2017 Hyundai Elantra GT

Brake line corroded AFTER recall with treatment was done. Loss of brakes while driving on highway. Avoided collision but could've been highly fatal accident. Hyundai should've replaced a serious safety issue instead of covering it with a coating and hoping it holds. It is a XXX Car driven in [XXX]. I don't know if XXX reports matter but I think it should. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11770901

Incident

Oct 12, 2026

2017 Hyundai Elantra GT suffered leakage from the hydraulic brake lines located under the driver's seat which can cause sudden and total braking failure. The leakage was caused by severe rust and corrosion trapped by the underbody panels. The fuel line was also severely corroded, with imminent failure. While Transport Canada issued an official safety recall for this exact engineering defect on the same generation of Elantra GT under Transport Canada (Campaign 2023125), Hyundai Motor America has failed to extend this protection to U.S. consumers, leaving vehicles on U.S. roads with active, life-threatening brake and fuel line failures.

NHTSA ID

11756080

Incident

Jul 22, 2026

The Engine stalled completely at highway speeds. It was then towed to the dealership and was diagnosed with engine rod bearing failure. Hyundai is denying the warranty extension for this engine failure based on an incomplete 'Service Campaign 966' that does not appear on the NHTSA public recall database, leaving consumers unnotified of safety-critical software updates."

NHTSA ID

11755675

Incident

Apr 26, 2026

I bought a vehicle used and it malfunctions in six days. It is a safety hazard to me the driver and other drivers on the roads. The vehicle is weighing heavy on the passenger side the car is not parallel. Also the vehicle stalls while driving. The pedal stops giving power to the car. I attempted to fix the car and the problems still persist. The mechanics said the car need shocks, struts, and wheel alignment.

NHTSA ID

11751348

Incident

May 21, 2026

My vehicle was brought to an authorized Hyundai dealership In November 2025 to complete safety recall campaign KSDS (Campaign 966). Soon after picking up the vehicle after the dealer flashed the ECU, the vehicle went into a permanent, dangerous "limp mode" that severely limits the engine's RPMs, making it impossible to accelerate to highway speeds. The vehicle's computer displays zero OBD-II diagnostic trouble codes (no P1326 or standard fault codes). The dealership is refusing to address this issue, falsely claiming a plugged catalytic converter, despite the vehicle having passed a strict California Smog Check with perfect emissions and zero catalyst codes, just a few weeks before the update was performed, and ran perfectly normal. This recall software update has rendered my vehicle extremely unsafe to drive on public roads, and the manufacturer's authorized repair facility is refusing to remedy the electronic damage caused by the recall installation. I am trapped driving a disabled vehicle in a permanent, dangerous software loop.

NHTSA ID

11742601

Incident

Nov 10, 2025

I am writing to formally log a critical safety and product reliability complaint regarding my Hyundai Elantra GT. The vehicle has suffered catastrophic engine failure characterized by severe rod knock. This failure occurred without any prior warning from the vehicle’s onboard diagnostic systems, exposing an engineering and sensor flaw that creates an immediate safety hazard.The vehicle was operating normally when it suddenly developed a distinct, heavy metallic knocking sound from the engine block, indicative of failed connecting rod bearings. Upon immediate inspection, the issue was linked to critical oil starvation or pressure drops.Crucially, the vehicle’s warning systems failed entirely to alert me to an issue:No Low Oil Pressure Warning: The dashboard oil pressure light never illuminated to warn of low pressure or critical oil level depletion.No Check Engine Light (CEL): The engine sensors failed to detect underlying mechanical distress, oil degradation, or early-stage misfires before the catastrophic failure occurred.Complete System Silence: The vehicle gave absolutely no visual or audible alerts on the instrument cluster, depriving me of the chance to pull over safely and shut off the engine to prevent total destruction.This sensor failure is an unacceptable safety risk. Total engine seizure at highway speeds can cause a sudden loss of motive power, power steering, and braking assist, endangering my life and the lives of others on the road. The failure of Hyundai’s diagnostic sensors to communicate active oil or mechanical breakdown directly directly caused this total engine loss.I request that Hyundai review this case immediately, investigate the failure of the warning systems, and provide financial remediation for the required engine replacement.I look forward to your prompt response regarding the next steps for a corporate review.

