Reports submitted to NHTSA by owners and drivers, shown in full
Data refreshed
Our database holds 1,131 NHTSA owner-reported complaints for the 2012 Ford Edge. Each one is a report filed by an owner or driver and published by NHTSA without most of them being verified. A complaint is not a confirmed defect, not a recall and not a manufacturer bulletin. Narratives are shown exactly as filed.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Showing 1–25 of 1,131 · page 1 of 46
Engine keeps throwing sensors and transmission has hard shifting and slips ford is against changing fluid because i have put mileage on it. Loses power at stop of red lights
The brakes are hard to mash and spongey and it has a hissing kind of sound I believe it is a brake booster. When I bought the vehicle used from a dealership they told me it didn't have any recalls on the vehicle but later own I found out it did have a recall for the abs system so i called the ford company and they told me that the recall has already ended and they wouldn't fix it and now when I look it up online it showed the brake boosted had a recall to that the dealership never told me about but now I believe the recall has already ended on that to but not sure. But if the dealership told me the truth instead of lying to me I could have got to fix so I am wondering if there is away I could get those to recalls done on my 2012 ford edge. I noticed the abs messing up just a couple months after I bought it which was I believe in 2021 or 2022 and the brake booster started messing up around july 15, 2026
The rear camera only works sporadically. It will work once in awhile or will work and then not work at all for awhile. So far Ford has not addressed this make and model as having a problem. One of our teenagers is the primary driver and this is unsafe.
RE:Safety Complaint - Defective FCIM Causing Hazard Flashers to Activate Randomly May 22, 2026 To Whom It May Concern, I am writing to formally complain about a serious electrical defect affecting my 2012 Ford Edge involving the Front Controls Interface Module (FCIM). The vehicle’s hazard flashers activate randomly and repeatedly without warning, even when the vehicle is completely off and parked or operating normally. This issue appears to originate from a failed or malfunctioning FCIM module, despite the vehicle not being abused, modified, or involved in any event that would reasonably cause this failure. This defect creates multiple safety concerns, including: - Unexpected flashing while driving - Battery drain while parked - Driver distraction - Potential confusion for surrounding traffic - Loss of confidence in the vehicle’s electrical system After researching this issue, I discovered that many other Ford Edge owners have reported nearly identical FCIM-related failures, suggesting this may be a widespread defect rather than normal wear and tear. I am extremely disappointed that owners are being forced to pay significant repair costs for what appears to be a recurring design or manufacturing problem. Electronic control modules should not fail under ordinary use conditions in a manner that compromises vehicle safety functions. I respectfully request that Ford: - Investigate this recurring FCIM failure issue, - Offer goodwill repair assistance or reimbursement, - Consider issuing a technical service campaign or recall if appropriate, - And acknowledge the safety risks associated with malfunctioning hazard systems. I have been a Ford owner in good faith and hope the company will stand behind its product and assist customers financially experiencing this defect. Please contact me regarding the next steps toward resolving this issue. Thank You. Sincerely, [XXX] [XXX] [XXX] VIN [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
As I was driving into a parking lot space, I stepped on the brake pedal, and it sank to the floor. I rapidly pumped the pedal 2 or 3 times, but it continued to sink to the floor. As the car continued moving forward, I tried to avoid colliding with landscape items, drove between 2 parked cars, scraping one or both of them, and injured a pedestrian. My vehicle stopped when I jammed the gear control into the “PARK” position.
Loss of rearview image from backup camera. Intermittent blank, distorted, or inverted image when in reverse. Sometimes says "loss of signal". This reduces the driver’s view of the area behind the vehicle, increasing the risk of a backover crash. My 2012 Ford Edge is experiencing the same issues mentioned in 25V572 for the 2015-2018 Ford Edge.
I have replaced my front brakes at least 3 times, something is wrong with the brakes on these cars. Started off fine then after 50,000 miles I've changed them almost once a year. Never have had a Ford that I've had to replace brakes so much. Love the car just the little things are hard to handle. Take my car in again this year for front brakes again. Really??? I have just over 90,000 on the car and every 15,000 to do brakes again is unbelievable.
