2013 BMW 128I

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

The contact owns a 2013 BMW 128I. The contact stated that the air bag warning light remained illuminated. The local dealer was not contacted. The vehicle was not repaired. The failure was a recurring failure, and the vehicle was parked and no longer driven due to safety concerns. The manufacturer was not made aware of the failure. The failure mileage was unknown.

NHTSA ID

11696560

Incident

Oct 26, 2025

On or about 2022 I was given notice of recall which told me to go to any BMW dealer for repair. I went to Niello BMW in Sacramento. I was getting car processed and then told to summarily leave. They refused to repair my car per recall notice

NHTSA ID

11688526

Incident

Aug 22, 2022

The contact owns a 2013 BMW 128I. The contact stated that after starting the vehicle, the air bag warning light illuminated. The contact also stated that while his wife was seated in the front passenger’s seat, the passenger’s side air bag warning light illuminated. The vehicle was taken to the dealer, who determined that the front passenger’s side seat occupancy mat had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure and informed the contact that the part was no longer being manufactured. The failure mileage was approximately 82,000.

NHTSA ID

11679043

Incident

Jul 15, 2025

Mileage

82,000 mi

Front passenger air bag seat occupancy sensor (OC3) mat warning "Passenger restraint system. Fault in passenger restraint system affecting airbag" BMW has an extended warranty for this exact issue on several other models, but not the 1 series which should be included. This is a huge safety issue and shouldn't be the customer's responsibility.

NHTSA ID

11614818

Incident

Aug 7, 2024

See attached document for complaint.

NHTSA ID

11611643

Incident

Aug 11, 2024

The contact owns a 2013 BMW 128I. The contact received notification of NHTSA Campaign Number: 22V119000 (Engine and Engine Cooling); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.

NHTSA ID

11514539

Incident

Mar 2, 2023

The contact owns a 2013 BMW 128i. The contact stated while driving at 30 MPH, she smelled a strong burning odor. There was no warning light illuminated. The contact stated that the failure reoccurred several times while driving. The contact stated that the strong burning odor caused her to collapse once. The contact sought medical assistance and was informed that her brain was not getting enough oxygen. The contact stopped driving the vehicle. Additionally, the contact stated that upon starting the vehicle in the driveway, she saw smoke coming out from underneath the hood of the vehicle. The contact later received notification of NHTSA Campaign Number: 22V119000 (Engine And Engine Cooling) however, the part to do the recall repair was not yet available. The local dealer was contacted. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure and referred the contact to NHTSA. The failure mileage was approximately 75,001. VIN tool confirms parts not available.

NHTSA ID

11466120

Incident

Feb 25, 2022

Mileage

75,001 mi

The contact owns a 2013 BMW 128i. The contact received notification of NHTSA Campaign Number: 22V119000 (Engine and Engine Cooling) however, the part to do the recall repair was not yet available. The dealer was made aware of the issue. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact had not experienced a failure. VIN tool confirms parts not available.

NHTSA ID

11464493

Incident

May 12, 2022

While performing a 12-Volt battery jump start, disconnect, or replacement, Vehicle test, and/or Programming procedure- the BMW Footwell Module (FRM) may become unresponsive. As a result, one or more of the following vehicle electric system-related issues may occur: Headlights including the high beams, and/or taillights are not turning on or off Interior lights are not turning on Turn indicators are not working Instrument cluster indicator lights stay on The IHKA climate control system is not working Power windows are not working Folding mirrors are not working, and/or a Functional remote-control key FOB will not unlock and lock the doors

The electrical system of BMW vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This document covers important information for the dealer on how to handle “discharged battery” complaints.

N55 Engine: Various Faults Stored in DME Related to VANOS and Camshaft Position. A rattling noise can be heard from the engine compartment; the engine has a loss of power; and the Service Engine Soon lamp is illuminated. One or more of the following faults may be stored. E70, E71, E82, E88, E90, E92 and E93: 2D5A - VANOS, intake: control fault, camshaft sticking 2D5B - VANOS, intake: control fault, position not reached 2D60 - VANOS, exhaust: control fault, camshaft sticking 2D61 - VANOS, exhaust: control fault, position not reached 2D9F - camshaft input sensor: signal implausible 2DA1 - Camshaft exhaust sensor: signal implausible 300C - Camshaft input sensor: signal high 300D - Camshaft input sensor: signal low 300E - Camshaft exhaust sensor: signal high 300F - Camshaft exhaust sensor: signal low F07, F10, F12, F13 and F25: 130104 - VANOS, intake: control fault, camshaft sticking 130108 - VANOS, intake: control fault, position not reached 130304 - VANOS, exhaust: control fault, camshaft sticking 130308 - VANOS, exhaust: control fault, position not reached 130E11 - Camshaft input sensor: signal implausible 130F11 - Camshaft exhaust sensor: signal implausible 164020 - Camshaft input sensor: signal high 164021 - Camshaft input sensor: signal low 164030 - Camshaft exhaust sensor: signal high 164031 - Camshaft exhaust sensor: signal low CAUSE One or both (intake and/or exhaust) of the VANOS gear assemblies have failed; the attaching bolts may have also loosened and/or broken.

Butt connector for repairing a plug connection. The ?top up coolant? message is displayed in the central display (CC message ID 166). When checking the cooling system there are no leaks found and the expansion tank is filled to the proper level.

NAVIGATION SYSTEM: REPORTING MISSING OR INCORRECT ROAD MAP DATA: The route guidance is inaccurate and therefore irritating to the customer; or it is not possible to locate certain addresses, for instance:

NAVIGATION SYSTEM: REPORTING MISSING OR INCORRECT ROAD MAP DATA: The route guidance is inaccurate and therefore irritating to the customer; or it is not possible to locate certain addresses, for instance: