreatment performance. This is caused by condensation accumulating and freezing within the Charge Air Cooler (CAC); affecting air flow into the engine. This article lists all the currently available winter front covers that can be installed on the front grille and bumper to reduce cold air flow to the engine compartment.

Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Compare model years

Complaint and recall counts across every year of this model

International 4200 by model year
YearComplaintsRecallsInvestigationsIssue Index
2010010—
2009020—
2008Viewing130—
2007020—
2006030—
2005130—
2004020—
2003070—
2002071—
2001021—
2000011—
1999011—
1998011—
1997011—

Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.