2014 Mazda Mazda2

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

I have taken my car to two separate Mazda dealerships in 2019 and two separate non-dealership mechanics to address the same issue with a vibrating coming from the front driver when driving at lower speeds. It was not a constant noise until recently and saw there was a recall for my vehicle in May 2016. Mazda however says that my VIN does not qualify even though the build date range does show its covered. The problem at first was noted by the Kent Mazda dealership in 2019 but said the vehicle's small framing could cause this. This vibrating has become more clear and causing my vehicle to shake violently when steering. It has made me very fearful as each mechanic I take it to cannot find the source of the issue and overlook it. Mazda Corporate has not been helpful and overlooks the safety as it is something I've brought up to them. The original recall is below: [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11553002

Incident

Oct 29, 2023

Tire size: P 185 / 55 R 15 I believe there is a manufacturing defect with the Firestone Firehawk tires. The tires are prematurely cracking, these tires are supposed to have a 50,000 mile limited warranty. I replaced all four tires on 6/18/2022 and today (7/15/2023) I noticed there was deep cracking through the treads and into the sidewall. I currently have the tires and it is available for inspection upon request. I believe that cracked tires are a safety issue that could put myself and other cars at risk. The Firestone store mentioned the Firehawk tires were discontinued for the car. That cracking was a known issue on these tires and they refused to send the tires in for a warranty replacement. Tire Identification information: Front driver side tire: DOT RB8X FH1 4320 Front passenger side tire: DOT RB8X FH1 3421 Both rear tires: DOT RB8X FH1 4521

NHTSA ID

11532487

Incident

Jul 15, 2023

I bought this 2014 Mazda 2 Sport HB on Thursday January 26, 2023. Upon driving it home, this vehicle with only 41,280 miles on it, shook, vibrating , hearing a very loud popping clicking sounds. Like body metal clanging. It was hard to see. I don’t know if the low beams were set wrong or what but visibility wasn’t good with the low beams at all. I told him that the air conditioner made a horrible loud noises when cranked on high. I asked to take it to a mechanic and I was assured that their mechanics looked it over thoroughly. It has so much wrong with it. I was ripped off. Over $ 13,000 today. The car is in bad shape. It had one wreck I found out. This car looks ok, but it’s the worst car I have ever driven. My short instructed test drive wasn’t long enough to tell everything, but by the time I got home I knew that I was sold a lemon. Perhaps they didn’t know, but come on… This car is junk. It needs junked. This is the truth. I don’t believe it should be on the highway or resold again. Especially not 11,500 that turned into 13,000. I don’t have money for gas to be trying to fix garbage . Why would it have 2 owners and be a 2014 and only have 41,280 miles on it. They saw me coming and I explained that I can’t be ripped off. They didn’t care. I only drove it home and I know it’s really unsafe and not road worthy at all. Very difficult to steer compared to any other vehicle I have ever driven. It scares me truthfully.

NHTSA ID

11503910

Incident

Jan 26, 2023

The steering was making loud knocking noises at low-speed turns. When looked up Mazda2 issues, found that there was a recall for Steering, Recall no. 16V203000, dated 2016-04-10, states: If the steering knuckle separates from the strut assembly, it can cause a loss of steering control, increasing the risk of a crash. When the dealership looked up my VIN, it was not a serial number listed under the recall list. However, it had the same issues as the recall. These issues were listed as "requires immediate attention." The Steering rack and pinion, and also the front struts with bearing mounts have all been replaced by the dealership and an alignment was performed. I had to pay for this safety issue out of pocket because my VIN was not listed under the recall list. I would like to report this VIN under the recall list and request a refund for the work performed.

NHTSA ID

11432440

Incident

Jul 1, 2021

I WAS TURNING LEFT ON A PROTECTED GREEN ARROW WHEN A TRUCK ON THE LEFT LANE SPED UP AND I NOTICED T MERGED AND I WOULD GET HIT I TRIED TO GO OFF TO THE SIDE OF THE ROAD BUT THE STEERING WHEEL WAS STIFF AND WHEN I PRESSED ON THE GAS IT DID NOT MOVE THEN IT JERKED ME FORWARD.

NHTSA ID

11340631

Incident

May 23, 2020

Mileage

640,000 mi

TL* THE CONTACT OWNED A 2014 MAZDA 2. WHILE DRIVING AT AN UNKNOWN SPEED IN REVERSE, THE CONTACT STRUCK AN EMBANKMENT AND THE VEHICLE FLIPPED OVER. THE AIR BAGS DID NOT DEPLOY. THE CONTACT SUSTAINED A CHEST INJURY THAT REQUIRED MEDICAL ATTENTION. A POLICE REPORT WAS FILED. THE VEHICLE WAS TOWED TO A TOW YARD. THE VEHICLE WAS NOT TAKEN TO A DEALER TO BE DIAGNOSED OR REPAIRED AS THE INSURANCE COMPANY DEEMED THE VEHICLE A TOTAL LOSS. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE FAILURE MILEAGE WAS APPROXIMATELY 9,700. THE VIN WAS NOT AVAILABLE.

