2009 Mazda Mazda5

The subject vehicles have electro-hydraulic power assist steering (EHPAS).The complaint counts shown above alleged a loss of power steering assist in the subject vehicles.Usually, but not always, the loss is accompanied by the simultaneous lighting of an indicator light on the dash.The complaints include 14 alleged crashes involving 6 injuries.On Mazda3 and Mazda5 vehicles manufactured from April 2, 2007 through November 30, 2008, rust may have formed inside the EPAS high-pressure pipe during manufacture due to improper processing.If the rust is present it may damage the power steering pump bearings leading to an increased load on the electric motor; this results in an elevated operating temperature for the EPAS system.To prevent excessive overheating of the system, which could potentially cause permanent damage, afailsafe mode which de-powers the electric pump is implemented.This causes a loss of power assist making it more difficult to steer the vehicle, especially at lower vehicle speeds.Once the failsafe is implemented the EPAS system will remain disabled until the ignition is turned off.However EPAS will be re-enabled if the operating temperature is reduced (i.e., within an acceptable range) on a subsequent drive cycle.On August 8, 2010 Mazda submitted a Part 573 defect information report initiating Safety Recall 10V-374 to remedy the subject vehicles.The report, which contains additional details on the remedy repair, is available at http://www-odi.nhtsa.dot.gov/recalls/.ODI notes that the affected population shown in that report includes approximately 8,000 vehicles Mazda repaired prior to initiating the recall.

While driving car turns on its own almost causing accident

NHTSA ID

11738335

Incident

May 11, 2026

The headlights on this car are dangerously dim. Like the turn signals overpower them levels of dim. I’ve replaced the bulbs, the battery, cleaned all the connections, replaced the alternator, nothing makes a difference.

NHTSA ID

11496818

Incident

Aug 1, 2022

THIS MODEL OF MAZDA STEERING WHEEL STOP ROTATING MOSTLY ON HIGHWAY. AT TIME IT BECOME TOO STIFF TO OVE FOR 5 TO 10 MINUTES AND THEN IT COMES BACK ON IT IS WORRYING ME AS IT MAY CAUSE AN UNVOIDABLE CRASH.

NHTSA ID

11447674

Incident

Nov 12, 2021

Intermittently, the doors will not unlock when inside the vehicle, effectively trapping the occupants inside. Additionally, the locks will fail to lock or lock with either the key or the remote fob. trapping occupants inside or prohibiting someone on the outside from getting in to retrieve children inside.

NHTSA ID

11434463

Incident

Sep 27, 2021

TL* THE CONTACT OWNS A 2009 MAZDA 5. THE CONTACT STATED THAT THE VEHICLE WOULD NOT START. ON ONE OCCASION, THE VEHICLE BROKE DOWN IN THE MIDDLE OF A STREET AND WAS TOWED TO THE CONTACT'S HOME. THE CONTACT HAD A MECHANIC INSPECT THE VEHICLE WHO STATED THAT THE FUEL PUMP COULD BE THE CAUSE OF THE FAILURE. THE DEALER AND MANUFACTURER WERE NOT CONTACTED. THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE FAILURE MILEAGE WAS 163,000.

NHTSA ID

11288857

Incident

Dec 1, 2019

Mileage

163,000 mi

TL* THE CONTACT OWNS A 2009 MAZDA 5. WHILE DRIVING 55 MPH, THE POWER STEERING MALFUNCTIONED AND THE STEERING VEERED TO THE LEFT. THE FAILURE ALMOST CAUSED A CRASH. IN ADDITION, THE ENTIRE INSTRUMENT PANEL ILLUMINATED. THE CONTACT HAD TO EXERT EXCESSIVE FORCE TO TURN THE STEERING WHEEL AND PULL THE VEHICLE OFF THE ROAD. WHEN THE VEHICLE WAS TURNED OFF AND RESTARTED, THE POWER STEERING RETURNED TO NORMAL AND THE CONTACT WAS ABLE TO DRIVE HOME. THE MANUFACTURER AND THE DEALER WERE NOT NOTIFIED. THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE FAILURE MILEAGE WAS 86,000.

