2014 Mazda CX-5

The car's electrical system doesn't fully turn off after being put in park and turning the ignition off. The electrical system stays on, despite the engine and ignition turned off. It's a BIG problem that I've seen a lot of other people report. And yet Mazda refuses to address the issue.

NHTSA ID

11704343

Incident

Nov 10, 2023

I was driving down the road and my right side curtain airbag deployed. I did let my insurance company know but was told that they couldn’t do anything for me since it was not an accident. I called the local Mazda dealership and they told me that they could inspect the vehicle but it would not be on them. That it could have been a rat that chewed on something to cause it to deploy because I was not the first owner of the vehicle. There was no other damage other than the airbag and where it came through on the side.

NHTSA ID

11670101

Incident

Sep 12, 2023

The contact owns a 2014 Mazda CX-5. The contact stated that while her husband was driving at a slow speed and attempting to parallel park, there was an abnormal sound coming from the engine before the steering wheel seized. No warning light was illuminated. The contact's husband exited the vehicle to inspect the vehicle, and another person stopped to assist and became aware that the ball joint had detached. The vehicle was towed to an independent mechanic, where it was diagnosed and determined that the steering knuckle had separated from the strut assembly, causing the failure. The vehicle was not repaired. The dealer was contacted and stated that the vehicle was not under warranty. The manufacturer was notified of the failure, but no assistance was provided. The contact related the failure to NHTSA Campaign Number: 16V203000 (STEERING); however, the VIN was not included. The failure mileage was approximately 135,000.

NHTSA ID

11662815

Incident

May 4, 2025

Mileage

135,000 mi

Odometer Fraud. The contact purchased a 2014 Mazda CX-5. The contact stated that while attempting to register the vehicle, it was discovered that there was a mileage discrepancy. The vehicle was a private sale. At the time of purchase, the vehicle mileage was 86,000, and at the time of registration, it was discovered that the mileage was 190,000.

NHTSA ID

11660608

Incident

May 13, 2025

Mileage

190,000 mi

CAR ACCESSORIES WILL NOT SHUT OFF WHEN I PUT VEHICLE IN PARK. THIS IS DANGEROUS DUE TO CAUSING THE BATTERY TO COMPLETELY DRAIN LEAVING ME STRANDED.

NHTSA ID

11633341

Incident

Oct 11, 2024

Auxiliary power will not turn off when vehicle is turned off. Radio , lights interior power , etc….. car turns off when button is pressed but interior power does not .

NHTSA ID

11595830

Incident

Jun 12, 2024

I was waiting at a traffic signal to make a left turn, with my foot on the brake. The car accelerated aggressively, with no warning, like the pedal was pushed to the floor. I stood on the brake and shoved the shifter into park - coming to a stop in the middle of the intersection, Fortunately my wheels were pointed straight and the car did not race into oncoming traffic. My [XXX] father was in the car with me. Thankfully, my grandchildren were NOT in the car. You could smell the gas and brakes. It was NOT driver foot placement, nor was it floor mats. Vehicle has ~ 75K miles, and I am terrified of this happening again. I had driven this car regularly in rush hour stop & go traffic for years with no event like this ever before. Apparently sudden unintended vehicle acceleration is a recognized problem. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11594255

Incident

May 31, 2024

Car fails to shut off completely. The motor stops, but the electronics (dash, radio, etc.) and things like the A/C still are on. Searching forums shows it is a faulty gear shift sensor that detects that the car is in park.

