2009 Toyota Avalon

The steering latch to adjust steering wheel unlocks while I’m driving causing my steering wheel to drop literally while I’m driving.

NHTSA ID

11688670

Incident

Dec 31, 1969

While driving my 2009 Toyota Avalon on a sunny day, I could not see clearly through my windshield due to the intense sunlight reflection from my dashboard. Upon searching the Internet, I see this is an ongoing issue with my car model. The manufacturer does not provide any remedy to address this issue and I feel very unsafe driving my car. Please help address this issue with the manufacturer.

NHTSA ID

11550355

Incident

Oct 16, 2023

When driving my 2009 Toyota Avalon my headlights sporadically go out. Mostly on the drivers side. I have replaced the headlight on 3 separate occasions with in the last 3 Years and each time it cost me $185.00 for labor and the headlight. I also got stopped by the POLICE for it! Now in 2023 the right head light goes on and off sporadically since March 2023. Again, I got stopped by the POLICE! Now it's JUNE of 2023 and both lights went out while driving home at night. We took it to a different repair shop and was FINALLY told that this has been a problem for the 2009 Toyota Avalon for a while as it was a manufacturing DEFECT. A head light ballast I think. Why should I pay to fix this as well as tickets from the POLICE for a manufacturing ERROR!!! Now I have to pay for 2 Ballasts and 2 headlights????.

NHTSA ID

11525878

Incident

Jun 1, 2023

The steering wheel telescoping lever is faulty in that it will loosen in its own causing the steering wheel to lunge forward toward the dash unexpectedly with little pressure while driving.

NHTSA ID

11479139

Incident

Aug 3, 2022

The contact owns a 2009 Toyota Avalon. The contact stated that the dashboard was cracking. The check engine warning light was illuminated. The vehicle was taken to the local dealer where it was diagnosed that the oil and plugs needed to be replaced. The vehicle was repaired. The contact stated that while at the dealer he was notified about an extended warranty on the dashboard by another customer. The manufacturer was notified and informed him that the warranty had expired. The contact was referred to NHTSA. The contact had not received notification for the extended warranty on the dashboard. The approximate failure mileage was 134,000.

NHTSA ID

11445651

Incident

Dec 15, 2021

Mileage

134,000 mi

DRIVER AND PASSENGER SIDE HEADLIGHTS SUDDENLY STOPPED WORKING. , DISCOVERED THAT BOTH LIGHT BULBS HAD SHATTERED INSIDE THE HEAD LAMP HOUSING. DEALER & TOYOTA USA CONFIRMS THAT TOYOTA HAS CHANGED THE HEADLIGHT HOUSING DESIGN THAT ACCOMODATES A DIFFERENT HIGH BEAM BULB THAT WILL NOT SHATTER. TOYOTA REFUSES TO REPLACE THE HOUSING EVEN THOUGH VEHICLE ONLY HAS 60,000 MILES ON IT. THIS IS A SERIOUS SAFETY ISSUE THAT NEEDS TO BE ELEVATED TO RECALL STATUS. TOYOTA USED, A NOW EXPIRED, EXTENDED WARRANTY TO AVOID THIS BEING A RECALL AS IT SHOULD BE. HOW MANY AFFECTED VEHICLES HAVE TO LOSE DAY TIME RUNNING LIGHTS AND HIGH BEAMS!

NHTSA ID

11430364

Incident

Aug 18, 2021

IT HAS A MELTING DASHBOARD WHICH IS ALSO SHINY. IT MAY CAUSE AN ACCIDENT AS IT DISTRACTS THE VISIBILITY.

NHTSA ID

11377610

Incident

Nov 23, 2020

Mileage

141,650 mi

THE MANUAL LOCK MECHANISM FOR TELESCOPING STEERING WHEEL WILL UNLOCK ITSELF WHEN CAR IS IN MOTION & SEEMS LIKE A SAFETY HAZARD!

