2002 Monaco Coach Knight

MONACO INFORMED ODI THAT IT HAS RECEIVED NO OWNER REPORTS OF MISSING LP GAS LINE SHILEDS OTHER THAN THE ONE FORWARDED BY ODI.ODI HAS FOUND NO OTHER VEHICLE THAT WAS MISSING THE LP LINE SHIELD. DURING THE COURSE OF THE INVESTIGATION ODI: ?CONDUCTED FIELD INSPECTIONS AT NUMEROUS DEALERS; ?REQUESTED WARRANTY CLAIMS AND FIELD REPORTS FROM MONACO(THERE WERE NONE);REVIEWED ENGINEERING DRAWINGS;AND?REVIEWED THE ANSI A119.2 AND THE NATIONAL FIRE PROTECTION ASSOCIATION 1192 STANDARDS ON RECREATION VEHICLES (RV?S) PERTAINING TO LP GAS LINE INSTALLATION ON RV?S. BASED ON MONACO?S DATA AND THE ABSENCE OF ANY FURTHER COMPLAINTS, A SAFTEY RELATED DEFECT TREND HAS NOT BEEN IDENTIFIED AT THIS TIME AND FUTHER USE OF AGENCY RESOURCES IS NOT CURRENTLY WARRANTED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFTEY-RELATED DEFECT EXISTS.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION ON THE VEHICLES IF WARRANTED BY THE CIRCUMSTANCES. ODI WILL CONTINUE TO MONITOR FIELD REPORTS AND TAKE APPROPRIATE ACTION IF INDICATED.

TL* THE CONTACT OWNS A 2002 MONACO COACH KNIGHT. WHILE DRIVING ON THE INTERSTATE AT AN UNKNOWN SPEED, THE MOTOR FAILED TO FUNCTION AND ALMOST CAUSED A CATASTROPHIC SITUATION WHEN THE VEHICLE CAME TO A COMPLETE STOP. THE VEHICLE WAS UNABLE TO BE RESTARTED. THE VEHICLE WAS TOWED TO AN INDEPENDENT MECHANIC TO INSPECT AND DIAGNOSE THE MOTOR FAILURE. IN ADDITION, A THIRD PARTY SOURCE INVESTIGATED THE FAILURE. THE VEHICLE WAS NOT DIAGNOSED BY A DEALER. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE TO DETERMINE IF THEY COULD PROVIDE A PERMANENT REPAIR. THE VEHICLE WAS NOT REPAIRED. THE FAILURE MILEAGE WAS NOT AVAILABLE.

NHTSA ID

11112559

Incident

Dec 1, 2016

TL* THE CONTACT OWNS A 2002 MONACO COACH KNIGHT. WHILE DRIVING VARIOUS SPEEDS, AN ABNORMAL BURNING ODOR EMITTED FROM THE VEHICLE. THE VEHICLE WAS PULLED OVER AND INSPECTED. THE CONTACT NOTICED THAT BOTH FRONT WHEELS WERE HOT TO THE TOUCH AND THE ABS CABLES WERE BURNT AND DETACHED. THE VEHICLE WAS DRIVEN TO A REST AREA WHERE AN INDEPENDENT MECHANIC DIAGNOSED THE VEHICLE. THE TECHNICIAN STATED THAT THE ABS CABLES, CALIPERS, AND ROTORS FAILED AND WOULD NEED TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE FAILURE WAS MENTIONED IN NHTSA CAMPAIGN NUMBER: 02V278000 (SERVICE BRAKES, HYDRAULIC). THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 80,000.

NHTSA ID

10927455

Incident

Aug 19, 2016

Mileage

80,000 mi

IN JUNE 2010, WHILE ON MY WAY TO CHURCH ANNUAL CONFERENCE, MY RIGHT REAR BRAKE OVERHEATED AND MELTED THE ABS SENSOR. I CALLED FOR ROADSIDE ASSISTANCE AND HE FOUND THE PROBLEM, GOT THE BRAKE RELEASED AND I FINISHED MY TRIP WITH NO PROBLEMS. THEN IN AUGUST 2010, WHILE ON MY WAY TO PAINTSVILLE KENTUCKY , MY LEFT FRONT BRAKE OVERHEATED. I WAS ABLE TO GET STOPPED BEFORE THE SENSOR MELTED AND PUT A FAN ON THE BRAKE AREA AND COOLED IT OFF. IT WAS THEN FREE AND I WAS ABLE TO CONTINUE ON MY TRIP WITH NO ADDITIONAL PROBLEMS. WHEN I CONTACTED WORKHORSE ABOUT THE PROBLEM THEY SAID MY UNIT WAS NOT IN THE RECALL FOR THE SAME PROBLEM. *TR

