ELECTRICAL SYSTEM:IGNITION:SWITCH
2014 Nissan Cube
Recalls, owner-reported complaints, investigations and safety data
Data refreshed
Overview
Our database contains 7 NHTSA owner-reported complaints for the 2014 Nissan Cube, most frequently naming the electrical, powertrain (other) and seat belts categories. 1 safety recall has been issued covering this model year; 1 NHTSA investigation names it; and 78 manufacturer communications are on file.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Complaint activity over time
When owners filed reports about this model year
View as table
| Month | Complaints filed | Cumulative |
|---|---|---|
| Mar 2015 | 1 | 1 |
| Jul 2015 | 1 | 2 |
| Jan 2019 | 1 | 3 |
| Mar 2019 | 2 | 5 |
| Sep 2019 | 1 | 6 |
| Jul 2022 | 1 | 7 |
What owners report
Complaints grouped by the component NHTSA recorded
- Electrical220.0%
- Powertrain (other)220.0%
- Seat belts220.0%
- Body & structure110.0%
- Exterior lighting110.0%
- Brakes110.0%
- Driver assistance110.0%
Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.
Safety recalls
1 campaign cover this model year
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govSafety investigations
NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect.
Desiccated Air Bag Inflator Rupture
From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.
Recent owner complaints
Reports submitted to NHTSA, shown in the owner's own words
ABS light came on, I checked on the internet to see what the problem might be and came up with a number of reasons, the last being have it checked ASAP. Took the car to my repair shop to have it checked. Found code C1116 stop lamp circuit was the problem, which I had fixed.When I picked up the car, I was told that getting the part wasn't difficult because it was a common problem. They also told me that my brake lights wouldn't work because of the circuit problem. In my opinion, this is a safety concern; if your brake lights aren't working how can anyone behind you know your intention to slow down or stop . What's more, how am I to know that my rear brake lights are not working? I'm in the cabin driving and unless I am alerted by another driver behind me, what am I to do?
- NHTSA ID
- 11473944
- Incident
- Jul 11, 2022
MY WIFE DROVE CAR TO THE STORE WHEN SHE GOT BACK IN THE CAR WOULD NOT START ,THE BRAKE PEDAL WOULD NOT DEPRESS AFTER20 MIN SHE TRIED AGAIN AND THE CAR STARTED . WHEN I GOT HOME I TRIED TO START THE CAR AND IT WOULD NOT START ,I WENT TO YOU TUBE AND FOUND A VIDEO WITH THE SAME PROBLEM AND THE VIDEO SAID TO GIGGLE THE WIRES UNDER THE DASH I DID THAT AND IT WOULD NOT START I TRIED 4 DAYS LATER AND IT STARTED THE VEHICLE WAS PARKED IN MY DRIVEWAY
- NHTSA ID
- 11254087
- Incident
- Aug 9, 2019
- Mileage
- 100,110 mi
AFTER COMING TO A STOP (OR NEAR STOP) FROM HIGHWAY SPEEDS, MY 2014 NISSAN CUBE DOES NOT RESPOND TO DEPRESSING THE ACCELERATOR. I WOULD PRESS THE GAS TO THE FLOOR AND IT BARELY MOVED. IT WAS EXTREMELY SLOW, LIKE THE ENGINE WOULD NOT GO ABOVE IDLE. AFTER 5-20 SECONDS IT WOULD FINALLY ACCELERATE. A COUPLE OF TIMES I WAS IN HEAVY TRAFFIC ON A LIMITED ACCESS RURAL HIGHWAY. THE LIGHT AHEAD HAD TURNED RED AND I DECELERATED TO AN ALMOST STOP BEFORE THE LIGHT CHANGED TO GREEN. OF COURSE, I IMMEDIATELY LET OFF THE BRAKE PEDAL AND PRESSED THE ACCELERATOR. THE CAR DIDN'T RESPOND AND THE TRAFFIC FROM BEHIND WAS CLOSING AT NEAR HIGHWAY SPEED. FORTUNATELY, I WAS ABLE TO SWERVE OFF OF THE ROAD ONTO THE SHOULDER AS THE OVERTAKING TRAFFIC BARRELLED PAST ME. ONE PARTICULARLY SCARY TIME I WAS IN THE LEFT LANE WITH GUARD RAIL ON THE LEFT AS WE WERE APPROACHING A BRIDGE; THE NO RESPONSE EVENT REPEATED ITSELF, BUT I WAS UNABLE TO EXIT THE ROADWAY TO THE LEFT. I KEPT THE PEDAL DOWN AND PRAYED NO ONE WOULD HIT ME. KARMA WAS WATCHING OVER ME AS THE CARS COMING FROM BEHIND REALIZED JUST IN TIME THAT I WAS BARELY MOVING AND SWERVED TO MISS ME. A COUPLE OF THE CARS NARROWLY MISSED HITTING ME; THERE WAS A LOT OF SQUEALING TIRES AND BLARING HORNS. LUCKILY FOR ME, I WAS WEARING DARK-COLORED UNDERWEAR'.. IT APPEARS TO HAPPEN MORE OFTEN AS THE CAR ACCUMULATES MILEAGE. I NEVER KNOW WHEN THIS WILL HAPPEN, SO NOW I TRY TO BE IN THE RIGHT LANE FOR UPCOMING STOPS, BUT SOMETIMES YOU ARE CAUGHT OFF GUARD FOR A TRAFFIC LIGHT CHANGE. THIS IS VERY SCARY. CAR SHOULD BE RECALLED.
- NHTSA ID
- 11191035
- Incident
- Mar 22, 2019
- Mileage
- 82,000 mi
SEATBELT ON THE REAR DRIVER SIDE WILL NOT AUTO-RETRACT AND HAS TO BE HAND FEED THEN TUGGED A BIT IN ORDER TO SECURE CAR SEAT. *TR
- NHTSA ID
- 11186657
- Incident
- Sep 1, 2018
- Mileage
- 60,000 mi
MY MOTHER WAS IN A ONE VEHICLE CRASH VS A TREE WHILE NEGOTIATING A CURVE. THE SEAT BELT TENSIONER DID NOT LOCK AND RESTRAIN MY MOTHER CAUSING HER TO SLIDE DOWN THE SHOULDER HARNESS CAUSING THE SEAT BELT TO CUT INTO HER CHEST CAVITY INTO HER LUNG. NISSAN WAS CONTACTED AND SENT AN ATTORNEY AND AN ENGINEER TO INVESTIGATE. *DT*JB
- NHTSA ID
- 11171471
- Incident
- Apr 18, 2017
THE ORIGIN AND CAUSE OF A VEHICLE FIRE INCIDENT THAT OCCURRED ON JANUARY 17, 2015, APPROXIMATELY TWO MILES EAST OF WIDENER JUNCTION ON HIGHWAY 70 NEAR MEMPHIS, TENNESSEE. IT STARTED BY A FIRE THAT OCCURRED WHILE DRIVING MY 2014 NISSAN CUBE WITH VEHICLE IDENTIFICATION NUMBER (VIN) [XXX]. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6). *TR UPDATED 9/15/15 *LN *CN
- NHTSA ID
- 10744848
- Incident
- Jan 17, 2015
- Mileage
- 1,500 mi
VEHICLE WOULD NOT ACCELERATE YET RPM'S WOULD RISE. *TR
- NHTSA ID
- 10693706
- Incident
- Mar 10, 2015
- Mileage
- 31,000 mi
Manufacturer communications
A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.
STRUCTURE:BODY
CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).
STRUCTURE:BODY
CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).
AIR BAGS
DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. IF YOU CONFIRM DTC B00A0-00 (OCCUPANT DETECTION SENSOR UNIT) is stored, AND OCS zero point reset cannot be performed, (continued on the next page)
ELECTRICAL SYSTEM
CAN COMMUNICATION CODES – DIAGNOSTIC TIPS AND GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ELECTRICAL SYSTEM
VEHICLE KEY NOT DETECTED / AUTHENTICATED, ENGINE WILL NOT START This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ELECTRICAL SYSTEM
CAN COMMUNICATION – NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Compare model years
Complaint and recall counts across every year of this model
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.