2000 Chevrolet S10

GENERAL MOTORS IS CONDUCTING A SPECIAL POLICY PROGRAM FOR 903,464 OWNERS OF 2000 - 2003 MODEL S/T VEHICLES THROUGH WHICH OWNERS MAY, AT THEIR OPTION, EITHER (1) PERIODICALLY INSPECT THE TAILGATE SUPPORT CABLES INSTALLED IN THEIR VEHICLE AND HAVE THE CABLES REPLACED IF THE CABLE COATING EXHIBITS ANY INDICATIONS OF DAMAGE OR DETERIORATION OR (2) REQUEST THAT THE TAILGATE SUPPORT CABLES BE REPLACED FREE OF CHARGE. GM WILL HONOR ALL REQUESTS BY OWNERS WHO OPT FOR REPLACEMENT WITHOUT QUESTION REGARDLESS OF THE CONDITION OR APPEARANCE OF THE CABLES. GM HAS AGREED TO MAIL REMINDER NOTIFICATIONS TO OWNERS EVERY TWO YEARS UNTIL THE TAILGATE SUPPORT CABLES HAVE BEEN REPLACED OR UNTIL THE VEHICLE IS 12 YEARS OLD.ODI'S INVESTIGATION INDICATES THAT A SIGNIFICANT MAJORITY OF THE REPORTED COMPLAINTS (87%) AND INJURIES (94%) HAVE OCCURRED IN MY 2000 - 2003 S/T VEHICLES.

ODI IS UPGRADING RQ04-012 AND OPENING AN EA TO INVESTIGATE THE TAILGATE SUPPORT CABLES INSTALLED IN 1998 - 2004 MODEL YEAR SONOMA AND S10 MODEL VEHICLES.GENERAL MOTORS IS CONDUCTING RECALL CAMPAIGN 04V-129 TO REPLACE THE TAILGATE SUPPORT CABLES ORIGINALLY INSTALLED IN CERTAIN MODEL YEAR 2000-2004 SIERRAS AND SILVERADOS AND CERTAIN MODEL YEAR 2002-2004 AVALANCHES AND ESCALADE EXTS (C/K MODELS).GENERAL MOTORS HAS ADVISED ODITHAT THE TAILGATE SUPPORT CABLES INSTALLED IN THE SUBJECT VEHICLES WERE FABRICATED USING IDENTICAL OR SIMILAR SHEATHING MATERIAL AS THE RECALLED VEHICLES.HOWEVER,GENERAL MOTORS HAS ADVISED ODI THAT SONOMA AND S-10 VEHICLES DIFFER FROM C/K MODELS IN SEVERAL WAYS: THE VEHICLE HEIGHT IS LOWER; THE TAILGATE DISPLACEMENT (DROP) WHEN NOT SUPPORTED BY THE CABLES IS SMALLER AND THE TAILGATE COMES TO REST AT A LESS SEVERE TIP ANGLE WHEN NOT SUPPORTED BY THE CABLES; THE TAILGATE MASS IS SMALLER; AND THE SIZE, PAYLOAD, AND USAGE CHARACTERISTCIS ARE LESS DEMANDING THAN C/K MODEL VEHICLES.GM ALSO STATED THAT SONOMA AND S-10 WARRANTY CLAIM INFORMATION INDICATES A LOWER CLAIM COUNT AND A LOWER CLAIM RATE THAN RECALLED C/K MODELS.NOTWITHSTANDING THE ABOVE INFORMATION, ODI HAS RECEIVED AN ADDITIONAL 73 NON-INJURY COMPLAINTS AND 10 INJURY COMPLAINTS ON THE SUBJECT VEHICLES DURING RQ04-012 (SINCE NOVEMBER 2004 TO DATE), WHICH JUSTIFIES OPENING AN ENGINEERING ANALYSIS TO FURTHER INVESTIGATE THIS ISSUE.

