2007 Dodge Caliber

In their Defect Information Report (DIR) of June 3, 2010, Chrysler Group, LLC (Chrysler) notified NHTSA that it will conduct a safety recall of approximately 25,265 model year 2007 Dodge Caliber vehicles and 71 model year 2007 Jeep Compass vehicles manufactured from March 7, 2006 through May 19, 2006.The recall will remedy a defect in the accelerator pedal assembly (accelerator pedal) of the Electronic Throttle Control (ETC) system that can cause the accelerator pedal to stick in an open position and not return to the idle position when released.As stated in the opening resume, the subject vehicles (Caliber) are equipped with an ETC accelerator pedal manufactured by the CTS Corporation, the same supplier of the ETC accelerator pedal used in the recently recalled Toyota vehicles.The ETC accelerator pedal used in Caliber and Compass vehicles is not the same as those used in the recalled Toyota vehicles.They are of a different design, were manufactured using different tooling, and fail in a different manner.According to Chrysler and CTS, oversized bearing pockets in the ETC accelerator pedal housing of the Caliber and Compass vehicles allows the accelerator pedal pivot shaft bearings to dislodge from the housing.If this occurs, the accelerator pedal can stick in an open position (i.e., fails to return to the closed position) or be slow to return.Chrysler's DIR notes that the subject vehicles are equipped with Smart Brake Technology and contends that the impact of a binding or sticking accelerator pedal can be negated by its Smart Brake system.In Chrysler's view, the system enables the brake pedal input to override the throttle control system and safely depower the vehicle and minimizes the potential for safety consequences resulting from the defect in the accelerator pedal.Further, Chrysler states, as a result of the presence of this technology, Chrysler Group LLC has concluded that the condition described in this report does not present an unreasonable risk to motor vehicle safety.ODI does not concur with Chrysler's position that the Smart Brake technology employed in the subject vehicles eliminates unreasonable risks to safety stemming from the ETC accelerator pedal defect.Aside from the fact that the technology is applicable only to situations where the brake pedal is activated, the Smart Brake system implemented in the subject vehicles will override a stuck throttle under a discrete set of conditions.Because driver behaviors (e.g., kicking at the accelerator pedal to dislodge it, or pumping the brake pedal instead of steady application) may delay or prevent activation of the Smart Brake system in the subject vehicles, ODI believes that this Smart Brake system does not totally eliminate unreasonable risks to safety posed by this defect or the necessity of a safety recall in this case.See Safety Recall file 10V-234 for recall details.

Vehicle tipm shut off transmission while driving an cause a traffic jam on a busy intersection caused the transmission system to go in limp mode an no breaks. Was very dangerous lucky I had a hand break that worked cause engine to shut off an studder had to get towed an transported the vehicle home an got it inspected by a mobile mechanic an says the fuse box had blown internal components due to failing internal electrical components or weak points in the tipm system

NHTSA ID

11736456

Incident

Apr 25, 2026

The contact owns a 2007 Dodge Caliber. The contact stated that the ECU had been hacked. While driving on the highway at 70 MPH, the brakes applied without application, but I was able to move to the right lane. The vehicle was able to pull over safely, and it stalled. While parking with the foot on the brakes, the vehicle suddenly accelerated and crashed into a small pole. There was no reported fire, airbag deployment, police report filed, or injuries. While in neutral, the vehicle suddenly accelerated. The driver was able to shift to neutral. The vehicle was making an abnormal growling sound. There was no light inside. While using the headlights, the windshield wipers turned on for five minutes. After locking the vehicle, the headlights remain on. While using the turn signal, the windshield wipers engaged without application. While driving in the rain, the vehicle hydroplaned. The contact stated that someone stole the key fob, made copies, hacked into the vehicle, and was controlling the vehicle. The vehicle was taken to an independent mechanic for diagnostic testing, which confirmed the vehicle was working as designed. The local dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was not contacted. The approximate failure mileage was approximately 154,000. The VIN was not available.

NHTSA ID

11713355

Incident

Apr 1, 2025

Mileage

154,000 mi

I was informed on 09/29/2025 by my Chrysler dealer that a second critical component of my 2007 Caliber frame had rusted to the point that it broke. The first critical component was reported in my complaint tracking number 11459461 submitted on 04/03/2022. The component in that filing was the engine pan that supported the engine. On this latest failure, I was told the same thing by the shop manager: "If you hit a bump while driving this vehicle you could lose your back wheels". In the first incident, the engine could have fallen out of my vehicle. He was not going to let me drive it home. Then he changed his mind and told me it was "at my discretion". I did drive it home (4.5 miles) with no problem. He told me he was going to try and find a new or used part to fix the issue. He made it clear that he was not hopeful of finding one. This is twice now that my life and the lives of any drivers on the road at the same time were placed in danger from excessive rusting problems. I submitted files in the first incident showing that Chrysler was aware of the issue. A copy of the corporate service bulletin was attached. To my knowledge nothing was ever done. Is anything going to be done this time?

