2020 Hyundai Venue

I bought this Hyundai Venue because it came with a manual transmission, which I prefer driving, however the transmission has been the biggest issue with this vehicle. It has a tendency to get stuck in reverse, most often when changing gear on a slight incline or decline. This has left me frantically trying to force the transmission out of reverse and into first. It's really scary when this happens in traffic (ex: reversing out of a parallel park). Sometimes you have to "rock" the car by reversing further (if you have space), clutching in and jiggling the shifter, but that doesn't always work. This started happening so frequently that I took the car to Pohanka Hyundai of Fredericksburg and they diagnosed it as acorns getting stuck in the gear linkage, but after having it cleaned out and seeing no more squirrel/rodent activity, it still gets stuck in reverse on occasion. I have owned two manual transmission cars before this and never had this issue with those.

NHTSA ID

11755301

Incident

Aug 2, 2026

The car horn stopped working. Replaced the fuse and still not working.

NHTSA ID

11736888

Incident

May 6, 2026

In a passenger-side front collision at 25mph, no front collision warning was given, and the automatic braking system did not engage. Fire broke out inside the vehicle next to the floorboard beside the front passenger seat (bottom of B-post) almost immediately upon impact. Upon inspection of the vehicle on 1/16, I believe the wiring that powers the passenger side airbags shorted (see photos), resulting in a fire which quickly engulfed the interior of the vehicle. Investigation, police report, and insurance still pending.

NHTSA ID

11711460

Incident

Jan 13, 2026

The trunk handle and latch malfunctioned, due to "internal part failure" (cited by dealership diagnostic). Each time I locked or unlocked my car, the trunk latch would repeatedly make noise as if trying to unlock/lock but it was jammed. After multiple click noises, the trunk would then sporadically pop open while driving, causing me to have to pull over and force it shut again. This created a safety concern as it would pop open while driving. There was no consistency on when this would happen either, making it unsafe to drive not knowing if it would suddenly pop. I brought it to the local Hyundai dealership who looked at it and recommended a full trunk latch and handle replacement. They cited that it was an "internal part failure," however since my model of car did not have a recall out yet for trunk latches (other Hyundai models currently do), it was not covered (costing $1,162). There were no warning lights or messages. The first trunk latch jam happened on November 30th when putting stuff in my trunk. The repeated clicking and trunk popping then occurred December 7th. After that, the clicking and jamming occurred every day, each time I locked or unlocked my car. It got progressively worse with increased trunk pops while driving. I brought it to the dealership on December 10th for diagnostic assessment.

NHTSA ID

11709308

Incident

Dec 7, 2025

I have two serious complaints about this vehicle. I am 5 ft 2 in tall. The seatbelt consistently slides across my neck causing distraction while driving. One would think that manufacturers would have figured this out by now. Almost all vehicles do this to anyone under 5ft 3in tall. Can’t tell me that when they add expensive sensors the seatbelt adjustment would be all that expensive to fix. Also- I have three grandchildren two in car seats one rear facing. It is not safe for me to travel with all three in the backseat. If I’m sideswiped the older child will have broken hips there is simply not enough room. And when we put the rear facing in the back seat the passenger in front has to push up so far their knees are in the dash. Can we say”how about I eat that airbag?”

NHTSA ID

11671257

Incident

Jul 4, 2025

I've owned this car since October 26, 2022. I noticed that my gas pedal is spongy and doesn't want to go or after I've stopped for a stop sign or a light. It was only happening every so often when I first got it but now it's happening at least once a week. My local CarX, whom I've been taking my vehicles to since 2013 and have a great relationship with, has looked at everything and can't find a cause. They told me to file a complaint to see if a recall is in the works for this transmission.

NHTSA ID

11662444

Incident

May 19, 2025

Position of accelerator and brake pedals is dangerous and potentially fatal. The brake pedal is significantly higher than the accelerator, often causing the driver's foot to slip onto the accelerator. Also, braking is difficult due to pedal placement that does not allow natural movement from the accelerator to the brake pedal because the height difference causes the driver's foot to hit the side of the brake, forcing driver to panic, lift leg high, and hope he hits the brake in time to prevent a rear-end collision. The dealer confirmed that the pedals are not adjustable, rendering the entire vehicle unsafe. Other Venue drivers have told me they have the same problem but no solution.