ODI OPENED PE02-066 TO EVALUATE THE SCOPE AND CONSEQUENCE OF ENGINE POWER-LOSS DUE TO FUEL STARVATION INDUCED BY IN-TANK MODULAR FUEL PUMP STRAINER RESTRICTION.THE SUBJECT PUMPS USE AN EXTERNAL ?SOCK? STRAINER TO FILTER FUEL FLOWING TO THE PUMP INLET.THIS FILTER CAN SOMETIMES BECOME CLOGGED, RESULTING IN A REDUCED FLOW OF FUEL TO THE ENGINE.GM HAS SUBSEQUENTLY MODIFIED THE STRAINERS TO REDUCE THIS RESTRICTION.ANALYSIS OF THE ODI COMPLAINT DATABASE SHOWS THAT DESPITE THESE RESTRICTIONS, THE SUBJECT VEHICLES STALL AT A RATE THAT IS COMPARABLE TO THOSE OF MANY PEER VEHICLES.ADDITIONALLY, NONE OF THE RELEVANT WARRANTY REPAIR RATES EXCEED 1% AT 36 MONTHS OF EXPOSURE.ONE RELATED CRASH INVOLVES A STALLED VEHICLE THAT WAS REAR-ENDED ON THE ROADWAY, WHILE THE REMAINDER INVOLVED MINOR COLLISIONS OR SCRAPES.THE SOLE INJURY CONSISTED OF BRUISING FROM A LOW SPEED FRONTAL CRASH. GIVEN THESE CIRCUMSTANCES, FURTHER EXPENDITURE OF AGENCY RESOURCES IS NOT JUSTIFIED IN THIS MATTER.THE PRELIMINARY EVALUATION IS THEREFORE CLOSED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTS.THE AGENCY WILL TAKE FURTHER ACTION IN THE FUTURE IF WARRANTED.

My dad purchased my truck from the church secretary where he attended in March of 2015. At the time of purchase it only had 66,000 miles on it. The secretary’s father owned it and used it from new until 6 months before we purchased it and only used it to help feed his cows. 1. Window washer motor circuit 2. Seatbelt need’s stitched 3. The overload sticker is wrong Came in after we purchased the truck but my dad was sick and he passed away 3/8/2016 Coated brake rotor & hub assembly (86757CR)x2 Tie rod end (NCD 2693017)x2 Ball joint front lower (NCD 2601130)x2 Tie rod end control arm front left (NCD 2605330) Tie rod end control arm and ball joint front right upper (NCP 2605329) Tie rod adjusting sleeve front (NCD 2691109)x2 Idler arm assembly (NCD 2683654) Tie rod End outer (NCD 2683267)x2 Steering center link (NCD 2721591) TOO MUCH NOISE AND WHEN MAKING A PARKING LOT TURN IT FELT AND SOUNDED LIKE I WAS GONNA LOSE MY WHOLE FRONT END ON THE GROUND.

NHTSA ID

11589037

Incident

Oct 18, 2016

The driver window power motor has been malfunctioning and the power steering has been not fixed in the sense of not having a functioning power steering pump

NHTSA ID

11432225

Incident

Sep 8, 2021

DMV LAS VEGAS HAS SALVAGED MY TRUCK IN CALIFORNIA. MY TRUCK WAS BOUGHT 3 PLUS YEARS AGO. I HAVE A CLEAN TITLE. NEVADA HAS REFUSED TO RETAG MY TRUCK AND SAID IT WAS UNSAFE TO DRIVE. THE TRUTH IS THEY ID THEFT ME AND MADE THE ERROR ON MY TRUCK THAT IS IN GREAT SHAPE IT DRIVES AND HANDLES GREAT. I HAVE CHANGED SEVERAL PARTS. THIS IS JUST MAINTENCE AND I HAVE INSPPECTED IT AND FIND IT TO BE FRAUD PER CERTIAN PEOPLE IN DMV BUT THE ERROR IS IN ONE PERSONS HANDS TO BLOCK ME FROM DRIVING IT. MY FRIENDS WONDER HOW MUCH MORE I CAN TAKE FROM ALL THE FRAUD I HAVE DEALTH WITH AND NOW ITS MY TRUCK

NHTSA ID

11414686

Incident

Mar 31, 2021

TL* THE CONTACT OWNS A 2000 CHEVROLET S10. WHILE DRIVING 26 MPH AROUND AN S CURVE, THE BRAKES PEDAL WAS APPLIED, BUT SEIZED. THE CONTACT LOST CONTROL OF THE VEHICLE AND CRASHED INTO AN EMBANKMENT AND CREEK. THE AIR BAGS DID NOT DEPLOY. THE DRIVER WAS NOT WEARING A SEAT BELT AND SUSTAINED NECK, NOSE, AND EYE INJURIES THAT REQUIRED MEDICAL ATTENTION. A POLICE REPORT WAS FILED. THE VEHICLE WAS TOWED TO THE CONTACT'S RESIDENCE. THE MANUFACTURER AND DEALER WERE NOT CONTACTED. THE CAUSE OF THE FAILURES WAS NOT DETERMINED. THE FAILURE MILEAGE WAS 230,000.

NHTSA ID

11271790

Incident

Oct 15, 2019

Mileage

230,000 mi

THE TOP HINGE OF THE DRIVERSIDE DOOR IS WORN ALLOWING AIR AND RAIN TO ENTER THE CABIN. THE SMALL PLASTIC SLEEVE IN THE TOP HINGE APPEARS TO BE BROKEN OR WORN EXCESSIVELY.