NHTSA ID

11691736

Incident

Sep 29, 2025

I was at a gas station and attempted to leave the lot and the cradle and/or attached parts broke into, rendering the car undrivable.

NHTSA ID

11687762

Incident

Sep 8, 2025

The contact owned a 2007 Dodge Caliber. The contact stated while driving at an undisclosed speed, the contact's vehicle was involved in a head-on collision, which was no fault of the contact. The contact's vehicle was damaged to the front of the vehicle and on the passenger's front side of the vehicle. The contact stated that the other driver's vehicle crashed into the contact's vehicle at a high rate of speed. The air bags did not deploy. The vehicle was towed to a local tow yard. The paramedics and the local Police arrived at the scene. A Police report was filed, however, the report number was unavailable. The vehicle was deemed a total loss. The contact was the only occupant in the vehicle. The contact was transported to the local medical center, however, due to the severity of the injuries and the specific treatments that the contact required, the contact was transferred to a medical center that specialized in the contact's required treatments. The contact-sustained injuries included but were not limited to traumatic brain injury, seizures, impaired speech, physical and mental disabilities, intermittent paralysis, damage to the spinal cord, and amnesia. The manufacturer was not made aware of the failure. The failure mileage was unknown.

NHTSA ID

11624039

Incident

Jan 7, 2020

My car is at 69739 miles and the control arms and the front and rear subframe is rotted out

NHTSA ID

11619600

Incident

Oct 14, 2024

This is a follow up to complaint #11459461 filed on 4/3/22 at 9:16:43am. I was not able to send documents at that time. Documents included relate to follow up on complaint #11591104. First pdf file: pages 1-4 Service bulletin from Chrysler - my model year not included; pages 5-7 service invoice and picture of missing engine cradle pan; page 8 original repair invoice; page 9 copy of original repair invoice with notations for Magna plant manager; page 10 notice of having received complaint; page 11 Defective lug nut issue; page 12 Complaint #11591104; page 13 Service invoice noting replacement of two defective lug nuts. Second pdf file: pages 1-2 Copy of original complaint #11459461; page 3 Copy of towing receipt due to defective lug nut. Third pdf file: Picture of three of four defective lug nut covers that I had to remove due to flat tires. First one not shown due to being damaged while attempting to remove beyond recognition. Upper left lug nut cover came off just in handling of removed lug nuts.

NHTSA ID

11619474

Incident

Oct 21, 2021

The contact owns a 2007 Dodge Caliber. The contact stated that while it was raining, there was water entering through the sunroof and doors into the vehicle. The air bag warning light was illuminated. The contact called the local dealer, who stated that there were no related recalls for the failures. The vehicle was not diagnosed or repaired. The manufacturer was contacted and stated that there was no recall coverage for the failures and the contact was referred to the NHTSA Hotline to report the failures. The failure mileage was approximately 70,000.

NHTSA ID

11595439

Incident

Jan 1, 2022

Mileage

70,000 mi

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Transmission Kit with Torque Converter 1. All Promaster (VF) 3.6L/62TE equipped vehicles. If the transmission bracket to the transmission case fasteners are removed during servicing, the fasteners (Part Number 06511385A$) are one-time usage. Vehicles built prior to 10/23/2015 requires Service Kit PN 68461214AA; includes Transmission Isolator PN 68264483AA, and Adaptation Bracket 68264479AA and Fastener Service Kit PN 68329056AA Vehicles built after on or after 10/23/2015 will require only the Fastener Service Kit PN 68329056AA. 2. All 3.6L/62TE equipped vehicles. If the vehicle you are repairing has a crack in the flex plate or failed pump bushing inspect and confirm that both (2) dowel pins are present in the engine block, which align the transmission center line to the crank shaft centerline and visually inspect the dowel alignment holes in the transmission case. If the holes are damaged or elongated the transmission should be replaced to prevent further damage to the transmission/flexplate or pump bushing due to the inability to properly align the engine to the transmission during the repair. 3. All 62TE equipped vehicles. If pump bushing is scored or damaged and the dowel pin alignment holes are ok, replace the pump assembly as opposed to complete transmission. 4. All 62TE equipped vehicles. If vehicle is jerking/slipping with MIL code(s) P0740 or P2764, check TCC Solenoid operation. If TCC Solenoid is ok, the codes are indicative of a torque converter failure. Replace the torque converter.

THROTTLE BODY For clarification, only use 68414676A$ on 2010 & earlier vehicles as supply is limited.

THROTTLE BODY For clarification, only use 68414676A$ on 2010 & earlier vehicles as supply is limited.

Disinfectant Solution Recommended for COVID-19