NHTSA ID

11241238

Incident

Jan 2, 2019

Mileage

86,000 mi

CLIMATE CONTROL MALFUNCTIONING AND TURNING ON THE HEATER NOT AC

NHTSA ID

11228307

Incident

May 15, 2019

Mileage

108,000 mi

SLIDING PASSENGER DOOR WILL NOT LATCH. WILL OPEN WHILE DRIVING.

NHTSA ID

11165848

Incident

Dec 1, 2018

Mileage

104,000 mi

This SA supersedes the previously issued SA(s) listed below. The changes are noted in Red. SA-061/25 12/17/25 DESCRIPTION If you encounter any type of electrical concern (e.g, dead battery, engine no start, DTC(s) stored...), interview the customer before proceeding with normal MGSS diagnosis by asking if any aftermarket devices have been installed. Aftermarket devices may be the cause of the electrical concern. Below are a few examples of unusual electrical concerns caused by aftermarket devices. Examples: 1. Devices connected to the DLC-2 (battery discharge/DTC stored) 2. Devices plugged into the 12V outlet 3. GPS tracking device (engine no start/battery discharge) 4. Dash cam (DTC stored) 5. Non-certified USB cable (Apple Carplay™/ Android Auto™ will not connect) 6. Over-sized wheels/tires (incorrect GPS location) 7. DTC C0023:14 8. Decorative trim and/or cover on the START/STOP ENGINE button Example 1: Some electrical devices connected to the DLC-2 connector by insurance or mobile phone companies may cause: Battery discharge. The device may disrupt the CAN system battery saver mode. • IDS/MMDS will not communicate with the vehicle due to poor DLC-2 connection. The aftermarket device may cause DLC-2 female terminals to spread open.

This Service Alert supersedes the previously issued SA listed below: The changes are noted in Red. SA-011/24 02/12/24, 06/06/24, 07/29/24 DESCRIPTION Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner's manual. Services performed outside of Mazda's factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers. SCHEDULED MAINTENANCE Refer to the applicable Workshop Manual or Owner's Manual for vehicle -specific manufacturer scheduled maintenance. Workshop Manual - Refer to section 00-00 SCHEDULED MAINTENANCE. Owner's Manual - Refer to section 8 Maintenance and Care. b. Note: Please refer to the information below outlining the services not included in Mazda's Factory Scheduled Maintenance: IMPORTANT: Recommending fluid flushes when not necessary can lead to customer confusion and dissatisfaction. Fluid flushing for preventive maintenance purposes is strongly discouraged, unless otherwise specified in a published procedure (Owner’s Manual, Workshop Manual, Technical Service Bulletin, etc.).

If you encounter any type of electrical concern (e.g, dead battery, engine no start, DTC(s) stored...), interview the customer before proceeding with normal MGSS diagnosis by asking if any aftermarket devices have been installed. Aftermarket devices may be the cause of the electrical concern. Below are a few examples of unusual electrical concerns caused by aftermarket devices.

A musty/mildew type odor may come from the vents when the air conditioning (A/C) system is operating. It is most noticeable when the A/C is first turned ON. This odor is the result of mold growth in the A/C evaporator/cooling unit which is caused by condensation, dust, and pollen within the cooling unit. This condition is usually worse during high humidity conditions. “Mazda Air Cooling Coil Coating” is available to encapsulate the mold to reduce odors. If the product is properly applied, it can effectively reduce the musty/mildew odor for up to three years. NOTE: See parts information for Mazda Air Cooling Coil Coating and Kit part numbers.

Some vehicles may experience exterior trim heat damage such (melted, separating, etc.) when parked near a glass building or Low-E windows. This may be caused by the sun's reflection. If a structure's windows create enough of a curve, the concave glass can focus the sun's rays onto a small area and acting like magnifiying glass direct the sunbeams into a hot pinpoint of light. This magnifcation of the sun's rays can cause damage to vehicle trim (see examples). Additional information and exemplar images regarding this phenomenon can be found by performing a google search.

When replacing the SiriusXM satellite radio unit, a call must be made to inform SiriusXM of the existing Radio ID and the new/replacement SAT Radio ID as soon as possible to ensure the customer leaves the dealership with an active SAT radio.