NHTSA ID

11593296

Incident

Jun 9, 2024

This SA supersedes the previously issued SA(s) listed below. The changes are noted in Red. SA-061/25 12/17/25 DESCRIPTION If you encounter any type of electrical concern (e.g, dead battery, engine no start, DTC(s) stored...), interview the customer before proceeding with normal MGSS diagnosis by asking if any aftermarket devices have been installed. Aftermarket devices may be the cause of the electrical concern. Below are a few examples of unusual electrical concerns caused by aftermarket devices. Examples: 1. Devices connected to the DLC-2 (battery discharge/DTC stored) 2. Devices plugged into the 12V outlet 3. GPS tracking device (engine no start/battery discharge) 4. Dash cam (DTC stored) 5. Non-certified USB cable (Apple Carplay™/ Android Auto™ will not connect) 6. Over-sized wheels/tires (incorrect GPS location) 7. DTC C0023:14 8. Decorative trim and/or cover on the START/STOP ENGINE button Example 1: Some electrical devices connected to the DLC-2 connector by insurance or mobile phone companies may cause: Battery discharge. The device may disrupt the CAN system battery saver mode. • IDS/MMDS will not communicate with the vehicle due to poor DLC-2 connection. The aftermarket device may cause DLC-2 female terminals to spread open.

This bulletin supersedes the previously issued bulletin(s) listed below. The changes are noted in Red. 01-008/23 06/05/23 Some vehicles may exhibit rattling noises from the engine compartment and oil leakage from the drive belt auto tensioner. This may be caused by insufficient sealing at the drive belt auto tensioner damper when the auto tensioner fully operates under both high ambient temperature and high load conditions. To eliminate this concern, the shape of the drive belt auto tensioner damper has been changed. REPAIR PROCEDURE If the tensioner is found to be "No Good" after completing the Drive Belt Auto Tensioner Inspection, replace it with a modified part according to the instructions on MGSS online:

DESCRIPTION Some vehicles may require the replacement of a damaged VIN plate or vehicle certification label. To obtain a replacement VIN plate (bulkhead-mounted and visible through the lower-left area of the windshield), contact DAG (Dealer Assistance Group) using VIN Plate Request Form available on One Mazda. To obtain a replacement vehicle certification label (located on the B􀀀pillar or front door), contact your assigned DSM (District Service Manager) to place the order. If DSM contact information is not available, refer to the Dealer & Field Contact Directory.

This Service Alert supersedes the previously issued SA listed below: The changes are noted in Red. SA-011/24 02/12/24, 06/06/24, 07/29/24 DESCRIPTION Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner's manual. Services performed outside of Mazda's factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers. SCHEDULED MAINTENANCE Refer to the applicable Workshop Manual or Owner's Manual for vehicle -specific manufacturer scheduled maintenance. Workshop Manual - Refer to section 00-00 SCHEDULED MAINTENANCE. Owner's Manual - Refer to section 8 Maintenance and Care. b. Note: Please refer to the information below outlining the services not included in Mazda's Factory Scheduled Maintenance: IMPORTANT: Recommending fluid flushes when not necessary can lead to customer confusion and dissatisfaction. Fluid flushing for preventive maintenance purposes is strongly discouraged, unless otherwise specified in a published procedure (Owner’s Manual, Workshop Manual, Technical Service Bulletin, etc.).

This Service Alert supersedes the previously issued M-Tip(s) listed below. The changes are noted in Red text. MT-003/22 03/02/22 DESCRIPTION Some customers may complain about a tapping or knocking noise coming from the rear seat after fuel fill. The concern will likely occur if the fuel tank is overfilled (more fuel is added after the fuel pump nozzle shuts off automatically) or filled up normally in high ambient temperatures and the fuel expands. No repair is needed. Explain to the customer not to continue filling after nozzle shut off.

This Service Alert supersedes the previously issued SAs and bulletin(s) listed below: The changes are noted below in red. SA-010/23 02/09/23 DESCRIPTION Some customers may experience one or more electrical malfunctions after a vehicle body repair. A newly painted fender stay (2) may be causing a poor front harness (1) ground connection. The front fender stay (2) newly painted surface at ground point (3), where attachment bolt (4) is seated, may create a poor front harness ground connection. NOTE: DO NOT paint ground point (3) attachment bolt (4) is seated. NEWLY INSTALLED FRONT FENDER STAY NOTE: CAUTION: If the bolt (4) contact area (3) is painted when the front fender stay (2) is newly replaced, it could cause a malfunction in the PCM. Before painting a newly replaced part, protect the bolt (4) contact area (3) with masking tape (5) as shown in the figure.