1997 Mazda MX-5 Miata

I HAVE A 1997 MAZDA MIATA WITH 113,000 MILES. IT HAS BEEN A GREAT CAR UP UNTIL THIS RECENT PROBLEM. IT STARTED OUT THAT THE "METER" FUSE WAS FAILING INTERMITTENTLY. WHEN THE 15 AMP FUSE WAS REPLACED IT WOULD WORK FINE FOR APROXIMATELY 2-3 MINUTES (MAYBE LESS) AT WHICH POINT I NOTICED THE "SERVICE ENGINE" LIGHT IS NOW ON AND THEN THE FUSE WILL FAIL AGAIN. THIS HAPPENED SEVERAL TIMES UNTIL NOW. NOW WHEN THE FUSE IS REPLACED AS SOON AS THE IGNITION CYLINDER IS CYCLED THE FUSE FAILS INSTANTLY. I AM AN AUTOMOTIVE TECHNICIAN, AND CHECKED A WIRING SCHEMATIC AS TO WHAT THIS "BLACK-YELLOW" WIRE ON THE "METER" FUSE SUPPLIES. BY THE WAY, AT THIS TIME I HAVE NO TURN SIGNALS, TACHOMETER, GAUGES OR WARNING LIGHTS. THIS PROBLEM IT DRIVING ME INSANE!!! I WENT THROUGH THE MANUAL AND DISCONNECTED EACH COMPONENT INDIVIDUALLY TO TEST THE CIRCUIT AT WHICH EACH TIME THE FUSE STILL FAILED. THE LIST OF COMPONENTS I TRIED ARE THE OXYGEN SENSORS, THE ECM, THE TURN SIGNAL SWITCH, AND THE INSTRUMENT CLUSTER (CRUISE CONTROL IS ALSO ON THIS CIRCUIT, BUT THE VEHICLE IS NOT SO EQUIPED) ALL TO NO AVAIL!!!! AM I MISSING SOMETHING? IS THERE A SHORT IN THE WIRING HARNESS ITSELF, IF SO, ANY SUGGESTIONS AS TO WHERE I SHOULD EXTEND MY SEARCH? THIS HAS BEEN A PROBLEM FOR ABOUT 2 WEEKS NOW AND I AM UNCOMFORTABLE DRIVING THE VEHICLE WITH THE ABOVE STATED CONCERNS. ANY INFORMATION YOU CAN GIVE ME REGUARDING THIS CONCERN WOULD BE GREATLY APPRECIATED!!!.*AK

NHTSA ID

10032778

Incident

Jul 28, 2003

WE TOOK THE CAR IN TO SUNNYVALE MAZDA TODAY BECAUSE THE STEERING COLUMN WAS LOOSE AND THEY SAID THE SAFETY CLAMPS ARE BROKEN AND THAT THE STEERING COLUMN NEEDED TO BE REPLACED (PLUS THE SAFETY CLAMPS) AND THAT WE MUST HAVE RUN OVER A "BUMP" TO CAUSE THE STEERING COLUMN TO HAVE TO BE REPLACED. I WONDER HOW MANY OTHER MAZDA MIATA'S HAVE HAD THIS HAPPEN TO THE STEERING COLUMN AT APPROXIMATELY 18,000 MILES.*AK

NHTSA ID

762945

Incident

Jun 11, 2002

THE THREAD ABOUT TO SEPARATE FROM THE TIRE (TIRESIZE: P185-60R14)( DOT NUMBER: TIRE SIZE: P185-60R14 )

NHTSA ID

733895

AT ALL TIMESTHERE IS A STRONG GASOLING ODOR IN VEHICLE AND IN TRUNK WHICH CAUSES OCCUPANTS TO GET SICK. DEALER CANNOT DETERMINE THE CAUSE. *AK

NHTSA ID

867197

Incident

Jan 1, 1999

VEHICLE WAS INVOLVED IN A FRONTAL COLLISION AT 35-40MPH, AND THE AIRBAGS DID NOT DEPLOY, CAUSING INJURIES. *AK

NHTSA ID

854008

Incident

Apr 5, 1999

DRIVER'S FLOORMAT IS CONSTANTLY WORKING WAY ONTO GAS PEDDLE CAUSING ACCELLORATOR TO STAY ON FLOOR, HOOK WOULD SOLVE PROBLEM, SEVERAL NEAR ACCIDENTS

NHTSA ID

709250

CELL PHONE USAGE IN VEHICLE, CAUSES BATTERY TO FAIL. *YC

NHTSA ID

607920

PARKING AND DIRECTIONAL LIGHT FAILED. MJS

NHTSA ID

605992

Incident

Nov 20, 1998

Radio Unlocking Codes.

This service bulletin provides information regarding the proper use of the driver’s floor mat to avoid any potential interference with the foot pedals. The following are possible causes of floor mat interference, which can be avoided with proper usage.

This service bulletin provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the battery periodically according to the repair procedure.

The Mazda DCA-8000PM is required for all warranty battery testing. If the Mazda DCA-8000PM is not used, incorrect battery testing may result in unnecessary battery replacement. Use the following test procedures in this Service Bulletin to test Mazda vehicle batteries and to generate a Warranty Code.

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer’s responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement.  Mazda vehicles are manufactured with tamper-proof speedometers.  When a speedometer is replaced, the new speedometer will read zero (0) miles.  This procedure is extremely important to accurately represent actual vehicle mileage.  Prior to speedometer removal, complete the information required on the “Speedometer Replacement Label”. Labels can only be ordered through Mazda eStore.  In an effort to achieve a higher level of Customer Experience and retain the value of Mazda’s vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMO’s services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense.