1999 Oldsmobile 98

EA02-030 IS CLOSED WITH GMEA02-030 IS CLOSED WITH GM?S ACTIONS IN 03V-473 AND 04V-090 RECALLING APPROXIMATELY 529,000 MY 1998-99 C- AND H-BODY VEHICLES EQUIPPED WITH DEFECTIVE FUEL PRESSURE REGULATORS.THESE VEHICLES WERE EQUIPPED WITH PLASTIC INTAKE MANIFOLDS THAT ARE UNABLE TO CONTAIN PRESSURES THAT OCCUR IN SOME BACKFIRE EVENTS AND DEFECTIVE FUEL PRESSURE REGULATORS WITH LEAKING DIAPHRAGMS THAT CAN PROVIDE A SOURCE OF FUEL TO PRODUCE A COMBUSTIBLE AIR-FUEL MIXTURE IN THE MANIFOLD.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY ODI THAT NO SAFETY DEFECT EXISTS IN THE VEHICLES THAT ARE NOT INCLUDED IN GM?S RECALLS.ODI WILL CONTINUE TO MONITOR THE INCIDENCE OF MANIFOLD RUPTURES AND RELATED FIRES IN OTHER MY 1995-2002 GM PASSENGER CARS EQUIPPED WITH THE SUBJECT INTAKE MANIFOLD.FOR ADDITIONAL INFORMATION, SEE THE ATTACHED CLOSING REPORT.

TURNED KEY IN IGNITION HEARD A LOUD BANG OPENED HOOD AND THE INTAKE MANIFOLD AND ENGINE COVER HAD BLOWN APART. JB

NHTSA ID

10021824

Incident

May 1, 2003

This warranty administration bulletin provides information regarding the field action courtesy transportation policy.

THIS TECHNICAL BULLETIN PROVIDES A PROCEDURE TO REPROGRAM THE MEDIA DISC PLAYER WITH THE LATEST CALIBRATIONS TO CORRECT A CONDITION OF THE REAR ENTERTAINMENT SYSTEM NOT OPERATING AS INTENDED IN COLDER AMBIENT TEMPERATURE AREAS DUE TO CALIBRATION CONCERNS.

Vehicle Recalls

Refinishing Aluminum Wheels This bulletin updates General Motor's position on refinishing aluminum wheels. GM does not endorse any repairs that involve welding, bending, straightening o re-machining. Only cosmetic refinishing of the wheel's coatings, using recommended procedures, is allowed. Evaluating Damage In evaluating damage, it is the GM Dealer's responsibility to inspect the wheel for corrosion, scrapes, gouges, etc. The Dealer must insure that such damage is not deeper than what can be sanded or polished off. The wheel must be inspected for cracks. If cracks are found, discard the wheel. Any wheels with bent rim flanges must not be repaired or refinished. Wheels that have been refinished by an outside company must be returned to the same vehicle. The Dealer must record the wheel ID stamp or the cast date on the wheel in order to assure this requirement. Refer to Refinisher's Responsibility — Outside Company later in this bulletin.

Refinishing Aluminum Wheels This bulletin updates General Motor's position on refinishing aluminum wheels. GM does not endorse any repairs that involve welding, bending, straightening o re-machining. Only cosmetic refinishing of the wheel's coatings, using recommended procedures, is allowed. Evaluating Damage In evaluating damage, it is the GM Dealer's responsibility to inspect the wheel for corrosion, scrapes, gouges, etc. The Dealer must insure that such damage is not deeper than what can be sanded or polished off. The wheel must be inspected for cracks. If cracks are found, discard the wheel. Any wheels with bent rim flanges must not be repaired or refinished. Wheels that have been refinished by an outside company must be returned to the same vehicle. The Dealer must record the wheel ID stamp or the cast date on the wheel in order to assure this requirement. Refer to Refinisher's Responsibility — Outside Company later in this bulletin.

Underbody Component Corrosion The following information may be helpful when addressing underbody component corrosion with customers. Some customers may comment that one or more of their vehicle's underbody components are showing some form of corrosion. This corrosion may be red in appearance (rust) if the component is steel, forged iron or cast iron. This corrosion may also be grey or white in color if the component is constructed of an aluminum alloy.