2008 Jeep Liberty

In a letter dated August 21, 2014, the Center for Auto Safety (CAS) petitioned the National Highway Traffic Safety Administration (NHTSA) to initiate a defect investigation of alleged failures associated with the Totally Integrated Power Module (TIPM) installed in Chrysler SUV?s, trucks, and vans beginning in the 2007 model year. The petitioner alleges that TIPM defects may result in engine stall, airbag non-deployment, failure of fuel pump shutoff resulting in unintended acceleration, fire, and other symptoms. On September 25, 2014, the Office of Defects Investigation (ODI) opened DP14-004 to evaluate the petition for a grant or deny decision. ODI analyzed complaint data provided by CAS as well as complaints submitted to ODI from consumers. In total, there were 296 complaints submitted by the petitioner in the original petition and five supplements, including 271 complaints related to the subject vehicles equipped with TIPM-7. Approximately 3 percent of CAS complaints are related to vehicles equipped with TIPM-6 and ODI?s review of these complaints did not identify any safety defect trends. ODI conducted a detailed review of complaints narratives submitted by CAS and consumers including careful analysis of vehicle repair histories, warranty claims obtained from the manufacturer and any available Customer Assistance Inquiry reports (CAIR). Analysis of the field data indicated that MY2011-2013 Jeep Grand Cherokee and Dodge Durango vehicles exhibited significantly higher complaint rates related to fuel pump relay (FPR) failures than other subject vehicles. In a September 3, 2014 letter to NHTSA, Chrysler submitted a Defect Information Report (DIR) identifying a defect in the FPR within the TIPM-7 which can result in a no start or stall condition in approximately 188,723 model year (MY) 2011 Jeep Grand Cherokee (WK) and Dodge Durango (WD) vehicles manufactured from January 5, 2010 through July 20, 2011 (14V-530).In a February 24, 2015 letter, Chrysler submitted a second DIR expanding the scope of the FPR defect condition to include an additional 338,216 MY 2012 through 2013 Jeep Grand Cherokee vehicles manufactured from September 17, 2010 through August 19, 2013 and MY 2012 through 2013 Dodge Durango vehicles manufactured from January 18, 2011 through August 19, 2013 (15V-115).ODI analysis of the CAS allegations of TIPM defects resulting in stall while driving, airbag non-deployment, unintended acceleration, fire and other faults identified a single defect condition related to 1 of over 60 different circuits in the TIPM assembly. The most common effect of this defect condition, related to the fuel pump relay, was a no-start concern, but it could also result in stall while driving (76 complaints). No valid evidence was presented in support of claims related to airbag non-deployment, unintended acceleration or fire resulting from TIPM faults and these claims were found to be wholly without merit based on review of the field data and design of the relevant systems and components.Except insofar as the petitioner's contentions relate to the defect condition addressed by the Chrysler recalls, the factual bases of the petitioner's contentions that any further investigation is necessary are unsupported. In our view, additional investigation is unlikely to result in a finding that a defect related to motor vehicle safety exists or a NHTSA order for the notification and remedy of a safety-related defect as alleged by the petitioner at the conclusion of the requested investigation. Therefore, in view of the need to allocate and prioritize NHTSA's limited resources to best accomplish the agency's safety mission, the petition is den

Airbag light has been coming on and stays on. When I start my vehicle the airbag in the dash on passenger side sounds like it’s trying to escape. Scary. I have a service appointment for April 2, 2026, Thursday. They can’t get me in sooner. I understand the recall doesn’t apply. I’m stating that it SHOULD! Please expand your recall to more Jeep models. I want this on record as I am deeply concerned about my safety.

NHTSA ID

11728193

Incident

Mar 27, 2026

Suspension rotting out for jeeps were recalled up until 2007. My 2008 jeep has the same issue with rotted suspension bars. Originally recalls were for 2005 they added up to 2007. Mine is a 2008. We need to add another year suspension bar is rusted in half. 158 thousand miles. the rest of underbody is solid. .

NHTSA ID

11722184

Incident

Mar 5, 2026

I am having problems when I back up and turn the steering wheel it starts to make noise and it slows down line it don't want to turn. And my EPS light will not turn off no matter what I do to it. There is something seriously wrong when I'm backing up n turning the wheels if you could please help me an if it has nothing to do with the recall but I'm sure it dies let me know what it is. Thank You [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11715318

Incident

Dec 12, 2025

Both lower rear control arms rusted out, broke off entirely while driving. Under 100k miles. This issue was recalled on the same make and model up until 2007 but they clearly haven't fixed the issue.

NHTSA ID

11694361

Incident

Oct 18, 2025

Steering wheel air bag went off on its own. Started the car and pop. Door locks won’t work on drivers door when unlocking with key fob

NHTSA ID

11682239

Incident

Aug 20, 2025

The contact's husband owned a 2008 Jeep Liberty. The contact stated that while driving at various speeds, the air bag and traction control warning lights would flash on the instrument panel. The contact stated that while driving at 40 MPH, the vehicle hydroplaned while crossing a puddle of water and landed in a ditch. The side curtain air bags deployed; however, the driver and passenger air bags did not deploy. The contact stated that an abnormal odor was emitted from the vehicle. The contact sustained bruising on the left arm but did not seek medical attention. A police report was not filed. Due to the failure, the vehicle was initially towed to the contact's home and was later towed to an independent tow yard. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline to file a complaint. The vehicle was destroyed. The failure mileage was unknown.

NHTSA ID

11675909

Incident

Apr 16, 2025

Rear control arms rusted on both sides. One side cracked almost completely through. Mechanic confirmed close to failure which would cause loss of control of vehicle. In 2017 this model was recalled for this danger but only through model year 2007. Appears same defective part was used in this model year (2008). No warning lights of problem. Observed myself and mechanic confirmed problem.

NHTSA ID

11620263

Incident

Oct 8, 2024

Recently driving down the road heard a very loud noice thought i had a tire blowout. It was both Rear lower control arms broken Completely into( very rusty ).It also broke my exhaust and banged up the driveshaft. This is very expensive to repair and could have very well been Deadly. Would like for someone to contact me asap ty

NHTSA ID

11587061

Incident

Apr 25, 2024

SWITCH - CLUTCH STARTER INTERLOCK & MASTER CYLINDER ASSEMBLY - CLUTCH

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Transmission Kit with Torque Converter 1. All Promaster (VF) 3.6L/62TE equipped vehicles. If the transmission bracket to the transmission case fasteners are removed during servicing, the fasteners (Part Number 06511385A$) are one-time usage. Vehicles built prior to 10/23/2015 requires Service Kit PN 68461214AA; includes Transmission Isolator PN 68264483AA, and Adaptation Bracket 68264479AA and Fastener Service Kit PN 68329056AA Vehicles built after on or after 10/23/2015 will require only the Fastener Service Kit PN 68329056AA. 2. All 3.6L/62TE equipped vehicles. If the vehicle you are repairing has a crack in the flex plate or failed pump bushing inspect and confirm that both (2) dowel pins are present in the engine block, which align the transmission center line to the crank shaft centerline and visually inspect the dowel alignment holes in the transmission case. If the holes are damaged or elongated the transmission should be replaced to prevent further damage to the transmission/flexplate or pump bushing due to the inability to properly align the engine to the transmission during the repair. 3. All 62TE equipped vehicles. If pump bushing is scored or damaged and the dowel pin alignment holes are ok, replace the pump assembly as opposed to complete transmission. 4. All 62TE equipped vehicles. If vehicle is jerking/slipping with MIL code(s) P0740 or P2764, check TCC Solenoid operation. If TCC Solenoid is ok, the codes are indicative of a torque converter failure. Replace the torque converter.

Mechanical rocker arm, intake, 1.7 ratio.

Mechanical rocker arm, intake, 1.7 ratio.