2017 INFINITI Q60

My engine is blown at 70,000 miles and I got there 45,000 miles and I had a car for 18 months

NHTSA ID

11736487

Incident

May 7, 2026

Subject: Safety Complaint: 2017 Infiniti Q60 - Recurring P052E Fault (Engine Shared with Mercedes) Vehicle Information: Make: Infiniti Model: Q60 Year: 2017 Engine: (Insert Engine Size, 2.0L) Incident Details: Code: P052E (Crankcase Ventilation Valve Performance) Symptoms: Check engine light, strong burnt oil smell, rough idling, low engine output/lack of acceleration. Problem Description: "I am filing this complaint to report a recurring, serious defect in my 2017 Infiniti Q60 regarding the PCV (Positive Crankcase Ventilation) system, throwing OBD-II code P052E. The vehicle experiences severe loss of power while driving, rough idle, and a strong odor of burning oil inside the cabin, which poses a fire risk and inhibits safe operation. It is well-documented that this vehicle utilizes an engine manufactured/designed in collaboration with Mercedes-Benz, and a recall exists within the Mercedes community for this exact code (P052E). However, Infiniti has not issued a corresponding recall, leaving owners of this shared-engine vehicle to pay for repairs on a known manufacturing defect. Given the severe symptoms and the recognized safety hazard of this defect by other manufacturers, I request an investigation into this safety issue

NHTSA ID

11730980

Incident

Oct 21, 2025

The contact owns a 2017 Infiniti Q60. The contact stated while driving at an undisclosed speed, the accelerator pedal was depressed; however, the vehicle failed to accelerate as intended, with the check engine warning light illuminated. The vehicle was taken to an independent mechanic where it was diagnosed with turbo charger failure. The contact was informed that the turbo charger needed to be replaced. The vehicle was not repaired. The contact referenced an unknown recall with a similar failure description; however, the VIN was not associated with the recall. The manufacturer was made aware of the failure but provided no assistance. The contact was informed that there were no recalls associated with the VIN. The failure mileage was approximately 130,000.

NHTSA ID

11713748

Incident

Jan 27, 2025

Mileage

130,000 mi

9/8/25 Airbag light is on dealership states it's the occupancy sensor. Must replace the seat frame $7k just for the part. I seen that the QX50 and 60 had same issue and a recall was issued. Could you please help us resolve this issue.

NHTSA ID

11693720

Incident

Sep 8, 2025

Engine threw a main bearing around 80 thousand miles in 2023, car was not modified other than different muffler on the back and aftermarket wheels and tires which has nothing to do with the engine. Car had oil changes every 3500-4500 miles with MOTUL full synthetic oil. No engines lights were given, car was taken to a Nissan dealership as manufacturer warranty was expired, my extended warranty was fidelity and they declined due to these aftermarket “changes” dealership gave me a quote over 25k dollars which is what I paid for the car in 2019. I understand it’s a luxury brand but these engines are well known for these issues and nothing is done other than some warranty extension for failing turbos which are also terrible and I believe to be the CAUSE of this thrown bearing, I have owned so many Nissans and will most likely never own another after this mistake. Still love the car but the people that buy these deserve better for the cost. The car is currently sitting in a garage because the cost is absurd.

NHTSA ID

11670882

Incident

Jul 2, 2025

Car malfunction light comes on spontaneously and runs rough and losses power and rpm can go to 4 at 35 mph and usually happens when car is idling parked for a little while. Them I cut it off and let it sit it goes back to normal. I also had prior problems with it smoking from tailpipe and it’s documented at dealership in Columbia SC and they said it wasn’t smoking enough to replace the turbos at the time but I got a notification from manufacturer about turbo malfunction.

NHTSA ID

11653939

Incident

Apr 1, 2025

The automobile has 24,000 miles on it and the sensor for the passenger seat airbag is defective. To repair this, the passenger seat track has to be replaced, at a cost of $8200.00. This is a major safety issue for this automobile.

NHTSA ID

11614045

Incident

Aug 26, 2024

Infiniti called me on 05/08/24 to discuss and review Infiniti Case # [XXX] including Infiniti’s subsequent refusal to remedy a defective SRS (Supplemental Restraint System) sensor on my 2017 Infiniti Q60 with 54,100 miles (VIN: [XXX] ). This defect was confirmed on 05/07/24 by Infiniti of Melbourne Florida through an authorized technician. While I am the original owner of the vehicle, Infiniti stated they will not provide any financial assistance to rectify the issue because the vehicle is outside of the manufacturers warranty, while acknowledging that there have been numerous customer complaints related to this problem and that Infiniti has been aware of defective SRS parts effecting a critical safety device that renders the air bag system inoperable. Moreover, to repair such a deficiency, based on Infiniti’s design, the entire seat must be replaced costing over $8K, an exorbitant and onerous amount, often more than 50% of the vehicles value. This excessive financial charge has deliberately burdened Infiniti owners with a safety related component. For several years this issue has been recurrently discussed on multiple public forums and yet Infiniti has intentionally decided not to remedy this safety issue or provide any assistance or consideration to its customers. I’ve attached an Infiniti forum link (one of dozens) proving that Infiniti has known about this problem going back over a decade and failed to take any action and instead prolonged a predatory pricing scheme that is harming owners. [XXX] ) As a result of Infiniti’s complete intransigence on a safety related matter, the National Hwy. Traffic Safety Admin. (NHTSA), should compel Infiniti to remedy this situation. It’s hoped that Infiniti will take immediate action to correct this situation and not abandon its owners in an untenable, unsafe and unjustifiable predicament. Sincerely, [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11588541

Incident

May 7, 2024

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Infiniti by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

TELEMATICS SERVICE INFORMATION See ITB19-029 for models built after those listed above for a different Service Procedure. SERVICE INFORMATION The Applied Vehicles are equipped with a wireless communication device called a Telematics Communication Unit (TCU). With an active Infiniti Connection® or Infiniti InTouch Services™, the TCU communicates with the Infiniti Data Center to provide various security and convenience services. This bulletin contains important service procedures that must be performed properly in order to set-up and maintain the telematics system for the Applied Vehicles. Ø A table has been provided on the next page that lists the model and year specific steps required to successfully configure a TCU after it has been replaced. Ø A check OFF sheet has been provided on page 21 to print and check off steps as they are performed. Please staple the completed Check OFF Sheet to the repair order.

AEB WARNING LIGHT IS ON WITH WARNING MESSAGES DISPLAYED ON COMBINATION METER APPLIED VEHICLES: 2015-2024 Q50 (V37) 2015-2018 Q50 Hybrid (HV37) 2017-2022 Q60 (CV37) 2015-2019 Q70 (Y51) 2015-2018 Q70 Hybrid (HY51) 2019-2024 QX50 (J55) 2022-2024 QX55 (FJ55) 2015-2021 QX60 (L50) 2022-2024 QX60 (L51) 2015-2019 QX60 Hybrid (L50H) 2015-2024 QX80 (Z62) SERVICE INFORMATION The AEB system is designed to turn itself OFF during driving conditions (e.g., rain, snow, fog, etc.) that obstruct its sensors. This behavior is normal, and no repairs should be performed. When the AEB system performs an intentional shutdown, the customer may state the following:  The ICC stopped working while driving,  The AEB/FEB warning light is ON, or turned ON, while driving (Figure 1),  The message “Unavailable Front Radar Obstruction” or “Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner's Manual” has displayed while driving (Figure 2). AND  DTC C1A16, C1A16-97, C2582, or C2582-97 is the ONLY DTC stored. Figure 1 Figure 2 Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner’s Manual

***** Retailer Announcement ***** INFINITI is committed to providing the highest levels of product quality and customer satisfaction. Therefore, INFINITI is conducting a warranty extension to Full Useful Life (FUL) of 10 years or 120,000 miles, whichever occurs first, if white smoke or oil leak occurs with MIL-On condition that requires replacement of the turbocharger assembly on model year 2016-2018 Q50 and model year 2017-2018 Q60. All other warranty terms, limitations, and conditions remain unchanged. On some model year 2016-2018 INFINITI Q50 and 2017-2018 Q60 vehicles there is a possibility that the turbocharger bearing may leak engine oil internally due to premature wear. The internal turbocharger oil leak may cause one or more of the following: Excessive smoke from the exhaust, Service Engine Soon (MIL) light and in severe cases, lack of engine power or damage to the internal components of the turbocharger. During the limited emission warranty extension period, owners are eligible for free replacement of the Turbocharger if it is determined to be required by an INFINITI trained technician. Owners of eligible vehicles will receive notification of this limited emission warranty extension during February 2025. ***** What Retailers Should Do ***** 1. Verify if vehicles are eligible for this Warranty Extension using the warranty extension page of Service Comm. Then, proceed with the instructions in item (2) below. 2. If a client contacts the retailer with a Turbocharger concern in an owned or leased vehicle, retailers should use the Electronic Service Manual (ESM) and appropriate Technical Service Bulletins (TSB) to diagnose the root cause of the customer concern and identify the correct repair to resolve the customer concerns. NOTE: Retailers will need to follow the warranty process and obtain pre-approval when the repair cost exceeds a Retailer’s Claims Administration/Authorization Limits (DCAL). CONFIRM: With the vehicle at operating temperature excessive smoke from exhaust, the Service Engine Soon (MIL) light on (with DTC P0106) due to excessive oil in the intake system from a turbocharger, or other damage to the turbocharger due to unusual bearing P4A05/P4A06 | Original Document wear and oil leakage. Proceed to replace the affected turbocharger(s) and update the vehicle to the latest engine software.

MIL ON WITH DTC(S) STORED IN THE ECM This bulletin is no longer active. Please discard previous versions of ITB17-050.

TURBOCHARGER REPLACEMENT PROCEDURE APPLIED ENGINES: VR30DDTT IF YOU CONFIRM One or both turbochargers require replacement. ACTION 1. Replace the affected turbocharger(s).  Refer to the SERVICE PROCEDURE in this bulletin for the updated procedure. IMPORTANT: You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair. 2. Refer to step 212 in the SERVICE PROCEDURE to confirm if the ECM needs to be reprogrammed.  2016-2024 Q50 and 2017-2021 Q60 will require ECM reprogramming at the end of this SERVICE PROCEDURE. 3. If the ECM part number is in Table A (page 61 and 63), reprogram the ECM. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.