1993 Mazda 626

OBTAINED RECALL 99V-358

TL* THE CONTACT OWNED A 1993 MAZDA 626. WHILE DRIVING 60 MPH, A DRIVER IN ANOTHER VEHICLE NOTIFIED THE CONTACT THAT THE REAR OF THE VEHICLE WAS ON FIRE. THE CONTACT STOPPED THE VEHICLE, PULLED OVER, AND EXITED WITHOUT INJURIES. THE VEHICLE BURST INTO FLAMES. THE FIRE DEPARTMENT EXTINGUISHED THE FIRE. A POLICE REPORT WAS FILED. THE VEHICLE WAS DESTROYED AND TOWED TO A POLICE LOT. THE MANUFACTURER WAS NOT NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 90,000.

NHTSA ID

10854819

Incident

Jun 13, 2007

Mileage

90,000 mi

I OWN A 1993 MAZDA 626 LX WITH A 2.0 LITER ENGINE AND AN AUTOMATIC TRANSMISSION. I PURCHASED IT IN EARLY 1998. I AM THE SECOND OWNER OF THE VEHICLE. IT IS A VERY LOW MILEAGE CAR FOR THE YEAR, WITH JUST MORE THAN 80,000 MILES ON IT. IT HAD JUST OVER 40,000 WHEN I PURCHASED IT USED FROM A LOCAL TOYOTA DEALER. JUST TWO WEEKS AGO, THE TRANSMISSION BROKE AT THE TRANSAXLE AND BECAME COMPLETELY INOPERABLE. I HAD THE VEHICLE TOWED TO MY MECHANIC WHOM I'VE USED FOR ABOUT SIX YEARS NOW. THE TRANSAXLE SPLINES IN THE TRANSMISSION WERE GALLED AND FRACTURED WHEN THE MECHANIC TOOK IT APART. IT WAS BEHAVING FAIRLY WELL UNIT FAILED, BUT IT FAILED VERY QUICKLY, WITHIN A FEW MILES. THIS AUTOMOBILE IS, AND HAS BEEN, VERY WELL CARED FOR AND THE MECHANIC SAID THAT WITH THE EXCEPTION OF THE TRANSMISSION, THE CAR IS IN OUTSTANDINGLY GOOD CONDITION. THE TRANSMISSION HAS NEVER BEEN ABUSED AND FREQUENTLY CHECKED SINCE I'VE OWNED IT. *TR

NHTSA ID

10286015

Incident

Sep 16, 2009

Mileage

82,000 mi

MY CAR STARTED BLINKING "HOLD" IN RED ON THE DASH ABOUT 2 MONTHS AGO. IT WOULD CONTINUE BLINKING, EVEN THOUGH I WASN'T USING THE 'HOLD BUTTON' ON THE SHIFTER. LAST MONTH, IT STARTED SPUTTERING AND MAKING ODD NOISES. IT NOW DOES NOT ACCELERATE VERY EASILY AT ALL. I HAVE TO BE VERY CAREFUL WHEN MAKING A RIGHT TURN, BECAUSE WHEN I FIRST DRIVE IT DURING THE DAY (EVERY DAY, WHEN I DRIVE IT FOR THE FIRST TIME) IT WON'T ACCELERATE PAST 25, EVEN WITH MY FOOT FULL ON THE GAS PEDAL. THE PROBLEM HAS GOTTEN INCREASINGLY WORSE AND I FEAR THAT IT WILL CAUSE IN ACCIDENT BY GETTING STUCK ON A TURN OR SOMETHING. ALSO, I'VE NOTICED SOMETIMES WHEN I'M DRIVING, THE RPM'S WILL GO UP AND DOWN RANDOMLY AND MY CAR WILL JERK. *TR

NHTSA ID

10284156

Incident

Jun 1, 2009

SPEEDOMETER QUIT WORKING AND I HAVE A "HOLD" LIGHT BLINKING. FROM THE STATEMENTS ON INTERNET THIS IS A COMMON PROBLEM DUE TO DEFECTIVE DESIGN BY MAZDA. *TR

