2007 Toyota Camry Solara

Twice: once in August and most importantly 09/07/2024 was slowing down to stop at a dry cleaners when the car reved up and accelerated forward. I continued to apply brakes all the way to the floor and couldn’t get it to stop, so ran into the businesses’s van. USAA paidfor repairs to both, but due to fears for my safety and life and those of others, I have not driven it since. I have had it towed for repairs and to be checked by an engineer sent by Toyota.and have had to rent or borrow or pay for rides up until now. The USAA sebt engineer came to check the car but decide the car was fine and Toyota would not offer help with replacement

NHTSA ID

11710124

Incident

Sep 7, 2024

The airbag warning light comes on at times constantly and occasionally intermittently. The connection under both front seats has been checked and found secured.

NHTSA ID

11700975

Incident

Jun 15, 2021

The contact's husband owns a 2007 Toyota Camry Solara. The contact stated that her daughter noticed cracks on the dashboard nearby the glove box above the passenger’s side air bag housing. No warning lights were illuminated. The vehicle was not diagnosed. The vehicle was not repaired. Neither the dealer nor the manufacturer was notified of the failure. The failure mileage was approximately 80,000.

NHTSA ID

11480557

Incident

Apr 1, 2022

Mileage

80,000 mi

The contact owns a 2007 Toyota Camry Solara. The contact noticed that the dashboard was melting. The contact mentioned that the reflection from the front windshield was causing a visibility issue. The vehicle was taken to the dealer where it was diagnosed that the dashboard needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 31,000.

NHTSA ID

11445917

Incident

Dec 1, 2021

Mileage

31,000 mi

I own a 2007 Toyota Camry Solara with less than 70,400 miles. It’s up to date on maintenance and is garaged. In December 2020, while garaged, my entire dashboard cracked without warning. After researching the condition, I learned that hundreds of Camrys and Solaras were affected and that Toyota replaced some dashboards under an extended warranty program… one such ZE6 program expired in August 2020. I was not notified. Despite the tremendous safety issue (the entirety of the car’s electronics sits beneath the dashboard including the airbags which, if deployed, can hurl dashboard pieces throughout the interior and blind and disfigure driver and passengers alike). Incredibly, neither Toyota nor NHTSA has issued a recall. Toyota Corp/dealership will do nothing at their expense. I Iive in fear that if my car is bumped or tapped, I’ll be maimed by flying dashboard debris; this puts my passengers and pedestrians at risk as well. Please help me get my dashboard replaced before something unthinkable happens. Thank you.

NHTSA ID

11423617

Incident

Dec 31, 2020

THIS PAST SUMMER (2020) THE DASH OF MY 2007 TOYOTA CAMRY GOT VERY STICKY AND MADE A REFLECTION ON MY WINDSHIELD MAKING VISIBILITY IMPAIRED WHICH IS A HUGE HAZARD. YOU CANNOT SEE THROUGH THE WINDSHIELD. I RESEARCHED IT TODAY AND FOUND OUT TOYOTA EXTENDED ITS WARRANTY FOR THIS PROBLEM, BUT IT EXPIRED IN 2017. MY PROBLEM DIDN'T START UNTIL 2020. I WANT THE NATIONAL TRAFFIC HIGHWAY SAFETY ADMINISTRATION TO INVESTIGATE THIS AND REQUIRE TOYOTA TO DO A RECALL FOR THIS PROBLEM.

NHTSA ID

11375664

Incident

Jun 1, 2020

WAS T-BONED ON MY DRIVER'S SIDE DOOR AT 40MPH AND NO AIRBAG DEPLOYED.. NOT EVEN THE SIDE CURTAIN AIRBAG AND THE WHOLE DRIVER'S SIDE WINDOW SHATTERED. WAS TURNING LEFT AT A LIGHT WHEN I WAS TBONED.

NHTSA ID

11315476

Incident

Feb 27, 2020

Mileage

122,000 mi

DASHBOARD IS MELTING, STICKY, SHINY, CREATES DANGEROUS GLARE.

NHTSA ID

11312017

Incident

Feb 28, 2020

Mileage

120,000 mi

Some 2005 – 2026 Toyota vehicles that have undergone water intrusion may exhibit a condition in which a musty odor is present. Follow the procedures in this bulletin to remediate the odor and address this condition. The purpose of this Service Bulletin is to provide general guidelines and procedures for odor remediation. This Service Bulletin provides a guide on how to prepare and treat the interior of the vehicle for odor remediation. Refer to the applicable model and model year Repair Manual and the EPA (Environmental Protection Agency) website for the most up-to-date safety and precautionary guidelines.

To prevent brake rotor rust from forming during transportation and storage, wheel film will be used instead of a cardboard type of anti-rust cover. The purpose of the wheel film is to shield the disc brake rotor from weather elements and initial rust before the vehicle is delivered to the customer. Consequently, the film should remain on the wheel for as long as possible.

Acid rain results from rainwater or other airborne moisture that become acidic due to industrial chemical impurities in the atmosphere. If these acidic compounds settle on an exposed vehicle, especially the horizontal areas such as the hood, roof, and decklid, significant damage to the painted surfaces can occur. Acid rain damage can typically be identified on vehicles by the presence of stains on the paint surface that resemble hard water spots. Unlike water spots however, acid rain damage cannot be removed by regular washing procedures. Also, because acid rain can etch and soften the paint, normal buffing or polishing repair procedures should not be attempted. This can cause further damage and result in visible depressions in the paint surface. The following are the three major categories of acid rain damage: •Minor damage: requires only buffing to repair. •Moderate damage: usually requires neutralizing, color sanding, and buffing. •Severe damage: extending beyond 1/2 mil of clearcoat on a pearl, metallic, or solid color, requires neutralization, sanding, and repainting. In cases where acid rain damage is minor, neutralization and buffing with a liquid-type paint finessing product may provide an adequate repair. Only specially formulated products outlined in this bulletin should be used for that purpose. Unfortunately, other than minor damage, there is no simple method of determining the actual extent (depth) of acid penetration other than color sanding a representative affected area until there is no visible etching or depressions, followed by measuring the amount of paint removed with either a magnetic or digital-type film thickness gauge. The procedures in this bulletin are intended for use by qualified body/paint technicians and should not be attempted by inexperienced personnel. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. Perform frequent vehicle washing, as often as daily, during high heat and humidity periods to minimize the potential for paint damage due to acid rain exposure. This is especially important in geographical areas known for high frequency and concentration of acid rain and industrial fallout.

The condition known as acid rain is caused by airborne chemicals or particles in the atmosphere, which mix with rainwater, nighttime dew, or high humidity to form acidic compounds. If these contaminants settle and remain on a painted vehicle surface, especially the horizonal areas of the hood, roof, and decklid, significant damage can occur. This damage is the result of actual etching of the paint and appears as pitting or water spots. As acid rain droplets on the vehicle surface evaporate, the concentration strength of the acid increases, causing deeper and more rapid damage. This evaporation and corrosive action also occur more rapidly on dark colored cars as direct sun heat increases. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. In areas known for high frequency and/or concentration of acid rain, frequent vehicle washing during high heat or humidity periods will minimize the potential for paint damage caused by acid rain. It is further recommended that either reverse osmosis or deionized water be used to prevent water spotting.

Toyota vehicles are currently protected with RapgardTM protective film designed to protect the horizontal painted surfaces. This material protects from acid rain, environmental fallout, and rail contamination. Follow the Removal Procedure in this bulletin to remove the RapgardTM protective film within 90 days from initial application.

Some 2005 – 2024 Toyota vehicles that have undergone water intrusion may exhibit a condition in which a musty odor is present. Follow the procedures in this bulletin to remediate the odor and address this condition. The purpose of this Service Bulletin is to provide general guidelines and procedures for odor remediation. This Service Bulletin provides a guide on how to prepare and treat the interior of the vehicle for odor remediation. Refer to the applicable model and model year Repair Manual and the EPA (Environmental Protection Agency) website for the most up-to-date safety and precautionary guidelines. This Service Bulletin is to provide a general overview and direction for the odor remediation process.