2016 Mazda CX-3

It’s a safety risk with this car. The converter burns super fast, causing issues that seem like it’s related to transmission or alternator.

NHTSA ID

11735158

Incident

May 1, 2026

While driving on the highway on a posted 65mph, the fuel remaining on the vehicle was posted at 1/4, approx. 75miles remaining. The vehicle abruptly stalled and I managed to pull over on the side of the road. The vehicle then refused to start again. Had to bring it to a fuel station and refueled leading to the vehicle starting again. Dealership diagnosed a bad fuel pump and fuel rail.

NHTSA ID

11635954

Incident

Dec 11, 2024

The contact owns a 2016 Mazda CX-3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

NHTSA ID

11633100

Incident

Jul 14, 2023

The contact owns a 2016 Mazda CX-3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated that while reversing, the rearview camera image was distorted on several occasions, and was black on other occasions. The local dealer was contacted. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 45,000. VIN tool confirms parts not available.

NHTSA ID

11619261

Incident

Apr 11, 2023

Mileage

45,000 mi

The contact owns a 2016 Mazda CX-3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The local dealer was contacted, and it was confirmed that the part was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

NHTSA ID

11595717

Incident

Jun 21, 2024

What component or system failed or malfunctioned, and is it available for inspection upon request? Rear view camera and speedometer How was your safety or the safety of others put at risk? Rear view camera restarts and flickers so seeing behind while in reverse is dangerous. The electrical component issues have bled over to the digital speedometer, making it difficult to see the speed at which you are driving. Has the problem been reproduced or confirmed by a dealer or independent service center? Unknown Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others? Unknown Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? No

NHTSA ID

11589104

Incident

May 15, 2024

My recent experience with the service at Putnam Mazda was extremely disappointing and frustrating. What should have been a routine visit turned into a distressing ordeal. My car suddenly died on the freeway without warning lights, prompting me to bring it in for servicing. Initially, I appreciated being offered a loaner car. However, subsequent communication regarding the repair was inadequate and concerning. I received an email stating the necessary part wouldn't be available until July and was abruptly instructed to return the loaner car immediately, with no consideration for my circumstances. This lack of empathy was shocking, especially as a loyal Mazda customer. Furthermore, I experienced racial and gender profiling throughout the ordeal. Instead of addressing my concerns, I was met with aggression and threats of police involvement, making me feel targeted and discriminated against. When I questioned this response, I was told my email was "direct," justifying the aggression. Additionally, the loaner agreement lacked an expiration date. Despite being assured they would provide a grace period if needed, I was demanded to return the car immediately, with false claims about the agreement. This manipulation, gaslighting, and harassment are not only unethical but also against the law. To exacerbate matters, safety concerns with my vehicle were brushed aside. Despite my car having a non-working engine, the dealership suggested I drive it off the lot. This reckless recommendation not only endangered my safety but also the safety of others on the road. Despite repeatedly expressing these safety concerns, the dealership did nothing to address them. Responding to a concerned customer with threats of police involvement is never justified. Instead of addressing my concerns, I was met with aggression and threats. They threatened to report the car stolen and demanded I drive my car without a working engine. This behavior was unwarranted and left me feeling insulted and degrad

NHTSA ID

11582003

Incident

Mar 27, 2024

THE HEADLIGHTS HAVE CONTAINED MOISTURE FOR THE LAST 4 YEARS, CAUSING DIFFUSED, DIMMED VISIBILITY AT NIGHT...VERY DANGEROUS. ALSO, CONCERNED THAT ELECTRICAL MAY BE AFFECTED EVENTUALLY.... Mazda still will not recall and repair?? on fixed income, to pricey for me to repair!

NHTSA ID

11573867

Incident

Jan 1, 2018

This SA supersedes the previously issued SA(s) listed below. The changes are noted in Red. SA-061/25 12/17/25 DESCRIPTION If you encounter any type of electrical concern (e.g, dead battery, engine no start, DTC(s) stored...), interview the customer before proceeding with normal MGSS diagnosis by asking if any aftermarket devices have been installed. Aftermarket devices may be the cause of the electrical concern. Below are a few examples of unusual electrical concerns caused by aftermarket devices. Examples: 1. Devices connected to the DLC-2 (battery discharge/DTC stored) 2. Devices plugged into the 12V outlet 3. GPS tracking device (engine no start/battery discharge) 4. Dash cam (DTC stored) 5. Non-certified USB cable (Apple Carplay™/ Android Auto™ will not connect) 6. Over-sized wheels/tires (incorrect GPS location) 7. DTC C0023:14 8. Decorative trim and/or cover on the START/STOP ENGINE button Example 1: Some electrical devices connected to the DLC-2 connector by insurance or mobile phone companies may cause: Battery discharge. The device may disrupt the CAN system battery saver mode. • IDS/MMDS will not communicate with the vehicle due to poor DLC-2 connection. The aftermarket device may cause DLC-2 female terminals to spread open.

This bulletin supersedes the previously issued bulletin(s) listed below. The changes are noted in Red. 01-008/23 06/05/23 Some vehicles may exhibit rattling noises from the engine compartment and oil leakage from the drive belt auto tensioner. This may be caused by insufficient sealing at the drive belt auto tensioner damper when the auto tensioner fully operates under both high ambient temperature and high load conditions. To eliminate this concern, the shape of the drive belt auto tensioner damper has been changed. REPAIR PROCEDURE If the tensioner is found to be "No Good" after completing the Drive Belt Auto Tensioner Inspection, replace it with a modified part according to the instructions on MGSS online:

DESCRIPTION Some vehicles may require the replacement of a damaged VIN plate or vehicle certification label. To obtain a replacement VIN plate (bulkhead-mounted and visible through the lower-left area of the windshield), contact DAG (Dealer Assistance Group) using VIN Plate Request Form available on One Mazda. To obtain a replacement vehicle certification label (located on the B􀀀pillar or front door), contact your assigned DSM (District Service Manager) to place the order. If DSM contact information is not available, refer to the Dealer & Field Contact Directory.

This Service Alert supersedes the previously issued SA listed below: The changes are noted in Red. SA-011/24 02/12/24, 06/06/24, 07/29/24 DESCRIPTION Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner's manual. Services performed outside of Mazda's factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers. SCHEDULED MAINTENANCE Refer to the applicable Workshop Manual or Owner's Manual for vehicle -specific manufacturer scheduled maintenance. Workshop Manual - Refer to section 00-00 SCHEDULED MAINTENANCE. Owner's Manual - Refer to section 8 Maintenance and Care. b. Note: Please refer to the information below outlining the services not included in Mazda's Factory Scheduled Maintenance: IMPORTANT: Recommending fluid flushes when not necessary can lead to customer confusion and dissatisfaction. Fluid flushing for preventive maintenance purposes is strongly discouraged, unless otherwise specified in a published procedure (Owner’s Manual, Workshop Manual, Technical Service Bulletin, etc.).

This Service Alert supersedes the previously issued M-Tip(s) listed below. The changes are noted in Red text. MT-002/19 09/30/19 and 12/19/19 DESCRIPTION If an engine assembly is replaced after a catastrophic internal mechanical failure, clean the intake manifold internally before installing a replacement engine assembly. If the intake manifold is not cleaned properly, the replacement engine may fail prematurely. Metallic debris from the old engine (with catastrophic internal mechanical failure) may rest inside the intake manifold. When the new engine assembly is installed, debris in the intake manifold will be ingested into the new engine and cause internal damage. Clean the intake manifold internally to remove any debris from old engine before installing the new replacement engine assembly. If the intake manifold cannot be properly cleaned internally, replace it.

This Service Alert supersedes the previously issued M-Tip(s) listed below. The changes are noted in Red text. MT-003/22 03/02/22 DESCRIPTION Some customers may complain about a tapping or knocking noise coming from the rear seat after fuel fill. The concern will likely occur if the fuel tank is overfilled (more fuel is added after the fuel pump nozzle shuts off automatically) or filled up normally in high ambient temperatures and the fuel expands. No repair is needed. Explain to the customer not to continue filling after nozzle shut off.