NHTSA ID

11638981

Incident

Jan 27, 2025

The contact owns a 2020 Hyundai Venue. The contact stated that while driving at an undisclosed speed and depressing the accelerator pedal, the vehicle failed to accelerate as intended. The check engine warning light illuminated. In addition, the contact stated that the vehicle was previously repaired under TSB #: 23-01-019H; however, the failure reoccurred. The vehicle was towed back to the same local dealer where it was diagnosed with DTC code: P0301 (Transmission Failure) and the contact was informed that the failure was related to TSB #: 23-01-019H. The vehicle was not repaired and remained at the local dealer. The manufacturer was made aware of the failure by the local dealer. The failure mileage was approximately 120,000.

NHTSA ID

11621745

Incident

Oct 23, 2024

Mileage

120,000 mi

Some vehicles may exhibit difficulty starting in cold weather. This bulletin provides the procedure to perform an inspection on the starter magnetic switch for potential freezing and, if necessary, replace the starter magnetic switch (solenoid) assembly.

The National Highway Traffic Safety Administration (NHTSA) has issued an urgent safety advisory regarding dangerous, counterfeit driver‑side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN), that have been identified in U.S. vehicles following prior crashes, theft, or non‑certified airbag replacements. These inflators are not approved for use, may rupture during deployment, and have caused serious injuries and fatalities. Please see attached announcement, provided by NHTSA, for more details.

The National Highway Traffic Safety Administration (NHTSA) has identified the presence of substandard and dangerous driver’s-side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN). These inflators were not supplied, approved, or authorized by the vehicle manufacturers and have primarily been found in vehicles that previously experienced a crash and underwent airbag replacement using non-genuine parts. These dangerous inflators have ruptured during deployment, posing a serious risk of injury or death due to metal fragments entering the vehicle cabin. To date, Hyundai is aware of three people who have died while driving a Hyundai vehicle with one of these substandard replacement airbag inflators that deployed in what likely would have been a survivable crash. NHTSA has issued a public advisory urging vehicle owners and service professionals to have vehicles inspected if there is reason to believe that a non-genuine replacement airbag may have been installed. Vehicles with salvage or rebuilt titles, prior airbag deployments, or unknown repair histories may present a higher risk. NHTSA strongly cautions against self-inspection by vehicle owners and recommends inspection by trained technicians.

In response to this trend, we engineered a software upgrade that addresses the social media theft method and made it available to owners of eligible models free of charge at authorized Hyundai dealers since early 2023. In addition to the anti-theft software, we’ve developed a new zinc-reinforced ignition cylinder protector hardware upgrade that can be installed at the ignition cylinder location to provide additional protection against the social media theft method. Because your Hyundai vehicle with the VIN listed above (“Subject Vehicle”) was not factory-equipped with an engine immobilizer and was previously eligible for the software upgrade, you are now eligible until March 31, 2027 to have the ignition cylinder protector installed — if you request it — at no cost to you through an authorized Hyundai dealership.

In addition to the Anti-Theft software provided under Service Campaign 993 (TSB 24-01-009H-1), a zinc reinforced ignition cylinder protector hardware upgrade is being made available to customers upon request. This supplemental security measure is to be installed at the ignition switch location and provides additional protection against the social media theft method. Vehicles not equipped with an immobilizer during production at the factory are eligible. The repair procedure shall be performed and claimed upon customer request only. Any future repairs to these vehicles in which an installed ignition cylinder protector impacts required parts and/or labor, shall be covered by HMA. Please see TSB 25-01-089H for details.

Upon customer's request ONLY, the Technical Service Bulletin (TSB) 25-01-089H provides the service procedure for installation of a key cylinder reinforcement protector assembly and two anti-theft decals on the front windows. This repair procedure is being provided in addition to the previous Anti-Theft software provided under Service Campaign 993 (TSB 24-01-009H-1).