2022 Mazda CX-30

The rear wheel bearing failed at approximately 50k miles, causing grinding noise, humming, vibration, steering pull. It was replaced by Mazda under warranty in 2025. The wheel bearing failed again at approximately 59k miles. I have seen reports from other CX-30 owners describing the same recurring wheel bearing failure. This is a known issue that Mazda has not been resolving for the owners and there need to be a recall for this issue.

NHTSA ID

11751249

Incident

Nov 20, 2025

I don't know, is 4:20 in the morning. Oh, is it work? I was sitting in my car and all of a sudden pop and I had ringing in my ear. According to Mazda, connect, I got some weird network. Error the network failure error some kind of engine failure. Error I don't know what happened. But I've been having a lot of network issues. I've had a lot of battery issues with the car. It's been in the shop at carry. Monster a number of times they've never taken care of the issue. I don't know I don't know what to do. I won't even driven

NHTSA ID

11730646

Incident

Apr 10, 2026

My infotainment system is brikecked ! I cant turn off my lane assist and its like a battle to keep it in roads that dont have lines and especially when you get stuck in a groove of a road. Its scary! I got put into a grove my car being awd the rest followed and I get out of the grove and lane assist put me back in amd it almost put me all the way into the same gaurdrail I just avoided. My car is im this state due to unaddressed parasitic draw killing multiple batteries all deallt with by mazda service department.

NHTSA ID

11727246

Incident

Mar 11, 2026

1. The system that is failing is the rear tailgate. When it is opened or closed there is a clicking sound as if it is tryng to engage the lock multiple times. While driving this continues with the tailgate closed turning on and off the interior lights in the vehicle and showing on the front console that the tailgate is unlocked and open. the car is availabe for inspection on request. When I asked the dealer about it they stated that this is a known problem and it will cost approximately 800 dollars to fix which I believe is unresonable due to it being a known issue. 2. Since the rear tailgate may not lock properly it could potentially fly open while driving. 3. Yes see #1-Was reported to Kennedy Mazda located in Valparaiso Indiana. 4. Yes see #1 5. No warnings just the constant clicking of the lock mechanism can be heard.

NHTSA ID

11727183

Incident

Jun 30, 2025

The contact owns a 2022 Mazda CX-30. The contact stated that while driving and sneezing, going through a green traffic light, another vehicle crashed into the front driver-side door. There was one individual in the vehicle. The driver-side air bag failed to deploy. The driver mentioned the air bag should have deployed based on the impact. No warning lights illuminated or sounds occurred prior to the crash. The vehicle was traveling at approximately 35 MPH. There was no property damage. The contact sustained pain in the left leg, back, and shoulders. The contact received medical treatment and was provided with pain medication. The vehicle was towed to a salvage lot. The dealer was not notified. The manufacturer was not notified of the failure. The approximate vehicle mileage was 23,000.

NHTSA ID

11725284

Incident

Mar 15, 2026

Mileage

23,000 mi

The infotainment software is bricked. It happened when the battery died after purchasing it. The dealership told me to get a battery should be ok Now the infotainment system doesn't work and lane assist about put me into a guard rail the other day. I have no access to my cars functions and it is crazy scary

NHTSA ID

11724338

Incident

Jan 4, 2026

Rear wheel bearings failed at approximately 30,000 miles and were replaced by Mazda under warrantee. The same rear wheel bearings failed at approximately 72,000 miles and are available for inspection. Dealer has confirmed bad wheel bearings on both occasions. The potential for wheel bearing failure incudes loss of control of the vehicle while in motion. Dealer has bearing available for inspection. The only warning is increasing noise as the bearing wear.

NHTSA ID

11686928

Incident

Sep 2, 2025

At around 26,528 miles my 2022 CX-30 2.5s (not the turbo) developed a "Low Oil Pressure" warning while driving between 55-65mph on 07/06/2025. The car has had regular oil and filter changes about every 5K miles. The last oil and filter change was at 25,259 mileage on 05/25/2025. There aren't any visible oil leaks. I have read that this is a common problem for other Mazda CX-30 years 2021- 2022.

NHTSA ID

11671440

Incident

Jul 6, 2025

DESCRIPTION Some customers may complain that the electric power steering warning light illuminates after engine start and DTC U2011:1C is stored. Zinc-plated whisker may form inside the EPS motor and trigger the DTC. However, since it is cleared when power is supplied during DTC detection, normal operation can be restored by turning the ignition OFF and then ON. Furthermore, there is no possibility of recurrence. This case may be resolved through a simple inspection or repair without the need for parts replacement, potentially avoiding unnecessary customer waiting time.

