2025 Mazda CX-50

"My 2025 Mazda CX-50 began overheating while still under the factory warranty. During one incident, the engine lost coolant and overheated. I immediately shut the engine off to prevent damage. The vehicle continues to overheat, and the air conditioning only cools properly while the vehicle is moving. When stopped or idling, the A/C stops cooling. I have reported the issue to my Mazda dealer and opened Mazda Customer Experience Case Number 00473077. The problem remains unresolved despite multiple attempts to obtain assistance. I am concerned this condition presents a safety risk." "The vehicle has been inspected by an authorized Mazda dealership on two separate occasions. The dealership kept the vehicle for several days during these inspections but reported that it could not reproduce or identify the cause of the overheating. Despite these inspections, the overheating condition and the air conditioning issue continue. During one of the service visits, I also discovered scratches to the vehicle's exterior that were not present before it was left with the dealership."

NHTSA ID

11753687

Incident

Jul 2, 2026

While driving my 2025 Mazda CX-50, the entire center-dash climate control panel (HVAC module) suffered a sudden, spontaneous, and total electrical power blackout. The unit completely loses power and goes dark exactly as if the power button was pressed. This is a recurring failure that occurs after only a few minutes of vehicle operation. This electrical failure immediately cuts all airflow and A/C cooling to the cabin. The unit can temporarily be turned back on manually, only to black out and fail completely again minutes later. This represents my second consecutive modern Mazda vehicle to experience an early-mileage HVAC hardware/electrical failure (previously a CX-30), indicating a dangerous, recurring manufacturing defect in Mazda’s electrical/climate control architecture that requires a formal safety recall. Additional Considerations: Distraction and Loss of Driver Focus, Rapid Window Fogging and Blindness, Extreme Heat Exhaustion and In-Cabin Medical Emergency, and Broader Electrical Fault Concerns.

NHTSA ID

11752977

Incident

Jul 27, 2026

The vehicle was traveling at highway speeds when it experienced a sudden, violent lateral jerk to the side, causing immediate side-curtain/seat airbag deployment prior to impacting the center divide. I believe there was a sudden, catastrophic mechanical failure of the front suspension componants causing a partial detachment of the front driver's side wheel. This failure mirrors the exact defect described in NHTSA Campaign 24V834000 / Mazda Recall 7925J regarding un-torqued front suspension fasteners. We believe our vehicle suffered from this exact factory build issue despite falling outside the initial recalled VIN list. Insurance claim to follow.

NHTSA ID

11751702

Incident

Jul 18, 2026

Brake booster failure in less than two years of ownership. It seems to be an issue with A LOT of these models. Very unsafe to have any brake failure

NHTSA ID

11748108

Incident

May 1, 2026

I previously reported the auto breaking system would slam on breaks prematurely. Now it was a factor in an accident where the Mazda CX-50 was rear-ended by a Ram 2500 truck at full speed on the highway. Car is incompaitated and I have suffered injuries.

NHTSA ID

11746992

Incident

Jun 24, 2026

When approaching cars at an intersection, the brake warning does not give any warning, but the cars brake, lock up, and throw me and anything in the seat flying into the floor or side compartment. It was not even necessary to stop that quickly. Totally random and could cause an accident.

NHTSA ID

11742408

Incident

Mar 17, 2026

CRUISE CONTROL SURGES BEYOND NORMAL LIMITS, HAS TRIED TO TAKE CURVES ON EXITS SO FAST THE TIRES SLIDE AND I HAVE TO SLAM ON THE BRAKES. ALSO, WHEN PULLING OUT FROM BEHIND A CAR, THE CRUISE CONTROL KICKS IN TOO FAST AND IS FLYING TOWARD STOPPED CARS, AND I HAVE TO USE THE BRAKE TO STOP IT OR REAR-END THE CAR IN FRONT OF ME. ALSO, THE FUEL SYSTEM WOULD NOT ALLOW ME TO FILL UP THE GAS TANK, AND I WAS STRANDED. COMPUTER WOULD NOT OPEN THE FUEL TANK FOR ME TO PUT FUEL INTO IT. HAS TO PRY THE ENTIRE ASSEMBLY OFF AND BREAK IT. THEN FUEL WOULD NOT GO INTO THE FUEL TANK, AIR PRESSURE KEPT TURNING OFF THE PUMP. AFTER THOSE INCIDENTS GOT THE CAR BACK FROM THE DEALER AND TWO DAYS LATER IT WAS COMPLETELY DEAD IN THE GARAGE, NOTHING WORKED, LOCKS, BACK LATCH, ETC. WHEN THEY RECARGED IT THERE WERE DOZENS OF CODES ON.

NHTSA ID

11742406

Incident

Apr 22, 2026

I rented this vehicle from Enterprise (EAN HOLDINS LLC) in Collierville Tn. on 5/19/25 I rented the vehicle to attend a funeral in Virginia. I drove 1803 miles there and back. While it was raining and cold, I used the seat heaters on and off when I noticed that my legs and gluts began to become irritated and inflamed. Once I finally was home late that night, I observed that I had been burned on legs and glut area. The areas were red and inflamed. That morning I had blisters and large red/purple bruises which I began documenting with photos. I went to see my doctor who stated that I had 1st and 2nd degree burns which he then photographed and documented in my chart and prescribed some meds. Today the areas are still numb but appear to be healing. I did report this incident to Enterprise locally and I also made a complaint with the company's corporate office 1800 numbers. These car seat heaters are extremely dangerous

NHTSA ID

11740251

Incident

May 22, 2026

This SA supersedes the previously issued SA(s) listed below. The changes are noted in Red. SA-063/24 09/06/24 DESCRIPTION The Blind Spot Monitoring (BSM) system can malfunction with the following symptoms if the rear side radar sensors are installed facing the wrong direction.

This Service Alert supersedes the previously issued SAs listed below. The changes are noted in Red text. SA-017/25 12/16/25, 09/08/25, 07/14/25, 05/15/25 and 03/21/25 DESCRIPTION Mazda Connect Frequently Asked Questions (FAQ) Index General Questions MAZDA CONNECT Indication Setup and Getting Started Dealer Processes Registration / Enrollment / Take-Over Customer Subscription Status WI-FI General Informatio Opening the TCU Communication Line WI-FI How-To Conditions for Remote Engine Start Will Not Function WI-FI Trial Period Conditions for Remote Engine Start Function Will turn engine OFF Interacting With The App TCU Communication Line Status Service Issues Educational Videos Troubleshooting Resources MyMazda App Error Codes Customer Opt-Out

COMPLIANCE WITH NEW YORK STATE GENERAL BUSINESS LAW §399‑CCCCC (CONNECTED VEHICLE SERVICE; DOMESTIC VIOLENCE VICTIMS) DESCRIPTION This Service Information is issued in accordance with New York State General Business Law §399􀀀CCCCC (Connected Vehicle Service; Domestic Violence Victims). This regulation is intended to protect victims of domestic violence by allowing them to request the termination of third-party access (including access by an alleged abuser) to connected vehicle services, such as vehicle location tracking and remote control functions. To support this requirement, this Service Information enables confirmation of whether a vehicle is subject to connected vehicle services by referring to the SUBJECT VIN & PRODUCTION DATE RANGE, and provides guidance on the procedure to terminate such services when a customer requests the removal of third-party access for an applicable vehicle. Effective July 1, 2026, if a customer requests action under this regulation, a CMU/CDC software update must be performed to enable appropriate control of connected vehicle service access. If no request is made by the customer, the CMU/CDC software update is not required. REPAIR PROCEDURE 1. Confirm that the customer has requested deactivation of connected services in accordance with New York State General Business Law related action. 2. Perform the CMU/CDC software update according to the procedures outlined in the appropriate TSB shown in the table below:

UPDATED SOFTWARE RELEASE FOR CONCERNS WITH MAZDA CONNECT INFOTAINMENT SYSTEM This bulletin supersedes the previously issued bulletin(s) listed below. The changes are noted in Red. 16-001/26 01/08/26 DESCRIPTION The release notes outlined below provide an overview of bug fixes, feature improvements, and updates included in the latest software release. The latest version of software contains all the updates of the previous versions. NOTE: If current version is not 7230C1A-NA01_***** or 7230C2A-NA01_*****, this TSB is not applicable. Version 7230C1A-NA01_10022 enables termination of connected services at customer request: Termination of Connected Services by customers at their initiative has been enabled. Accordingly, the following items have been updated. Add a "Data Communication Information" item under Settings > System Settings>Online Connectivity. ○ Updated the text displayed on the confirmation screen for disabling Connected Services. ○ • The list on the center display may appear distorted, giving a double image. • The system may reboot when the ignition is turned on. However, the camera images on the center display are not affected, and the back camera is usable. • The voice recognition function does not start. • Apple CarPlay® may fail to connect while driving on the highway. REPAIR PROCEDURE 1. Verify the customer concern. 2. Update MAZDA CONNECT with software version 7230C1A-NA01_10022/7230C2A-NA01_10014 or later with a USB memory stick using the 7TH GEN MAZDA CONNECT Update Instructions.

DESCRIPTION Some vehicles may exhibit a clicking, popping, tapping or knocking noise from the front end when turning left or right and accelerating. NOTE: The noise could occur at different steering wheel angles or power levels. Due to the insulating properties of the suspension and chassis, it can be difficult to determine which driveshaft is at fault by listening from inside the vehicle. See the attached video for an example of an outer CV joint clicking. These noises may be caused by the outer ball joint cage machining being out of specification. To eliminate this concern, tighter quality controls have been implemented to ensure proper machining of the cage window. NOTE: The part number for the improved part has not been changed. The current parts inventory is after the countermeasure production date implementation.

This SA supersedes the previously issued SA(s) listed below. The changes are noted in Red. SA-061/25 12/17/25 DESCRIPTION If you encounter any type of electrical concern (e.g, dead battery, engine no start, DTC(s) stored...), interview the customer before proceeding with normal MGSS diagnosis by asking if any aftermarket devices have been installed. Aftermarket devices may be the cause of the electrical concern. Below are a few examples of unusual electrical concerns caused by aftermarket devices. Examples: 1. Devices connected to the DLC-2 (battery discharge/DTC stored) 2. Devices plugged into the 12V outlet 3. GPS tracking device (engine no start/battery discharge) 4. Dash cam (DTC stored) 5. Non-certified USB cable (Apple Carplay™/ Android Auto™ will not connect) 6. Over-sized wheels/tires (incorrect GPS location) 7. DTC C0023:14 8. Decorative trim and/or cover on the START/STOP ENGINE button Example 1: Some electrical devices connected to the DLC-2 connector by insurance or mobile phone companies may cause: Battery discharge. The device may disrupt the CAN system battery saver mode. • IDS/MMDS will not communicate with the vehicle due to poor DLC-2 connection. The aftermarket device may cause DLC-2 female terminals to spread open.