2016 INFINITI Q70

TL* THE CONTACT OWNS A 2016 INFINITI Q70. WHILE DRIVING IN A SNOW STORM, THE WINDSHIELD WIPERS SEIZED IN THE DOWN POSITION. THE CONTACT WAS ABLE TO PULL THE VEHICLE OFF THE HIGHWAY. THE DEALER (HERB CHAMBERS INFINITI OF WESTBOROUGH, 312 TURNPIKE RD, WESTBOROUGH, MA 01581, (508) 983-1000) STATED THAT THE WIPERS HAD A HEAT SENSOR THAT WAS DESIGNED TO TURN OFF IF THE HEAT ON THE WIPER ENGINE WAS TOO HIGH. THE MANUFACTURER WAS UNABLE TO DUPLICATE THE FAILURE. THE FAILURE MILEAGE WAS 23,000.

NHTSA ID

11160921

Incident

Nov 12, 2018

Mileage

23,000 mi

TL* THE CONTACT OWNS A 2016 INFINITI Q70. THE CONTACT STATED THAT THE AIR BAG WARNING INDICATOR ILLUMINATED. THE VEHICLE WAS TAKEN TO GEORGE HARTE INFINITI (1076 S COLONY RD, WALLINGFORD, CT 06492 (203) 495-6700). THE CAUSE OF THE FAILURE COULD NOT BE DETERMINED; HOWEVER, THE AIR BAG WARNING INDICATOR WAS RESET. THE CONTACT STATED THAT THE REPAIR DID NOT RECTIFY THE FAILURE. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE FAILURE MILEAGE WAS UNKNOWN.

NHTSA ID

11042856

Incident

Nov 29, 2016

BOTH MY WIFE AND I FEEL THAT THE HEATED STEERING WHEEL GETS TOO HOT TO COMFORTABLY HOLD CONTINUOUSLY. THIS ENCOURAGES THE DRIVER TO TURN OFF THE STEERING WHEEL HEATER WHILE DRIVING. UNFORTUNATELY, THE SWITCH IS LOCATED IN THE LOWEST BANK AT THE DRIVERS LEFT KNEE WHERE IT IS VERY DIFFICULT TO SEE. IT IS ALSO IN CLOSE PROXIMITY TO THE SWITCHES TO TURN OFF THE VEHICLE DYNAMIC CONTROL, BACK-UP COLLISION INTERVENTION AND WARNING SYSTEMS. ALL OF THE ABOVE COMBINED RESULT IN THE DRIVER HAVING TO DIRECT THEIR ATTENTION AWAY FROM THE ROAD AND TO THE LOWER CONTROL PANEL AND, IN ADDITION, MAKES IT LIKELY THAT THEY WILL INADVERTENTLY TURN OFF A VEHICLE SAFETY SYSTEM. THE SERVICE MANUAL PROVIDES A RANGE OF 68F - 86F. THE DEALER MEASURED MINE AT 120F. SINCE THIS CLOSELY MATCHED ANOTHER Q70 ON THE LOT IT WAS DEEMED "NORMAL". I SUBMIT THAT IT IS NOT AND BELIEVE THAT IT NEEDS TO BE ATTENDED TO BEFORE IT RESULTS IN AN ACCIDENT. *TR

NHTSA ID

10943915

Incident

Dec 20, 2016

Mileage

6,300 mi

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Infiniti by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

TELEMATICS SERVICE INFORMATION See ITB19-029 for models built after those listed above for a different Service Procedure. SERVICE INFORMATION The Applied Vehicles are equipped with a wireless communication device called a Telematics Communication Unit (TCU). With an active Infiniti Connection® or Infiniti InTouch Services™, the TCU communicates with the Infiniti Data Center to provide various security and convenience services. This bulletin contains important service procedures that must be performed properly in order to set-up and maintain the telematics system for the Applied Vehicles. Ø A table has been provided on the next page that lists the model and year specific steps required to successfully configure a TCU after it has been replaced. Ø A check OFF sheet has been provided on page 21 to print and check off steps as they are performed. Please staple the completed Check OFF Sheet to the repair order.

AEB WARNING LIGHT IS ON WITH WARNING MESSAGES DISPLAYED ON COMBINATION METER APPLIED VEHICLES: 2015-2024 Q50 (V37) 2015-2018 Q50 Hybrid (HV37) 2017-2022 Q60 (CV37) 2015-2019 Q70 (Y51) 2015-2018 Q70 Hybrid (HY51) 2019-2024 QX50 (J55) 2022-2024 QX55 (FJ55) 2015-2021 QX60 (L50) 2022-2024 QX60 (L51) 2015-2019 QX60 Hybrid (L50H) 2015-2024 QX80 (Z62) SERVICE INFORMATION The AEB system is designed to turn itself OFF during driving conditions (e.g., rain, snow, fog, etc.) that obstruct its sensors. This behavior is normal, and no repairs should be performed. When the AEB system performs an intentional shutdown, the customer may state the following:  The ICC stopped working while driving,  The AEB/FEB warning light is ON, or turned ON, while driving (Figure 1),  The message “Unavailable Front Radar Obstruction” or “Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner's Manual” has displayed while driving (Figure 2). AND  DTC C1A16, C1A16-97, C2582, or C2582-97 is the ONLY DTC stored. Figure 1 Figure 2 Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner’s Manual

INTELLIGENT KEY NOT DETECTED / ENGINE WILL NOT START This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

CAN COMMUNICATION CODES – DIAGNOSTIC TIPS AND GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

CAN COMMUNICATION – NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.