2001 Toyota Echo

While entering interstate accelerator was depressed all the way and became stuck on a couple of occasions. I had to use my foot to release it and it popped out. Dealership recommended it was floor mat. I purchased aftermarket ridged floor mats that will not curl up and it is still an issue.

NHTSA ID

11506400

Incident

Feb 6, 2023

TL* THE CONTACT OWNS A 2001 TOYOTA ECHO EQUIPPED WITH PRIME WELL TIRES, TIRE LINE: PS830, TIRE SIZE: UNKNOWN: DOT: 7TB03MH13318. THE CONTACT WAS DRIVING ON THE HIGHWAY AND HER FRONT LEFT DRIVER'S SIDE TIRE BLEW. SHE PULLED OVER AND NOTICED THE DAMAGE WAS ON THE BOTTOM SIDE. THE DAMAGE WAS A LONG TEAR AND HOLE IN THE TREAD. THE VEHICLE WAS TOWED TO AN INDEPENDENT TIRE SHOP. THE CONTACT DID NOT REMEMBER WHAT THE TIRE SHOP DIAGNOSED AS THE CAUSE OF THE BLOW OUT. THE FAILURE MILEAGE ON THE TIRES WAS UNKNOWN. THE FAILURE MILEAGE ON THE VEHICLE WAS 215,000.

NHTSA ID

11365911

Incident

Oct 16, 2020

Mileage

215,000 mi

TL* THE CONTACT OWNS A 2001 TOYOTA ECHO. WHILE DRIVING VARIOUS SPEEDS, THE AIR BAG AND CHECK ENGINE INDICATORS ILLUMINATED. THE CONTACT ALSO STATED THAT THE GEAR SHIFT INDICATOR DID NOT ILLUMINATE WHEN CHANGING GEARS. THE VEHICLE WAS TAKEN TO A REPAIR SHOP WHERE THE COMPUTER WAS RESET, BUT THE FAILURE RECURRED. THE VEHICLE WAS NOT REPAIRED. THE DEALER AND MANUFACTURER WERE NOT MADE AWARE OF THE FAILURE. THE FAILURE MILEAGE WAS 155,000.

NHTSA ID

11155661

Incident

Jan 1, 2015

Mileage

155,000 mi

CRANKSHAFT POSITION SENSOR! I BOUGHT THE VEHICLE FROM A GENTLEMAN WHO HASN'T DRIVEN THE CAR FOR AWHILE AFTER IT DIED ON HIM AND HE WAS UNABLE TO START IT UP AGAIN. I HOOKED IT UP TO AN OBD READER AND IT GIVE S ME THE CODE FOR THE CRANKSHAFT POSITION SENSOR. I CHECKED FUEL PUMP SPARK PLUGS TO MAKE SURE AND THOSE ARE GOOD WORKING ORDER.

NHTSA ID

10920010

Incident

Jul 1, 2015

Mileage

150,000 mi

TL* THE CONTACT OWNS A 2001 TOYOTA ECHO. THE CONTACT STATED THAT WHILE DRIVING AT 20 MPH, THE VEHICLE ACCELERATED WITHOUT WARNING. THE VEHICLE CRASHED INTO A HOUSE GARAGE DOOR AND THE AIR BAGS FAILED TO DEPLOY. THE CONTACT SUSTAINED A WAIST INJURY AND THE FRONT PASSENGER SUSTAINED CHEST AND ARM INJURIES WHICH REQUIRED MEDICAL ATTENTION. A POLICE REPORT WAS FILED. THE VEHICLE WAS DESTROYED. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE FAILURE MILEAGE WAS NOT AVAILABLE.

NHTSA ID

10748086

Incident

Aug 3, 2015

TL* THE CONTACT OWNS A 2001 TOYOTA ECHO. THE CONTACT STATED THAT THE AIR BAG WARNING INDICATOR WAS ILLUMINATED AND THE HORN BECAME INOPERABLE. THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE MANUFACTURER WAS NOT NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 93,000. MA 10/8 UPDATED 3/22/16 *JS *CN

NHTSA ID

10746407

Incident

Aug 4, 2015

Mileage

93,000 mi

EVER SINCE I BOUGHT THIS CAR BRAND NEW I HAVE HAD A PROBLEM WITH THE SPEAKER WIRE SHORTING AND GETTING HOT. I ONCE HAD TO CALL THE FIRE DEPT BECAUSE THE SPEAKER WAS SO HOT TO THE TOUCH. I AM STILL HAVING THAT PROBLEM AND JUST CUT THE WIRE AGAIN DUE TO SPARKING. I TOOK THE CAR TO FREEMAN TOYOTA IN SANTA ROSA, CA WHERE I GOT IT AND THEY REWIRED THE SPEAKERS. THAT DID NOT FIX THE PROBLEM, AND I DO NOT KNOW WHAT TO DO NEXT. *TR

NHTSA ID

10593267

Incident

Apr 1, 2003

Mileage

10,000 mi

TL* THE CONTACT OWNS A 2001 TOYOTA ECHO. THE CONTACT STATED THAT WHEN DRIVING AT VARIOUS SPEEDS ABOVE 5 MPH AND OPERATING THE HEADLIGHTS, THE VEHICLE WOULD STALL WITHOUT WARNING. THE VEHICLE WAS ABLE TO BE RESTARTED AFTER A JUMP AND WAS NOT INSPECTED BY A DEALER NOR REPAIRED. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE FAILURE MILEAGE WAS APPROXIMATELY 225,000. THE VIN WAS UNAVAILABLE.

NHTSA ID

10439785

Incident

Nov 29, 2011

Mileage

225,000 mi

Acid rain results from rainwater or other airborne moisture that become acidic due to industrial chemical impurities in the atmosphere. If these acidic compounds settle on an exposed vehicle, especially the horizontal areas such as the hood, roof, and decklid, significant damage to the painted surfaces can occur. Acid rain damage can typically be identified on vehicles by the presence of stains on the paint surface that resemble hard water spots. Unlike water spots however, acid rain damage cannot be removed by regular washing procedures. Also, because acid rain can etch and soften the paint, normal buffing or polishing repair procedures should not be attempted. This can cause further damage and result in visible depressions in the paint surface. The following are the three major categories of acid rain damage: •Minor damage: requires only buffing to repair. •Moderate damage: usually requires neutralizing, color sanding, and buffing. •Severe damage: extending beyond 1/2 mil of clearcoat on a pearl, metallic, or solid color, requires neutralization, sanding, and repainting. In cases where acid rain damage is minor, neutralization and buffing with a liquid-type paint finessing product may provide an adequate repair. Only specially formulated products outlined in this bulletin should be used for that purpose. Unfortunately, other than minor damage, there is no simple method of determining the actual extent (depth) of acid penetration other than color sanding a representative affected area until there is no visible etching or depressions, followed by measuring the amount of paint removed with either a magnetic or digital-type film thickness gauge. The procedures in this bulletin are intended for use by qualified body/paint technicians and should not be attempted by inexperienced personnel. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. Perform frequent vehicle washing, as often as daily, during high heat and humidity periods to minimize the potential for paint damage due to acid rain exposure. This is especially important in geographical areas known for high frequency and concentration of acid rain and industrial fallout.

The condition known as acid rain is caused by airborne chemicals or particles in the atmosphere, which mix with rainwater, nighttime dew, or high humidity to form acidic compounds. If these contaminants settle and remain on a painted vehicle surface, especially the horizonal areas of the hood, roof, and decklid, significant damage can occur. This damage is the result of actual etching of the paint and appears as pitting or water spots. As acid rain droplets on the vehicle surface evaporate, the concentration strength of the acid increases, causing deeper and more rapid damage. This evaporation and corrosive action also occur more rapidly on dark colored cars as direct sun heat increases. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. In areas known for high frequency and/or concentration of acid rain, frequent vehicle washing during high heat or humidity periods will minimize the potential for paint damage caused by acid rain. It is further recommended that either reverse osmosis or deionized water be used to prevent water spotting.

To prevent brake rotor rust from forming during transportation and storage, wheel film will be used instead of a cardboard type of anti-rust cover. The purpose of the wheel film is to shield the disc brake rotor from weather elements and initial rust before the vehicle is delivered to the customer. Consequently, the film should remain on the wheel for as long as possible.

Toyota vehicles are currently protected with RapgardTM protective film designed to protect the horizontal painted surfaces. This material protects from acid rain, environmental fallout, and rail contamination. Follow the Removal Procedure in this bulletin to remove the RapgardTM protective film within 90 days from initial application.

The condition known as acid rain is caused by airborne chemicals or particles in the atmosphere, which mix with rainwater, nighttime dew, or high humidity to form acidic compounds. If these contaminants settle and remain on a painted vehicle surface, especially the horizonal areas of the hood, roof, and decklid, significant damage can occur. This damage is the result of actual etching of the paint and appears as pitting or water spots. As acid rain droplets on the vehicle surface evaporate, the concentration strength of the acid increases, causing deeper and more rapid damage. This evaporation and corrosive action also occur more rapidly on dark colored cars as direct sun heat increases. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. In areas known for high frequency and/or concentration of acid rain (see Figure 1), frequent vehicle washing during high heat or humidity periods will minimize the potential for paint damage caused by acid rain. It is further recommended that either reverse osmosis or deionized water be used to prevent water spotting.

Acid rain results from rainwater or other airborne moisture that become acidic due to industrial chemical impurities in the atmosphere. If these acidic compounds settle on an exposed vehicle, especially the horizontal areas such as the hood, roof, and decklid, significant damage to the painted surfaces can occur. Acid rain damage can typically be identified on vehicles by the presence of stains on the paint surface that resemble hard water spots. Unlike water spots however, acid rain damage cannot be removed by regular washing procedures. Also, because acid rain can etch and soften the paint, normal buffing or polishing repair procedures should not be attempted. This can cause further damage and result in visible depressions in the paint surface. The following are the three major categories of acid rain damage: •Minor damage: requires only buffing to repair. •Moderate damage: usually requires neutralizing, color sanding, and buffing. •Severe damage: extending beyond 1/2 mil of clearcoat on a pearl, metallic, or solid color, requires neutralization, sanding, and repainting. In cases where acid rain damage is minor, neutralization and buffing with a liquid-type paint finessing product may provide an adequate repair. Only specially formulated products outlined in this bulletin should be used for that purpose. Unfortunately, other than minor damage, there is no simple method of determining the actual extent (depth) of acid penetration other than color sanding a representative affected area until there is no visible etching or depressions, followed by measuring the amount of paint removed with either a magnetic or digital-type film thickness gauge. The procedures in this bulletin are intended for use by qualified body/paint technicians and should not be attempted by inexperienced personnel. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. Perform frequent vehicle washing, as often as daily, during high heat and humidity periods to minimize the potential for paint damage due to acid rain exposure. This is especially important in geographical areas known for high frequency and concentration of acid rain and industrial fallout.