NHTSA ID

10382531

Incident

Jun 6, 2010

Mileage

21,750 mi

VEHICLE INVOLVED IS A 2002 MONACO KNIGHT MOTORHOME ORIGINALLY EQUIPPED WITH BOSCH ZOPS AIR OVER HYDRAULIC DISC BRAKES. ALL FOUR BRAKE CALIPERS WERE REPAIRED WITH BOSCH ZOH-T ANCHOR PLATE REPAIR KITS UNDER RECALL CAMPAIGN NO. 02V278000 IN 2004. IN JULY 2009 THE LEFT REAR BRAKE BECAME SEVERELY OVERHEATED CAUSING TRANSFER OF BRAKE PAD MATERIAL TO THE ROTOR AND CAUSING THE ABS SENSOR TO MELT AND FALL LOOSE FROM THE CALIPER. REPAIR WAS MADE BY REPLACING THE LEFT REAR CALIPER, REPLACING BOTH LEFT AND RIGHT BRAKE PADS, TURNING THE LEFT BRAKE ROTOR AND REPLACING THE ABS SENSOR. *TR

NHTSA ID

10290905

Incident

Jul 31, 2009

Mileage

81,300 mi

THERMAL BRAKE FAILURE ON US HWY 19 WEST OF BURNSVILLE, NC. ON 22 SEPT. 2008. THE RIGHT FRONT CALIPER OVERHEATED AND CAUSED A BURNED BRAKE SMELL, STRONG PULL OF THE STEERING WHEEL TO THE RIGHT, AND A RESULTANT ABS SENSOR FAILURE. THE PISTON FAILED TO RETRACT CAUSING THE BRAKE PADS TO DRAG ON THE ROTOR RESULTING A HEAT BUILD UP, SMOKE BILLOWED FROM THE WHEEL WELL AND THE ROTOR GLOWED RED. THIS IS MY FIRST FAILURE. HOWEVER, SEVERAL FELLOW OWNERS HAVE REPORTED SIMILAR BRAKE FAILURE. A 2004 RECALL REPLACED SOME BAKE PARTS. I DON'T FEEL COMFORTABLE THAT THIS TYPE OF FAILURE WILL NOT HAPPEN AGAIN! I AM SERIOUSLY CONSIDERING HAVING THE FOUR CALIPERS REPLACED AT AN ESTIMATED COST OF $1250. AFTER ATTENDING SEMINARS, SPEAKING WITH OTHER OWNERS, AND SEVERAL TECHNICIANS, I BELIEVE MONACO CONTINUES TO HAVE BRAKE PROBLEMS WITH MOTOR HOMES THAT HAVE BOSCH BRAKE CALIPERS INSTALLED. *TR