NHTSA ID

11162948

Incident

Aug 12, 2017

Mileage

9,700 mi

2014 MAZDA 2. CONSUMER WRITES IN REGARDS TO VEHICLE STEERING SYSTEM ISSUES. *SMD THE CONSUMER STATED THE RIGHT AXLE BROKE WHICH CAUSED HIM TO LOOSE CONTROL OF THE VEHICLE. CONSEQUENTLY, HE HIT ANOTHER VEHICLE. THE VEHICLE WAS TOTALED. *JB

NHTSA ID

10763630

Incident

Oct 1, 2015

THERE WAS/IS NO INFORMATION ON THE DOOR OR IN THE OWNERS MANUAL TO INDICATE TIRE PRESSURE FOR THIS VEHICLE. HAD TO OBTAIN INFORMATION FROM THE DEALER.

NHTSA ID

10748876

Incident

Jan 1, 2015

This SA supersedes the previously issued SA(s) listed below. The changes are noted in Red. SA-061/25 12/17/25 DESCRIPTION If you encounter any type of electrical concern (e.g, dead battery, engine no start, DTC(s) stored...), interview the customer before proceeding with normal MGSS diagnosis by asking if any aftermarket devices have been installed. Aftermarket devices may be the cause of the electrical concern. Below are a few examples of unusual electrical concerns caused by aftermarket devices. Examples: 1. Devices connected to the DLC-2 (battery discharge/DTC stored) 2. Devices plugged into the 12V outlet 3. GPS tracking device (engine no start/battery discharge) 4. Dash cam (DTC stored) 5. Non-certified USB cable (Apple Carplay™/ Android Auto™ will not connect) 6. Over-sized wheels/tires (incorrect GPS location) 7. DTC C0023:14 8. Decorative trim and/or cover on the START/STOP ENGINE button Example 1: Some electrical devices connected to the DLC-2 connector by insurance or mobile phone companies may cause: Battery discharge. The device may disrupt the CAN system battery saver mode. • IDS/MMDS will not communicate with the vehicle due to poor DLC-2 connection. The aftermarket device may cause DLC-2 female terminals to spread open.

This Service Alert supersedes the previously issued SA listed below: The changes are noted in Red. SA-011/24 02/12/24, 06/06/24, 07/29/24 DESCRIPTION Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner's manual. Services performed outside of Mazda's factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers. SCHEDULED MAINTENANCE Refer to the applicable Workshop Manual or Owner's Manual for vehicle -specific manufacturer scheduled maintenance. Workshop Manual - Refer to section 00-00 SCHEDULED MAINTENANCE. Owner's Manual - Refer to section 8 Maintenance and Care. b. Note: Please refer to the information below outlining the services not included in Mazda's Factory Scheduled Maintenance: IMPORTANT: Recommending fluid flushes when not necessary can lead to customer confusion and dissatisfaction. Fluid flushing for preventive maintenance purposes is strongly discouraged, unless otherwise specified in a published procedure (Owner’s Manual, Workshop Manual, Technical Service Bulletin, etc.).

If you encounter any type of electrical concern (e.g, dead battery, engine no start, DTC(s) stored...), interview the customer before proceeding with normal MGSS diagnosis by asking if any aftermarket devices have been installed. Aftermarket devices may be the cause of the electrical concern. Below are a few examples of unusual electrical concerns caused by aftermarket devices.

A musty/mildew type odor may come from the vents when the air conditioning (A/C) system is operating. It is most noticeable when the A/C is first turned ON. This odor is the result of mold growth in the A/C evaporator/cooling unit which is caused by condensation, dust, and pollen within the cooling unit. This condition is usually worse during high humidity conditions. “Mazda Air Cooling Coil Coating” is available to encapsulate the mold to reduce odors. If the product is properly applied, it can effectively reduce the musty/mildew odor for up to three years. NOTE: See parts information for Mazda Air Cooling Coil Coating and Kit part numbers.

Some vehicles may experience exterior trim heat damage such (melted, separating, etc.) when parked near a glass building or Low-E windows. This may be caused by the sun's reflection. If a structure's windows create enough of a curve, the concave glass can focus the sun's rays onto a small area and acting like magnifiying glass direct the sunbeams into a hot pinpoint of light. This magnifcation of the sun's rays can cause damage to vehicle trim (see examples). Additional information and exemplar images regarding this phenomenon can be found by performing a google search.

Some customers may complain about a noisy HVAC blower motor or odor after a cabin air filter replacement. Foreign debris on the blower motor after servicing the cabin air filter may be the cause. During the removal of the cabin air filter, foreign debris (leaves, dust, dirt....ect.) may fall on the blower motor causing a fluttering type noise or odor.