NHTSA safety recalls, owner-reported complaints and investigations, by model and model year · 1989–2018
Our database holds no NHTSA owner-reported complaints for Morgan. Our database also holds 5 safety recall campaigns covering at least one Morgan model year.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Ordered by total owner-reported complaint volume, which is not a ranking of quality
| Model | Model years | Complaints | Recalls |
|---|---|---|---|
| 3W | 2012–2014 | 0 | 2 |
| Morgan | 1989 | 0 | 1 |
| Penske | 2010 | 0 | 1 |
| Truck Bodies | 2013–2018 | 0 | 1 |
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Complaint totals count a report once for each model year it names; recall totals count a campaign once per model.
The 5 newest campaigns covering a Morgan vehicle in our database
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govELECTRICAL SYSTEM:WIRING; EXTERIOR LIGHTING:TURN SIGNALMorgan Truck Bodies LLC (Morgan) is recalling all 2013-2018 Morgan Truck Bodies built on Isuzu, Kenworth, Mercedes, Chevrolet, GM, Freightliner, Mitsubishi and Peterbilt chassis. Water may enter part of the wiring harness and affect the turn signal operation.
SERVICE BRAKES, HYDRAULIC:BRAKE FLUID LOW WARNING: LAMPMorgan 3 Wheeler Limited (Morgan) is recalling certain model year 2012-2014 3W motorcycles. The affected motorcycles were manufactured without a lamp to that illuminates only when the brake fluid level is low. As such, these vehicles do not conform to Federal Motor Vehicle Safety Standard No. 122a, "Motorcycle Brake Systems."
EQUIPMENT:OTHER:LABELS; SERVICE BRAKES, HYDRAULIC:FLUIDMorgan 3 Wheeler Limited (Morgan) is recalling certain model year 2012-2013 three-wheeled motorcycles manufactured between October 2012 and July 2013. The brake fluid reservoir does not have a brake fluid reservoir filling warning statement. Thus, these vehicles fail to conform to the requirement of Federal Motor Vehicle Safety Standard (FMVSS) No. 122, "Motorcycle Brake Systems."
STRUCTURE:FRAME AND MEMBERSMORGAN IS RECALLING CERTAIN MODEL YEAR 2010 PENSKE VEHICLES. THE "Z" MOUNTING BRACKETS, WHICH SUPPORT THE VAN BODY ABOVE THE CHASSIS, ARE SUBJECT TO BENDING AND, IN EXTREME CASES, INDIVIDUALLY ARE SUBJECT TO BREAKING. IF MULTIPLE "Z" MOUNTING BRACKETS BREAK, THE PARCEL VAN BODY MAY LOWER ONTO THE CHASSIS FRAME RAIL. THE PARCEL VAN BODY TOUCHING THE FRAME RAIL MAY CAUSE INTERFERENCE BETWEEN THE WALK RAMP AND THE FUEL LINE, AND MAY PULL AWAY FROM THE CHASSIS CAB.
SEAT BELTS:FRONT:ANCHORAGESAFETY BELTS MAY NOT EXTEND EASILY FROM THEIR RETRACTORS WHEN VEHICLE IS PARKED ON SLIGHT SLOPE AS REQUIRED BY FMVSS 208. REAR STOP LIGHTS AND TURN SIGNALS DO NOT MEET MINIMUM PHOTOMETRIC STRENGTH, AND FRONT TURN INDICATOR - SIDE MARKER LIGHTS ARE BELOW HEIGHT REQUIRED BY FMVSS 108. WARNING LABEL (NEAR FILLER OF BRAKE FLUID RESERVOIR) TO CLEAN FILLER CAP BEFORE REMOVING MAY BE MISSING, WHICH VIOLATES REQUIREMENT OF FMVSS 105. INSIDE WINDSCREEN MOULDING MAY BE TOO HIGHLY REFLECTIVE AND NOT IN COMPLIANCE WITH FMVSS 107.
Every year with at least one publishable Morgan model year