NHTSA ID

11737885

Incident

Feb 12, 2026

After a Hyundai dealership installed the Knock Sensor Detection System (KSDS) update to prevent engine bearing failure and potential fires in certain Theta II, Nu, and Gamma engines, my Elantra GT is stuck in limp mode and will no longer accelerate. Since it takes my car a very long time to reach safe driving speeds, I took the car back to the dealership and they conveniently blamed the catalytic converter. I went for a ride with a California BAR associate, and he agreed that the update was causing my engine to go into limp mode, and it wasn't a symptom of a plugged CAT, but he was unable or unwilling to help me. Hyundai acknowledged that the engine does qualify for the Theta II extended warranty but will not explore that possibility until I have them replace the cat for $3,300, which we both know isn't going to solve anything. I have contacted Hyundai Corporate Customer Relations, and even the BBB, who refuses to qualify my car for their Engine Replacement class action lawsuit because the engine hasn't seized up yet, which will never happen since the update is preventing it. Even lemon law lawyers refuse to assist me because the car is too old. Since this is the only car I have, I am a nervous reck whenever I have to use it. If I press the accelerator pedal just a bit too much, the engine cuts out.

NHTSA ID

11729107

Incident

Apr 3, 2026

Was driving the car on a two lane road and engine shut off. Had to coast to side of road. Had car towed to deal and they say it is a bottom end knock and engine has to be replaced. It has 54,000 miles and has been serviced regularly by Hyundai dealers. Dealer can not specify what is wrong with engine other than bottom end knock and won’t drop the pan or do an oil analysis to find out more details.

NHTSA ID

11658501

Incident

Apr 22, 2025

Some vehicles equipped with internal combustion engines may exhibit higher-than-expected engine oil consumption. This bulletin outlines the combustion chamber cleaning procedure for vehicles diagnosed with this condition. All internal combustion engines consume some engine oil during normal operation, depending on driving conditions and mileage, and this procedure should only be performed when deemed necessary based on inspection and diagnosis of the vehicle as outlined in TSB 26-EM-015H, Engine Oil Consumption – Inspection & Repair Guidelines, or the latest revision.

Certain vehicles equipped with internal combustion engines may exhibit higher-than-expected engine oil consumption. This bulletin provides the inspection and repair procedures for vehicles exhibiting this condition. All internal combustion engines consume engine oil as part of normal engine operation. Oil consumption rates may vary based on mileage, operating conditions, driving habits, and maintenance history. Hyundai recommends following the prescribed maintenance schedule and periodically checking the engine oil level using the dipstick to maintain proper engine oil level.

The National Highway Traffic Safety Administration (NHTSA) has identified the presence of substandard and dangerous driver’s-side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN). These inflators were not supplied, approved, or authorized by the vehicle manufacturers and have primarily been found in vehicles that previously experienced a crash and underwent airbag replacement using non-genuine parts. These dangerous inflators have ruptured during deployment, posing a serious risk of injury or death due to metal fragments entering the vehicle cabin. To date, Hyundai is aware of three people who have died while driving a Hyundai vehicle with one of these substandard replacement airbag inflators that deployed in what likely would have been a survivable crash. NHTSA has issued a public advisory urging vehicle owners and service professionals to have vehicles inspected if there is reason to believe that a non-genuine replacement airbag may have been installed. Vehicles with salvage or rebuilt titles, prior airbag deployments, or unknown repair histories may present a higher risk. NHTSA strongly cautions against self-inspection by vehicle owners and recommends inspection by trained technicians.

The National Highway Traffic Safety Administration (NHTSA) has issued an urgent safety advisory regarding dangerous, counterfeit driver‑side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN), that have been identified in U.S. vehicles following prior crashes, theft, or non‑certified airbag replacements. These inflators are not approved for use, may rupture during deployment, and have caused serious injuries and fatalities. Please see attached announcement, provided by NHTSA, for more details.

This TSB references the Op codes to use for claim submission and the Parts required based on the vehicle’s inspection results from TSB 22-01-023H-2 (DTC P1326 – Engine Bearing Inspection/Engine Replacement) or the latest version.

This TSB references the Op codes to use for claim submission and the Parts required based on the vehicle’s inspection results from TSB 22-01-023H (DTC P1326 – Engine Bearing Inspection/Engine Replacement) or the latest version.