The contact's father owns a 2012 Ford Edge. The contact stated that while shifted into reverse(R), the rearview image was frozen, or the screen was blank. The contact stated that the failure was intermittent. The vehicle had been taken to an independent mechanic and was advised that the vehicle needed to be taken to a dealer. The vehicle was taken to a local dealer where it was diagnosed, and it was determined that the rearview camera system needed to be replaced. The vehicle was not yet repaired. The contact researched online and associated the failure with NHTSA Campaign Number: 25V572000 (Back Over Prevention); however, the VIN was not included. The manufacturer was informed of the failure. The failure mileage was approximately 120,000.
Rear view or back up camera monitor and animation not connecting or staying connected to load back up camera image
My car skids when I try to stop the car(car breaking). This happening a couple of times during the past 2 or 3 days. My car mechanic just did a diagnostic and found out that the ABS Sensor module and electrohydraulic has system failure and needs replacement, but parts aren't available where I live (Puerto Rico). This is surely a matter of security I will appreciate if you can help us to find the parts need to fix this issue.
2012 Ford Edge brake failure occurred without any warning while I was driving on I85. Brake pedal went to floor with diminished braking ability when a vehicle adjacent changed lanes quickly to in front of my vehicle. Luckily no accident occurred. Vehicle was taken to Ford dealer. A previous issue with brakes happened in 2021/mileage 109k and brake booster was replaced under recall 13N02 at that time. Dealer diagnosed current brake issue and recommended replacing HCU AND MASTER CYLINDER DUE TO VALVES AND SEAL LEAKING INTERNALLY. RELACE OIL SENDING UNIT ALSO DUE TO IT LEAKING OIL. Mileage 146K Vehicle is unsafe to drive as is. Cost of repairs is close to value of car.
Shift to park message, not showing it is in park. Can only crank the car if you turn the key halfway and then shift to neutral to crank it. Once you put it back in park and set the emergency brake you can only crank it by repeating the process of Neutral cranking. Car will roll away without brake set. Driving is a concern as I am afraid it might pop into another gear. My year 2012 is not in the recall that effects 2015-2018 models but it's the exact same issue.
My airbags randomly deployed while I was driving.
Ford Edge 2012 Limited 2.0L [XXX] The brake pedal went all the way to the floor while my wife was driving a few times. The brakes DID NOT STOP OR SLOW THE CAR AT ALL! She pumped the brake pedal and braking came back. But, after that we could not trust the brake system. We paid AutoNation Ford in Fort Worth, Texas $2,694.45 on 10/11/2023 to replace the ABS system, after their recommendation that this will fix the problem. This did fix the problem until recently this past week on 9/21/2025, when the brake pedal went to the floor without any braking, just continued to move forward in our driveway. The next push on the brake pedal did provide braking but now seems a little soft. My wife’s sister also has a Ford Edge with similar or the same symptoms, a 2013 Edge. My daughter has a 2012 Ford Fusion with similar or the same symptoms. This is a very dangerous SAFETY PROBLEM with these Ford cars! I suspect that this problem is more widespread than just my family, more Ford Edge vehicles with this ABS problem. A Ford Edge ABS RECALL might be required to help Ford customers be safe! INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The contact owns a 2012 Ford Edge. The contact stated that while attempting to start the vehicle, the contact became aware that the rearview camera displayed a blank screen or an upside-down image. An independent mechanic was contacted. The vehicle was not taken to a dealer or an independent mechanic to be diagnosed. The vehicle was not repaired. The contact related the failure to NHTSA Campaign Number: 25V270000 (BACK OVER PREVENTION); however, the VIN, the make, or model was not included in the recall. The manufacturer was not notified of the failure. The failure mileage was approximately 123,000.