This SA supersedes the previously issued SA(s) listed below. The changes are noted in Red. SA-063/24 09/06/24 DESCRIPTION The Blind Spot Monitoring (BSM) system can malfunction with the following symptoms if the rear side radar sensors are installed facing the wrong direction.

This bulletin supersedes the previously issued bulletin(s) listed below. The changes are noted in Red. 09-016/26 05/06/26 DESCRIPTION Some customers may complain that the seat warmer does not operate when turning the ignition on while the seat is warm but when turning the ignition off then on again, the seat warmer begins to operate appropriately. DTCs “B1030:13” and/or “B1032:13” are stored. This is caused by the seat warmers fail-safe mode which prevents it from working during the initial drive cycle. To correct this issue, the seat warmer has been modified to optimize the temperature control. B1030:13 Seat warmer unit (LH) circuit malfunction (Heater side) B1032:13 Seat warmer unit (RH) circuit malfunction (Heater side) Customers having this concern should have their vehicle repaired using the following repair procedure. REPAIR PROCEDURE 1. Verify the customer concern. 2. Remove the front seat cushion trim and the front seat back trim for both the driver and passenger seats according to the instructions in MGSS.

This Service Alert supersedes the previously issued SAs listed below. The changes are noted in Red text. SA-017/25 12/16/25, 09/08/25, 07/14/25, 05/15/25 and 03/21/25 DESCRIPTION Mazda Connect Frequently Asked Questions (FAQ) Index General Questions MAZDA CONNECT Indication Setup and Getting Started Dealer Processes Registration / Enrollment / Take-Over Customer Subscription Status WI-FI General Informatio Opening the TCU Communication Line WI-FI How-To Conditions for Remote Engine Start Will Not Function WI-FI Trial Period Conditions for Remote Engine Start Function Will turn engine OFF Interacting With The App TCU Communication Line Status Service Issues Educational Videos Troubleshooting Resources MyMazda App Error Codes Customer Opt-Out

This SA supersedes the previously issued SA(s) listed below. The changes are noted in Red. SA-061/25 12/17/25 DESCRIPTION If you encounter any type of electrical concern (e.g, dead battery, engine no start, DTC(s) stored...), interview the customer before proceeding with normal MGSS diagnosis by asking if any aftermarket devices have been installed. Aftermarket devices may be the cause of the electrical concern. Below are a few examples of unusual electrical concerns caused by aftermarket devices. Examples: 1. Devices connected to the DLC-2 (battery discharge/DTC stored) 2. Devices plugged into the 12V outlet 3. GPS tracking device (engine no start/battery discharge) 4. Dash cam (DTC stored) 5. Non-certified USB cable (Apple Carplay™/ Android Auto™ will not connect) 6. Over-sized wheels/tires (incorrect GPS location) 7. DTC C0023:14 8. Decorative trim and/or cover on the START/STOP ENGINE button Example 1: Some electrical devices connected to the DLC-2 connector by insurance or mobile phone companies may cause: Battery discharge. The device may disrupt the CAN system battery saver mode. • IDS/MMDS will not communicate with the vehicle due to poor DLC-2 connection. The aftermarket device may cause DLC-2 female terminals to spread open.

This SA supersedes the previously issued bulletin(s) listed below. The changes are noted below in Red. SA-027/26 04/16/26 DESCRIPTION The Mazda DCA-8000 is required for all warranty battery testing. If the Mazda DCA-8000 is not used, incorrect battery testing may result in unnecessary battery replacement. Use the following test procedures in this Service Bulletin to test Mazda vehicle batteries and to generate a Warranty Code. NOTE: A Warranty Code is required for warranty claim submission Battery Identification (Mazda batteries have 2 rating types) 1. JIS (Japanese Industrial Standard): JIS codes are six-digit alpha-numeric markings (excluding i-STOP batteries e.g. Q-85, S-95) molded into the top of the battery to identify a battery by the capacity (amps), dimensions, and battery terminal type. Vehicles manufactured in Japan come from the factory with a JIS rated battery. NOTE: Replacement batteries may use a CCA rating. If so, use the CCA rating listed on the battery. REPAIR PROCEDURE 1. Perform appropriate repair to vehicle. If needed, use the Battery Diagnostics of the DCA-8000 to test the charging and starting systems by following the on-screen instructions for entering the appropriate information. Refer to the Mazda DCA-8000 Instruction Manual for more information.