2013 Lexus IS 250

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

TL* THE CONTACT'S MOTHER OWNS A 2013 LEXUS IS 250. WHILE THE DRIVER WAS ATTEMPTING TO PARK THE VEHICLE, THE GEAR SHIFT LEVER WAS PLACED IN PARK WITH THE BRAKE PEDAL DEPRESSED. SUDDENLY, THE VEHICLE ACCELERATED INDEPENDENTLY, DROVE OVER A CURB, STRUCK A TREE, AND STRUCK A PARKED VEHICLE. THE AIR BAGS FAILED TO DEPLOY. A POLICE REPORT WAS FILED. THE DRIVER WAS INJURED AND SOUGHT MEDICAL ATTENTION AT THE EMERGENCY ROOM. THE VEHICLE WAS TOWED TO A COLLISION CENTER. THE VEHICLE WAS NOT DIAGNOSED AND THE REPAIR WAS STILL PENDING. AN UNKNOWN DEALER WAS CONTACTED AND INFORMED OF THE FAILURE. THE MANUFACTURER WAS NOT NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 50,000. THE VIN WAS NOT AVAILABLE.

NHTSA ID

11287952

Incident

Nov 23, 2019

Mileage

50,000 mi

WHEN STEERING WHEEL IS TURNED TO THE RIGHT WHILE DRIVING. A METAL SCRAPING NOISE OCCURS. THIS HAS BEEN FIXED SEVERAL TIMES BUT KEEPS OCCURING MORE OFTEN. THIS ONLY HAPPENS WHEN CAR IS IN MOTION. AND I BELIEVE IT HAS SOMETHING TO DO WITH THE PLACEMENT OF THE BRAKE SHIELD. AS IF SOMETHING IS PRESSING ON IT.

NHTSA ID

11220934

Incident

Apr 1, 2019

Mileage

38,000 mi

THE ENGINE COULD STALL IN THE MIDDLE OF DRIVING BECAUSE OF MISFIRE. MY LEXUS 250 ONLY 40K MILEAGE AND ALWAYS DO PROPER MAINTENANCE TO THE ENGINE EVERY 3000 MILE. I DO RESEARCH THAT LEXUS IS 250 CAUSE CARBON BUILD UP BECAUSE OF THE WRONG DESIGN OF THE DIRECT INJECTION. HERE'S THE YOUTUBE LINK: HTTPS://WWW.YOUTUBE.COM/WATCH?V=YTQUQFLAWR8. I BROUGHT THE CAR TO LEXUS DEALER, THEY WON'T ADMITTED, INSTEAD THEY BLAME ME USING A WRONG FUEL. BEFORE I USED 91OCTANE SHELL, THEN I SWITCH TO 91OCTANE CHEVRON. STILL HAS THE PROBLEM. THEY SHOULD RECALL FOR THIS MATTER, BECAUSE IT'S ABOUT SAFETY AND THE ENGINE COULD SUDDENLY STALL IN THE MIDDLE OF DRIVING.

NHTSA ID

11114087

Incident

Jul 1, 2018

Mileage

40,000 mi

TL* TAKATA RECALL. THE CONTACT OWNS A 2013 LEXUS IS 250C. THE CONTACT RECEIVED NOTIFICATION OF NHTSA CAMPAIGN NUMBER: 18V024000 (AIR BAGS); HOWEVER, THE PARTS TO DO THE REPAIR WERE UNAVAILABLE. THE CONTACT STATED THAT THE MANUFACTURER EXCEEDED A REASONABLE AMOUNT OF TIME FOR THE RECALL REPAIR. THE CONTACT CALLED A LOCAL DEALER (LEXUS OF RIVERSIDE, 3150 ADAMS ST, RIVERSIDE, CA 92504) AND WAS INFORMED THAT THE REMEDY WAS ON BACKORDER FOR APPROXIMATELY TWO WEEKS. THE MANUFACTURER WAS NOT NOTIFIED OF THE ISSUE. THE CONTACT HAD NOT EXPERIENCED A FAILURE. PARTS DISTRIBUTION DISCONNECT.

NHTSA ID

11073068

Incident

Jan 9, 2018

THE PROBLEM THAT MANY IS250 LEXUS OWNERS ARE HAVING WITH THE FRONT TIRES WEARING OUT OR TEARING FROM THE INSIDE. I HAVE FOUND THAT THE ISSUE IS THE SUSPENSION WHERE THE FRONT TIRE AND A COTTER PIN MEET EVERY TIME YOU HIT A BUMP OR POT HOLE. THIS HAS CAUSED GREAT DAMAGE TO BOTH FRONT TIRES TO THE EXTENT WHERE YOU CAN SEE THE STEEL BELT. LEXUS HAS GONE AS FAR AS TO BLAME THE TIRE MANUFACTURE AND HAS NOT TAKEN RESPONSIBILITY FOR THE PROBLEM. I ASK THAT THIS ISSUE BE INVESTIGATED BEFORE A LIFE IS LOST DUE TO NEGLIGENCE.

NHTSA ID

10862390

Incident

Apr 30, 2016

Mileage

1 mi

TI: 19LE05 Expired December 1, 2022

DP: Limited Service Campaign KLG expired December 01, 2022

DP: Customer Support Program 19LE05 expired December 1, 2022.

TI: 19LE05 Expired December 1, 2022

CSP: Takata CSP Coverage Job Aid - published 7.28.2022

CSP: On July 30, 2018, a settlement of claims for Economic Loss related to Takata airbag inflators was approved for full implementation. The settlement includes Lexus?s agreement to provide a Customer Support Program (?CSP?) for 2002-2019 model year (MY) vehicles originally equipped with certain Takata airbag inflators or repaired under a recall with Takata airbag inflators to provide coverage for repairs of the airbag inflator contained in the airbag module. This CSP letter is to help clarify how to administer this coverage in accordance with the settlement. This is NOT a recall or a campaign, but is provided to reassure owners that Lexus stands behind the reliability of our vehicles