The first incident occurred in GA on vacation in June. While my spouse was driving, he said the brakes seemed squishy and were not right. When he braked to stop the car to get gas, his foot went almost to the floor. After getting gas, I drove and they did not seem right. The second incident happened the beginning of August and I was coming down a relatively steep hill. I went to brake and my foot went all the way to the floor and did not completely stop. I took the car to my mechanic and he wasn't sure of the problem, and to another mechanic. The 2nd thought it was the brake booster. I then took it to the Ford dealership where I bought it last August and had them look at it. They said it is the ABS module and that I am #829 on the list of 1300 people that need that part, that Ford has no idea when it will be available. The third incident was last Sat, [XXX] and I had No Brakes At All, so I had to take my husband's car to work. In All the incidents, I was at risk, as well as my family and the people driving in front & back of me. I have also had issues of the AC coming in for NO Reason, and after I turn it down, it turns itself back on at full blast. This car is NOT SAFE. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The backup camera is faulty. Sometimes you will start the car and it works but most of the time it is just a black screen. I can go out and make several stops and sometimes it will flash on and then go right off. I know there have been several recalls about this but this model so far hasn't been included. It is a widespread problem as I have another Ford vehicle that does the same thing and it is a safety issue.
The ABS system is completely shot. I have replaced the entire brake system besides the ABS. There is a recall on the ABS System for other 2012 Ford Edges, but for some reason my vehicle isn’t included. Please consider including my car in the recall as this is a serious safety issue. I cannot even drive the car, because i am not able to brake properly.
The contact owns a 2012 Ford Edge. The contact stated that while driving on several occasions at various speeds, or while the vehicle was parked, the contact observed an abnormal gasoline odor in the vehicle. Additionally, while driving at an undisclosed speed, the vehicle lost motive power while attempting to accelerate, with the check engine warning light illuminated. Additionally, a "Turbo Boost" message was displayed. The vehicle was taken to an independent mechanic who discovered a fuel leak. The contact was informed that either the fuel tank or fuel lines needed to be replaced. The manufacturer was not notified of the failure. The failure mileage was 98,260.
Constant gas smell . Was told there is a fuel tank leak. Also check engine light came on and the codes that came up is for supercharger/ turbo boost.
Regarding the three Ford vehicles in my possession, each with approximately 80,000 miles, I've observed consistent issues with the Anti-lock Braking System (ABS) module. Despite my inquiry with a Ford dealership, no recall has been issued for these vehicles, and the ABS module is reportedly unavailable for repair. Given the apparent prevalence of this issue, I am concerned about the potential impact on vehicle performance during critical events. Furthermore, I am seeking clarification from Ford representatives regarding the lack of a resolution for this recurring problem across multiple vehicles. Sincerely, [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
BRAKE PEDAL HITTING THE FLOOR : ISSUE COMES AND GOES VERY RARELY . FIRST COMPLAIN REPORTED ON APRIL 2014: BRAKE BOOSTER REPLACED ON WARRANTY. LAST COMPLAIN REPORTED TO ORIGINAL CAR DEALER: COULD NOT IDENTIFY THE ISSUE. IN BETWEEN THESE TWO DATES, BRAKE BOOSTER HAS BEEN REPLACED RECENTLY. ABS HYDRAULIC CONTROL UNIT MAY CAUSE THE BRAKE FAILURE, NO ABS LIGHT YET. FORD HONORED AN EXTENDED WARRANTY ON BRAKE POWER BOOSTER IN 2020. PERFORMING A FEW REPEATED SUDDEN STOPS AT CERTAIN SPEED GETS THE BRAKES TO HOW IT SHOULD BE. NO ACCIDENT EVER INVOLVED.
See attached document for complaint.
On July 31, 2019, I had the brake booster replaced at Midas due to a hissing noise and a loss of brake pressure, costing me $733.39. At that time, I checked for a Ford recall but found none for my VIN. I recently came across Ford Customer Satisfaction Program 13N02: Certain 2010-2014 Model Year Edge and MKX Vehicles Extended Warranty Coverage on Brake Booster. While I never was contacted by Ford about this issue for my 2012 Ford Edge, I feel it should be part of the program as it was clearly a safety issue at the time. Ford Customer Satisfaction Program 13N02 does show as an outstanding field service action for my VIN.
The contact owns a 2012 Ford Edge. The contact stated that while the vehicle was parked, the contact stated that the rearview camera became inoperable. The contact stated that the rearview camera image appeared upside down. The vehicle was taken to the dealer, where it was diagnosed and determined that the rearview camera had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 166,000. The VIN was not available.
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Categories with enough reports to have a page of their own
Data on this page last refreshed .