NHTSA ID

10248507

Incident

Sep 22, 2008

Mileage

60,400 mi

SEPARATION OF FIREWALL FROM FLOOR BOARDS. THIS IS A STRUCTURAL FAILURE AND ALLOWS EXHAUST GAS FROM GENERATOR TO ENTER INSIDE OF MOTORHOME. MECHANIC AT RECENT OIL CHANGE AND GENERATOR SERVICE NOTICED SCREWS MISSING FROM FIREWALL TO FLOOR BOARD CONNECTION. THERE IS A HORIZONTAL SEPARATION OF APPROXIMATELY 1/8 INCH AND A VERTICAL SEPARATION OF 3/16 INCH. ALL OF THE SCREWS, EXCEPT FOR ONE, WHERE MISSING OR SHEARED OFF. THERE IS NOW A GAP BETWEEN THE FLOOR BOARD TO FIREWALL MOUNTING. UPON STARTING THE GENERATOR TO VERIFY OPERATION AFTER OIL CHANGE AND SERVICING, DIESEL EXHAUST FUMES COULD BE SMELLED INSIDE THE MOTOR HOME. THE GENERATOR WAS RUN FOR APPROXIMATELY 5 MINUTES AND THE YOU COULD SMELL THE DIESEL EXHAUST FUMES IN THE FRONT HALF OF THE MOTOR HOME. I CONTACTED MONACO COACH CORP. TWICE, ONCE BY PHONE AND ONCE BY EMAIL TO THEIR TECH SUPPORT. THE CALL TO MONACO WAS ON 10 JULY 2008 AND I TALKED WITH BOB PIERSON (1-877-466-6226). HE STATED THAT THERE WAS NOTHING THAT MONACO WOULD DO AS THE COACH IS 6 YEARS OLD. HE STATED THAT I COULD SEND THE PICTURES TO HIM AND HE WOULD LOOK AT THEM AND FORWARD THEM UP THE LADDER. I RECEIVED NO RESPONSE. I THEN CONTACTED MONACO BY EMAIL, EXPLAINING THE PROBLEM AND ENCLOSED THE PICTURES. I GOT AN AUTOMATED ACKNOWLEDGEMENT TO THE EMAILS AND NOTHING ELSE. I HAVE TRIED TO REPLACE THE SCREWS, GOT 2 INSTALLED AFTER JACKING THE FIREWALL UP TO BE ABLE TO INSTALL REPLACEMENT SCREWS, BUT THE CENTER SECTION AND THE DRIVERS SIDE, I WAS NOT ABLE TO INSTALL SCREWS AND THE FIREWALL STILL REMAINS UNATTACHED. THERE STILL IS A GAP, HORIZONTALLY OF ABOUT 1/8 INCH AND VERTICALLY OF ABOUT 1/8 INCH FROM THE CENTER SECTION ALL THE WAY OVER TO THE DRIVERSIDE WALL, AS FAR AS I CAN SEE. THE COACH HAS APPROXIMATELY 44,000 MILES ON IT, 85 % HIGHWAY OR INTERSTATE, 15 % COUNTY OR CITY ROADS. ONLY GRAVEL ROAD TRAVEL HAS BEEN IN OUR DRIVEWAY AND RV PARKS. MONACO COACH NUMBER # 131966. *TR

NHTSA ID

10240805

Incident

Jul 10, 2008

Mileage

44,000 mi

2002 MONACO KNIGHT WITH BRAKE FAILURE. CONSUMER STATES THAT AFTER HAVING THE VEHICLE REPAIRED IN 2004. THE VEHICLE STARTED EXPERIENCING THE SYMPTOMS IDENTIFIED IN A RECALL FOR THAT VEHICLE. *KB THE CONSUMER WAS TOLD THE FAILURE OF THE BRAKES WAS CAUSED BY OVERUSE OF THE BRAKING SYSTEM. THE CONSUMER ALSO STATED THE ABS LIGHT ILLUMINATED BETWEEN THE TIME OF THE RECALL AND THE BRAKE FAILURE. THE CONSUMER BELIEVED THE MANUFACTURER WAS NEGLIGENT IN RECTIFYING THE PROBLEMS WITH HIS RV WHICH WAS RELATED TO THE RECALL. *JB

NHTSA ID

10221734

Incident

Sep 15, 2005

TL*THE CONTACT OWNS A 2002 MONACO KNIGHT 34PBD. THE CONTACT STATED THAT THE ABS LOCKS UP AND FORCES THE VEHICLE OFF THE ROAD. THE ABS ALSO OVERHEATS AND CAUSES HIM TO PULL OVER AND ALLOW THE COMPONENT TO COOL. THE VEHICLE WAS BRAND NEW WHEN THE FAILURE FIRST BEGAN AND HAS OCCURRED EVERY TIME THE MOTOR HOME WAS USED. THE CONTACT STATED THAT THE VEHICLE FAILS TO STOP PROPERLY DURING SUDDEN BRAKING. HE HAS TO SLAM ON THE BRAKE PEDAL FOR THE VEHICLE TO STOP. THE CONTACT ALSO STATED THAT THE VEHICLE HAS BEEN IN THE SHOP MORE THAN IT HAS BEEN USED. THE ENGINE SIZE WAS UNKNOWN. THE CURRENT AND FAILURE MILEAGES WERE 19,000.

NHTSA ID

10197468

Incident

Feb 10, 2003

Mileage

19,000 mi

JB RADIATOR INNER COOLER FAILURE ON ALUMINUM RADIATORS. *TT

TOUCH PAD SHIFTER. *SCC

IMFORMATION REGARDING FRONT JACK MOUNTING PLATE. NLM

MONACO HAS DECIDED THAT CERTAIN MOTORHOMES REQUIRE ADDITIONAL HARDWARE AT THE FRONT LEVELING JACK. THE ADDITIONAL INSTALLATION HARDWARE WILL ELIMINATE UNUSUAL MOVEMENT OF THE MOTORHOME WHILE LEVELED. *TT