2004 Isuzu N-Series

ON SEVERAL OCCASIONS MY 2004 ISUZU RODEO WILL NOT START. I WILL ATTEMPT TO START IT, AND IT WILL TURN OVER AND THEN WILL NOT START. I WILL THEN ATTEMPT TO START THE SUV AGAIN AND I GET NOTHING. I HAVE LEARNED THAT I HAVE TO GET OUT OF THE VEHICLE LOCK THE DOORS, UNLOCK THE DOORS GET BACK IN AND ATTEMPT TO START THE VEHICLE AGAIN. I HAVE HAD THIS HAPPEN TO ME SITTING IN TRAFFIC AS WELL. THE VEHICLE WILL JUST STALL OUT AND THEN WILL NOT START. I HAVE REPORTED THIS TROUBLE TO MY LOCAL ISUZU DEALERSHIP AND THEY TELL ME THAT THEY ARE AWARE OF THE TROUBLE AND THERES NOTHING THEY CAN DO ABOUT IT. THEY TOLD ME THAT THEY HAVE HAD MANY COMPLAINTS ABOUT THE SAME PROBLEM. I TOLD ME IT HAD SOMETHING TO DO WITH THE IMMOBILZER ON THE VEHICLE. I ASKED IF ISUZU PLANNED ON DONT ANYTING ABOUT IT, AND THE RESPONSE I GOT WAS THAT THEY HAD NO FIX AT THIS TIME.*AK

NHTSA ID

10118461

Incident

Feb 23, 2005

Mileage

5,000 mi

INFORMATION BULLETIN: THE INFORMATION SET FORTH IN THIS BULLETIN IS INTENDED TO AID TECHNICIANS IN PROPERLY TESTING THE BATTERIES AND ALTERNATORS IN THE AFFECTED ISUZU VEHICLES. IT IS IMPORTANT TO CONFIRM THE BATTERY IS IN GOOD CONDITION PRIOR TO DIAGNOSIS OF THE ALTERNATOR AND CHARGING SYSTEM. NEVER REPLACE AN ALTERNATOR BEFORE TESTING THE BATTERY’S CONDITION.

THIS INFORMATION BULLETIN OUTLINES THE SERVICE PROCEDURE FOR INSTALLATION OF FLUID LEVEL INDICATOR JOINT TUBE ANYTIME THE AISIN TRANSMISSION IS REMOVED OR OIL PAN IS REMOVED AND REINSTALLED TO PREVENT WATER INTRUSION TO TRANSMISSION.

THIS INFORMATION BULLETIN IS TO REMIND DEALERS WHENEVER THE IPC ASSEMBLY IS REPLACED IN AN AFFECTED ISUZU MANUFACTURED VEHICLE, THEY ARE TO AFFIX AN ODOMETER REPLACEMENT STICKER, AS THE ODOMETER IS NOT PROGRAMMABLE. THE STICKER SHOULD BE FILLED OUT COMPLETELY WITH THE DATE OF REPLACEMENT ALONG WITH THE MILEAGE FROM THE PREVIOUS ODOMETER READING, AND THE DEALER CODE OF THE DEALERSHIP REPLACING THE IPC.

INFORMATION BULLETIN: THIS BULLETIN APPLIES TO ALL OEM AND REMANUFACTURED ENGINE AND TRANSMISSION ASSEMBLIES, FOR THE AFFECTED VEHICLES LISTED ABOVE, TO BE REPLACED UNDER THE ISUZU NEW VEHICLE WARRANTY, GOODWILL, ISUZU PARTS WARRANTY, GOLD STAR USED TRUCK WARRANTY AND/OR ALL EXTENDED POWERTRAIN WARRANTIES OFFERED BY ISUZU, AS WELL AS ALL OVER-THE-COUNTER ENGINE AND TRANSMISSION ASSEMBLY REPLACEMENTS.

The following information is provided to clearly explain Isuzu’s policy for control module (engine, transmission, antilock brake, instrument panel, body control, power interface, etc.) reprogramming. Control module calibrations are regularly updated for many reasons. These reasons may include, but are not limited to: model year change, software corrections, certification compliance, product improvement and specific application requirements. However, the mere existence of a newer control module calibration does not necessarily mean that warranty coverage exists or that the calibration must be installed. It is not our policy to update control modules, under warranty or after warranty, based solely on the availability of a newer calibration file. Below are our guidelines for reprogramming control modules.

This bulletin outlines the procedures for using the Alpine Exchange Program (the "Exchange Program"). The Exchange Program must be used when any Alpine radio or other component covered by this bulletin is repaired under warranty and may also be used for radio and component repairs not covered under warranty. Contact Alpine directly for pricing and payment methods applicable to radio and component repairs not covered under warranty.