NHTSA ID

11164133

Incident

Dec 10, 2018

THE DRIVER'S SEAT HAS NOT BEEN WORKING PROPERLY FOR SEVERAL MONTHS. THE SEAT WILL NOT STAY LOCKED IN PLACE AND THIS HAS CREATED A DANGEROUS SITUATION, ESPECIALLY IN INTERSECTIONS, WHEN THE TRUCK HAS BEEN IN MOTION. NOW THAT THIS HAS HAPPENED SEVERAL TIMES, I'VE BEEN ESPECIALLY CAREFUL & PREPARED TO MOVE THE SEAT BACK FORWARD SO I CAN AGAIN REACH THE PEDALS. MY SOLUTION FOR THE TIME BEING - PLACING A WOODEN 2X4 PIECE BEHIND THE SEAT SO IT WILL STAY FIXED. IT'S WORKING, BUT IT IS VERY INCONVENIENT GETTING INTO OR OUT OF THE SEAT. WILL TRY TO REPAIR OR TAKE TO A SHOP IF A RECALL IS NOT MANDATED.

NHTSA ID

11102222

Incident

Mar 1, 2018

Mileage

108,000 mi

TL* THE CONTACT OWNS A 2000 CHEVROLET S10. WHILE DRIVING VARIOUS SPEEDS, THE BRAKE WARNING INDICATOR ILLUMINATED. ALSO, THE VEHICLE FAILED TO STOP WHEN THE BRAKE PEDAL WAS DEPRESSED TO THE FLOORBOARD. THE FAILURE RECURRED. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC WHERE IT WAS DIAGNOSED THAT THERE WAS OIL LEAKING BETWEEN THE BRAKE HOSE AND FRONT PASSENGER WHEEL. THE TECHNICIAN REPLACED THE WASHER FOR THE BRAKE HOSE, BUT THE FAILURE RECURRED. THE VIN WAS NOT INCLUDED IN NHTSA CAMPAIGN NUMBER: 99V220000 (SERVICE BRAKES, HYDRAULIC). THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 131,000.

NHTSA ID

10960063

Incident

Mar 6, 2017

Mileage

131,000 mi

CENTER-VEHICLE MOUNTED REAR BRAKE LIGHT MELTED ITS PLASTIC HOUSING WHICH MELTED THE WIRING AND MOUNTS USED TO POWER THE TWO LIGHTBULBS IN THE CENTER BRAKE LIGHT, RESULTING IN NO FUNCTIONING CENTER BRAKE LIGHT. THIS ALSO MADE THE INTERIOR LIGHT FALL OUT OF THE ROOF AS IT IS ATTACHED TO THE SAME PLASTIC HOUSING. ONLY APPARENT FIX IS TO REPLACE THE ENTIRE OLD MELTED CENTER BRAKE LIGHT HOUSING WITH A NEW ONE. OCCURRED UNDER NORMAL USE WITH MANUFACTURER RECOMMENDED LIGHT BULBS IN USE.

NHTSA ID

10957191

Incident

Feb 1, 2017

Mileage

10,500 mi

This Preliminary Information communicates to the dealer the process for downloading or updating operating software for the Tire Pressure Monitor, Active Fuel Injector tester, multi media tester, PICO Scope, GR8 starting/charging tester  and Vehicle Data Recorder tools, giving website address and step by step instructions to complete the update.

This Preliminary Information communication provides information to the technician about vehicles that the Heater-Vent-Air Conditioning blows warm air. Before calling General Motors Technical Assistance Center technician will need to have high and low pressures, outside temperature, humidity, and vent temperature.

This Preliminary Information communication provides information to the technician about vehicles that the Heater-Vent-Air Conditioning blows warm air. Before calling General Motors Technical Assistance Center technician will need to have high and low pressures, outside temperature, humidity, and vent temperature.

Vehicle Wide Programming (VWP) is a new process to update software on GM Vehicles. It provides the ability via a single selection within Techline Connect to first identify which modules need updating and then proceed to updating affected modules (with some exceptions). The updating of modules is completed in parallel instead of the technician needing to update one module at a time. This allows a more streamlined approach for dealers and customers.

GM is receiving damaged (cracked or broken) transmission cores returned to the reman facilities. The damage is being caused either in the removal process by the technician, or inadequate packaging or shipping. This bulletin advises the dealers to be more careful not to damage the transmissions during removal and to package the core properly for return.

This service bulletin advises of a new fuel injection cleaner kit used for decarbonizing the intake valves to correct conditions of rough idle, Crank no start, extended crank or misfire, MIL with DTCs, and explains how Top Tier fuels should be used to reduce carbon build-up.