NHTSA ID

11375395

Incident

Jul 12, 2019

Mileage

79,797 mi

Some 2005 – 2026 Toyota vehicles that have undergone water intrusion may exhibit a condition in which a musty odor is present. Follow the procedures in this bulletin to remediate the odor and address this condition. The purpose of this Service Bulletin is to provide general guidelines and procedures for odor remediation. This Service Bulletin provides a guide on how to prepare and treat the interior of the vehicle for odor remediation. Refer to the applicable model and model year Repair Manual and the EPA (Environmental Protection Agency) website for the most up-to-date safety and precautionary guidelines.

Acid rain results from rainwater or other airborne moisture that become acidic due to industrial chemical impurities in the atmosphere. If these acidic compounds settle on an exposed vehicle, especially the horizontal areas such as the hood, roof, and decklid, significant damage to the painted surfaces can occur. Acid rain damage can typically be identified on vehicles by the presence of stains on the paint surface that resemble hard water spots. Unlike water spots however, acid rain damage cannot be removed by regular washing procedures. Also, because acid rain can etch and soften the paint, normal buffing or polishing repair procedures should not be attempted. This can cause further damage and result in visible depressions in the paint surface. The following are the three major categories of acid rain damage: •Minor damage: requires only buffing to repair. •Moderate damage: usually requires neutralizing, color sanding, and buffing. •Severe damage: extending beyond 1/2 mil of clearcoat on a pearl, metallic, or solid color, requires neutralization, sanding, and repainting. In cases where acid rain damage is minor, neutralization and buffing with a liquid-type paint finessing product may provide an adequate repair. Only specially formulated products outlined in this bulletin should be used for that purpose. Unfortunately, other than minor damage, there is no simple method of determining the actual extent (depth) of acid penetration other than color sanding a representative affected area until there is no visible etching or depressions, followed by measuring the amount of paint removed with either a magnetic or digital-type film thickness gauge. The procedures in this bulletin are intended for use by qualified body/paint technicians and should not be attempted by inexperienced personnel. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. Perform frequent vehicle washing, as often as daily, during high heat and humidity periods to minimize the potential for paint damage due to acid rain exposure. This is especially important in geographical areas known for high frequency and concentration of acid rain and industrial fallout.

The condition known as acid rain is caused by airborne chemicals or particles in the atmosphere, which mix with rainwater, nighttime dew, or high humidity to form acidic compounds. If these contaminants settle and remain on a painted vehicle surface, especially the horizonal areas of the hood, roof, and decklid, significant damage can occur. This damage is the result of actual etching of the paint and appears as pitting or water spots. As acid rain droplets on the vehicle surface evaporate, the concentration strength of the acid increases, causing deeper and more rapid damage. This evaporation and corrosive action also occur more rapidly on dark colored cars as direct sun heat increases. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. In areas known for high frequency and/or concentration of acid rain, frequent vehicle washing during high heat or humidity periods will minimize the potential for paint damage caused by acid rain. It is further recommended that either reverse osmosis or deionized water be used to prevent water spotting.

To prevent brake rotor rust from forming during transportation and storage, wheel film will be used instead of a cardboard type of anti-rust cover. The purpose of the wheel film is to shield the disc brake rotor from weather elements and initial rust before the vehicle is delivered to the customer. Consequently, the film should remain on the wheel for as long as possible.

Toyota vehicles are currently protected with RapgardTM protective film designed to protect the horizontal painted surfaces. This material protects from acid rain, environmental fallout, and rail contamination. Follow the Removal Procedure in this bulletin to remove the RapgardTM protective film within 90 days from initial application.

Vehicles may occasionally be subjected to contamination by airborne iron particles shed from railroad tracks, train wheels, exposure to heavy machinery facilities, grinding, welding, etc. This type of contamination can be identified by the presence of small, red or brown particles on the paint surface. These particles are often difficult to see on dark color paints but can be easily felt when brushing a hand across horizontal body surfaces such as the hood, roof, or deck lid. Follow the Repair Procedure in this bulletin to clean vehicles that may have been subjected to contamination by airborne iron particles such as rail dust during rail transportation or extended storage near industrial areas.