NHTSA ID

10226619

Incident

May 1, 2008

Mileage

80,000 mi

I HAVE A SET OF SIGMA SHADOW TIRES ON MY CAR MADE BY TBC CORPORATION. THE TIRE TREAD SEPARATED FROM THE TIRE WHILE I WAS DRIVING AND DAMAGED MY REAR BUMPER. I HAVE ORDERED AN NEW SET OF TIRES TO REPLACE THE DEFECTIVE SET OF TIRES THAT ARE NOW ON MY CAR. THE PROPER SIZE FOR MY CAR WAS NOT LISTED IN THE CHOICES SO I AM LISTING THE PROPER SIZE HERE. THE TIRE SIZE 195/65 R14 NOT 215/60 R16.

NHTSA ID

10192812

Incident

Jun 8, 2007

Mileage

247,050 mi

THE PROBLEM JUST OCCURRED ALL OF A SUDDEN. FROM A STOP LIGHT WHEN THE TRANSMISSION SHIFTED, IT PUSHED THE CAR FORWARD TO WHICH I ALMOST HIT THE CAR IN FRONT OF ME. BROUGHT THE CAR TO A MECHANIC, TRIED TO FIX IT BUT STILL THE PROBLEM IS THERE. *JB

NHTSA ID

10167173

Incident

Aug 1, 2006

Mileage

118,000 mi

MAZDA 626 LX SLIPING GEARS, JURKING, LEAKING TRANSMISSION,TRANSMISSION FAILER HAD TRANSMISSION REBUILT STILL NO GOOD. *NM

NHTSA ID

10151361

Incident

Feb 10, 2006

1993 MAZDA 626-2.0 4CYL AUTO TRANS, 89000 MILES. BOUGHT CAR 9/28/05 FOR $2900.00, ON 11/15/05, ON HIGHWAY, CAR STARTS BUCKING AS THE ENGINE LIGHT FLASHED. I KNOW THAT THIS IS THE BEGINNING OF THE END FOR THE TRANSMISSION. MAZDA, FORD SHOULD BE HELD RESPONSIBLE. USED CAR DEALERS, NO DOUBT, KNOW ABOUT THESE CARS TRANNY PROBLEMS, AND SHOULD BE REQUIRED BY LAW TO INFORM A POTENTIAL BUYER OF THE PAST, PRESENT, AND FOR SURE, FUTURE PROBLEMS REGARDING THE TRANSMISSIONS IN THE MAZDA 626! THEY NEED TO BE HELD RESPONSIBLE! THEY SHOULD BE FORCED TO BUILD A RELIABLE AUTO TRANS AND INSTALL THEM, FREE OF ANY CHARGES TO THE OWNERS OF 626 OWNERS WITH (BY NO FAULT OF THEIR OWN) AUTO TRANS PROBLEMS! *JB

NHTSA ID

10142990

Incident

Nov 14, 2005

Mileage

89,380 mi

Radio Unlocking Codes.

In support of the new MRT distribution, Mazda will ship to dealers a new Dual Purpose Diagnostic Leak Detector beginning March, 2019. Training videos will be posted to MGSS shortly and Workshop Manual procedures will be revised gradually.

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer's responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the "Speedometer Replacement Label". Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazda's vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMO's services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after-warranty assistance (AWA) or DSA that can be utilized to cover this service expense.

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer's responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the "Speedometer Replacement Label". Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazda's vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMO's services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense.

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer's responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the "Speedometer Replacement Label". Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazda's vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMO's services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after-warranty assistance (AWA) or DSA that can be utilized to cover this service expense.

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer?s responsibility to comply with Federal, State, and local laws concerning odometerand related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the ?SpeedometerReplacement Label?.Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazda?s vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service.With the use of SPECMO?s services, a Mazda dealer can get the odometer setting updated to reflect the correct mileage at the time of replacement for both warranty and customer pay repairs, therefore resulting in a higher level of customer satisfaction. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense.