2025 INFINITI QX80

I experienced severe wheel instability on 3/29/2026 at around 630pm on I74 West while traveling on the highway at high speed. I was forced to perform emergency maneuvers to avoid a catastrophic collision, resulted in a terrifying near-miss incident that required an emergency tow to safety. Upon inspection, it was confirmed that the lug nuts on the left rear wheel were not properly torqued and were dangerously loose as outlined by the tow report below :-----Please see the following service report regarding PO 3166 for a 2025 Infiniti QX80. When we arrived on scene, the customer stated that the vehicle made a sudden jerk and veered unexpectedly while being driven. Before touching or loading the vehicle, we took photos and observed that the left rear wheel appeared to be close to coming off the vehicle. Upon further examination, we found that 3 of the 5 lug nuts had broken off completely. The remaining 2 lug nuts were still in place, but were barely holding.I advised the customer that the safest course of action was to jack the vehicle up and tighten the 2 remaining lug nuts as much as possible in order to reduce the risk of the wheel falling off during loading, unloading, or transport. This was done strictly to help avoid additional body or vehicle damage---: Most critically, my [XXX] child was in the vehicle during this life-threatening event placing my family in immediate catastrophic near miss dangerous event. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11734428

Incident

Mar 29, 2026

What component or system failed or malfunctioned, and is it available for inspection upon request? Two components have failed: the infotainment/Apple CarPlay system, including the USB-C connectivity port, and the front collision detection/crash sensor system. The entire A/V unit was replaced on August 1, 2025, yet the infotainment defect persisted. Both systems are currently installed in my vehicle and are available for inspection upon request. How was your safety or the safety of others put at risk? The front collision detection system malfunction directly compromises my ability to rely on the vehicle's built-in safety features to prevent or mitigate crashes. Additionally, the infotainment screen has frozen and reset while the vehicle was in motion. I have also been locked out of my vehicle twice while the engine was running, which created a dangerous situation. Has the problem been reproduced or confirmed by a dealer or independent service center? Yes. On July 25, 2025, a technician at Georgetown Infiniti attempted and failed to connect their own phone to the CarPlay system, confirming the defect was in the vehicle and not my personal device. The collision system malfunction has been documented across multiple service visits at both Georgetown Infiniti and Grubbs Infiniti. Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others? Yes. The vehicle has been inspected and serviced by authorized Infiniti dealerships, specifically Grubbs Infiniti and Georgetown Infiniti, both of which are manufacturer-authorized service centers. Most recently addressed 2/4/20226. Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? Yes. The infotainment screen displayed warning messages, froze, and reset while driving. The front collision system displayed malfunction warnings on the dashboard.

NHTSA ID

11729242

Incident

Mar 28, 2026

The contact owns a 2025 Infiniti QX80. The contact stated that the middle seat belt receiver failed to function as intended. Upon inspection, the contact became aware that when the third-row seat was folded under, the seat belt receiver was crushed. No warning lights were illuminated. The vehicle was taken to the dealer, where it was confirmed that the seat belt receiver was damaged by the third-row seat. The vehicle remained at the dealer pending the repair. The manufacturer was not made aware of the failure. The failure mileage was approximately 3,000.

NHTSA ID

11720942

Incident

Feb 13, 2026

Mileage

3,000 mi

While driving my Infiniti QX80, 2025 model, the driver's side mirror is constantly shaking and vibrating, especially on uneven roads or at speeds over 40–50 mph. The vibration blurs the mirror, making it impossible to see clearly and posing a safety risk. I brought this to the dealer, but they could not resolve the issue. They replaced the mirror, yet it did not help and actually made the vibration worse. Now they claim this is "normal" and that nothing can be done. However, the vibration is constant and unacceptable for safe driving. I request further investigation and resolution.

NHTSA ID

11718472

Incident

Jun 20, 2025

Camera monitoring system or rear visibility system. The rearview/backup camera has intermittently malfunctioned in my QX80 numerous times since I purchased the car in February 2024, including (1) displaying a frozen image from the backup camera when putting the car in reverse which stayed frozen (for example, did show a car driving directly behind me which I almost hit) and displayed the frozen image to the driver the entire time driving the car, including at highway speeds, and which could not be manually removed from view (including by pressing the camera button); and (2) the backup camera not turning on at all when the QX80 is put in reverse, not could the backup camera be turned on manually by pushing the camera button. I attached some photos of the frozen rearview/backup camera which remained displayed to the driver the entire time driving the car, including while traveling on the interstate at highway speeds (65 mph) when the photos were taken attached below. The date below is the date of the photo, however backup camera malfunctions has occurred numerous times and dates. I also have numerous videos of the malfunctions described herein that I can also share.

