2010 Chevrolet Silverado

The contact owns a 2010 Chevrolet Silverado. The contact received notification of NHTSA Campaign Number: 21V054000 (Air Bags). However, the part to do the recall repair was not yet available. The local dealer was contacted. The local dealer-scheduled an appointment but cancelled it due to parts not being available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.

NHTSA ID

11549640

Incident

Aug 1, 2023

2010 CHEVROLET SILVERADO. CONSUMER WRITES IN REGARDS TO ACCESSORY POWER MODULE SAFETY RECALL. THE CONSUMER STATED THE HYBRID CONTROL MODULE WAS FAILED AND THERE WOULD BE NO PARTS AVAILABLE TO REPAIR IT. THE MANUFACTURER DENIED REPAIR ASSISTANCE AND WOULD NOT BUY BACK THE VEHICLE. THE VEHICLE'S MILEAGE WAS 149,169.

NHTSA ID

11453628

Incident

Feb 23, 2022

TL* THE CONTACT OWNS A 2010 CHEVROLET SILVERADO. WHILE ATTEMPTING TO REMOVE THE SPARE TIRE FROM UNDERNEATH THE VEHICLE, THE SPARE TIRE FAILED TO MOVE. AS A RESULT, THE CONTACT HAD TO FRACTURE THE WIRE CABLE THAT HELD THE TIRE IN PLACE. THE VEHICLE WAS NOT DIAGNOSED NOR REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE FAILURE MILEAGE WAS 71,000.

NHTSA ID

10860010

Incident

Apr 11, 2016

Mileage

71,000 mi

TL* THE CONTACT OWNS A 2010 CHEVROLET SILVERADO. THE CONTACT STATED THAT WHILE PARKED, SHE OBSERVED MULTIPLE CRACKS ON THE DASHBOARD NEAR THE STEERING COLUMN AND THE PASSENGER AIR BAG AREA. THE VEHICLE WAS TAKEN TO A DEALER WHERE IT WAS DIAGNOSED THAT THE DASHBOARD NEEDED TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS MADE AWARE OF THE FAILURE. THE FAILURE MILEAGE WAS 30,000.

NHTSA ID

10850037

Incident

Feb 15, 2015

Mileage

30,000 mi

MY OIL PRESSURE SENDING UNIT HAS BEEN REPLACED TWICE IN TWO MONTHS. THE OIL PRESSURE WILL BE FINE WHEN STARTING THE ENGINE COLD THEN GRADUALLY AS THE ENGINE WARMS UP IT DROPS AND DROPS UNTIL THE "LOW OIL PRESSURE" LIGHT COMES ON AND THE DISPLAY SAYS TO STOP ENGINE. AFTER SHUTTING OFF THE ENGINE FOR ONLY A FEW SECONDS AND THEN RESTARTING THE OIL PRESSURE IS BACK AROUND 30 THEN WILL DROP AND DROP AND WILL HAVE TO REPEAT. THIS LAST TIME I WAS DRIVING 80MPH AND THE OIL PRESSURE GAUGE WENT DOWN TO AROUND 5. AS SOON AS IT WAS RESTARTED IT WAS AROUND 30. THE FIRST REPLACEMENT WAS ON 1/19/2016. THIS LAST WAS REPLACED 03/07/2016.

NHTSA ID

10845640

Incident

Mar 7, 2016

Mileage

67,000 mi

THE DASH HAS CRACKED ON THE PASSENGER SIDE OF MY 2008 GMC 3500 DUALLY. THE CRACK IS IN BETWEEN THE AIR BAG AND THE WINDSHIELD. THE CRACK IS ABOUT 1" TO 1 1/2" LONG. THE CRACK APPEARED WHILE THE TRUCK WAS SITTING OUTSIDE.

NHTSA ID

10840143

Incident

Mar 3, 2016

Mileage

62,000 mi

DASHBOARD CRACKING IN MULTIPLE PLACES AROUND PASSENGER AIRBAG AND DRIVER INSTRUMENT PANEL

NHTSA ID

10836435

Incident

Feb 12, 2016

Mileage

60,000 mi

"TAKATA RECALL". THE TRUCK HAS A BIG CRACK IN DASH ABOVE INSTRUMENT PANEL. TRUCK HAS 35500 MILES ON IT AND IS ALWAYS STORED IN CLIMATE CONTROLLED SHOP. IT HAPPENED WHILE BEING STORED INSIDE SHOP. NEVER SETS OUT IN THE SUN AND HAS NEVER HAD ARMORALL PROTECTANT ON IT

NHTSA ID

10836224

Incident

Oct 5, 2015

Mileage

34,000 mi

This technical bulletin provides a procedure to lube the rear leaf springs on vehicles with the condition of a squeak noise originating from the rear of the vehicle.

14648A - Customer Satisfaction. Certain vehicles have a performance issue with their OnStar modules that could impact the vehicle?s battery life. If the vehicle?s OnStar module contains this condition, the OnStar green telltale light will be illuminated even when the vehicle is off. This condition can drain the vehicle?s battery if the vehicle is not started for approximately four days. The condition may also render the OnStar system inoperative, which would disable all OnStar services, including automatic crash response and emergency roadside services. This condition can occur even if the vehicle is not actively subscribed to OnStar. Dealers are to remove the fuse for the OnStar module to reset it.

This Preliminary Information communication provides information to the technician about vehicles that may have a bump feel or clunk noise at a stop or on launch. Dealer should communicate to the customer this condition is a normal operating characteristic of their vehicle. The bump clunk issue may be due to fuel movement in the fuel tank when not completely full. The condition is eliminated after completely filling the fuel tank.

This Preliminary Information communication advises the technician that the Hydro-Boost is not serviceable and will need to be replaced if the brake pedal moves or applies on its own at a full turn.

This Preliminary Information communication provides the technician with the additional steps that are needed to help perform a successful brake bleed on the 2-Mode Hybrid with Regular Production Option Code HP2. With a battery maintainer installed on the vehicle use brake pressure bleeder that maintains 30 psi for the entire bleed procedure.

This Preliminary Information communication provides the technician with a list of modules to check for communication with the scan tool, if the navigation radio does not display the current Hybrid mode. Dealer will use a scan tool to check communication with Accessory Direct current Power Control Module, Air Condition control module, Drive Motor Generator Power Inverter Module, Engine Control Module, Battery Energy Control Module, and Transfer Case Control Module. Repair the loss of communication with the affected module and the power flow should return to the radio display.