NHTSA ID

11693639

Incident

Sep 30, 2025

A lady driving a Honda Fit pulled out in front of my wife while she was driving her Infinity QX80. My wife was driving about 40-45 MPH at the time of the crash. The driver at fault in the Honda Fit I noticed all air bags deployed. My wife's QX80 had none of the air bags deployed. The officers at the scene were shocked to see the amount of damage to my wife's QX80 while not triggering the air bags to be deployed. One in particular told us to make sure we reported this to the insurance company.

NHTSA ID

11659777

Incident

May 7, 2025

Sunroof exploded. There is a sunshade which protected passengers. Infiniti dealer and it is my understanding that the Company are aware that it happened. Repairs have been made. Three appeared to be no reason for the sunroof to explode.

NHTSA ID

11635678

Incident

Oct 9, 2024

New QX80 should be taken off the road. The Infotainment system is the central computer system to the car. Countless times where the system reboots WHILE DRIVING yielding electronics cluster (Speed control, Heads up Display, etc) blacked out. Upon "reboot", the stereo system is blaring loud, without ability to turn down volume, creating a dangerous driving environment. Only resolution, to date, is to press and hold for 10-15 seconds the powerbutton to shutoff. Having to do this while driving is dangerous. Other isntances where the car pneumatic suspension system - connected to said infotainment system - faults and creates the car to go up/down while driving. This is similar to a friend who has the same exact car, who's having the same exact issues. There is no resolution. This car NEEDS TO BE TAKEN OFF THE ROAD UNTIL INFINITI CAN PROVE STABLE COMPUTER FUNCTIONALITY. IT WILL CREATE ACCIDENTS/DEATH. This has happened numerous times. Photo is from most recent after driving "blind" on the cluster back to our driveway to take a picture.

NHTSA ID

11632378

Incident

Dec 25, 2024

FUEL FILLER TUBE LOWER SEAL IS LEAKING AND DTC P0456 IS STORED IN THE ECM This bulletin is no longer active. Please discard previous versions of ITB26-002.

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Infiniti by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

FUEL FILLER TUBE LOWER SEAL IS LEAKING AND DTC P0456 IS STORED IN THE ECM IF YOU CONFIRM The vehicle has a visible leak with a smoke machine test coming from the fuel filler tube lower seal, AND DTC P0456 is stored as “Active”, “Past”, or “Pending” in the ECM. ACTION 1. Remove the supplied funnel from the rear of the vehicle or trunk. 2. Insert the funnel completely in the fuel filler tube and remove completely five (5) times. 3. Re-check the fuel filler tube lower seal with a smoke machine to determine visually if any leak is present. 4. If the fuel filler lower seal continues to leak, replace the fuel filler tube. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.

VENT CONTROL VALVE IN ACTIVE TEST INOPERATIVE IN CONSULT 4 SERVICE INFORMATION An issue in CONSULT 4 has been identified in “EVAP system close” in Work support. · After selecting the "EVAP system close" in Work support, the “VENT CONTROL/V” in Active test becomes non-functional temporarily. · When selecting “EVAP system close” operation in Work support, wait 10 minutes before starting “VENT CONTROL/V” Active test or cycle the IGN switch ON/OFF for “VENT CONTROL/V” Active test to be operational. HINT: This bulletin applies to model years that use CONSULT 4 only.

DOOR MIRROR REVERSE TILT-DOWN FEATURE NOT WORKING PROPERLY SERVICE INFORMATION If the customer states that the door mirror tilt position does not return to the set memory position when shifting from Reverse to Drive or from Drive to Reverse, replace the SWITCH ASSY - POWER WINDOW, MAIN (Main Power Window Switch). IMPORTANT: · Do not replace the BODY - DOOR MIRROR (Door Mirror) for this issue. · Do not use the EPC to determine the service part number for the Main Power Window Switch. Use the part number listed in the PARTS INFORMATION

IF YOU CONFIRM The AEB warning was displayed, and one or both of the following DTCs stored as Current: · U2752-88 for “Ethernet circuit” stored in the ADAS control unit 2. · U275F-88 for “Ethernet circuit” stored in the Distance Sensor control unit. HINT: The ESM shows U275F-88 as being stored in the LASER/RADAR control unit and in CONSULT 4 it is displayed as Distance Sensor. ACTION 1. Confirm the current Distance Sensor control unit part number. 2. Reprogram the Distance Sensor control unit, if applicable.