2014 Ford Econoline

By letter dated June 10, 2019, Ford Motor Company notified the Office of Defects Investigation (ODI) of a safety defect that may exist in certain model year (MY) 2009 through 2016 Ford Econoline vehicles equipped with a 5R110W transmission. Following the receipt of consumer complaints alleging transmission failures in vehicles built with a 5R110W transmission, NHTSA opened this investigation to assess the manufacturer's data including warranty claims, field reports, design changes, etc.Vehicles equipped with a 5R110W transmission contain a capacitive discharge weld within a coast clutch component in the transmission. A substandard weld may fatigue and fail, causing an elevated rate of loss of motive power in subject vehicle applications. Reports indicate that most of the weld failures occur when the torque is highest, which is when the driver attempts to accelerate from a stop.Analysis of the data provided by Ford Motor Company found that the risk of a transmission failure is very high in vehicles equipped with the combination of a W-MOD 5.4L SOHC EFI NA V8 G-NP engine and a 5R110W transmission. This vehicle population mainly consists of school buses and ambulances. A loss of mobility in school bus applications may result in the transfer of children when the vehicle is immobilized in a roadway, and a loss of vehicle mobility in ambulance applications may result in the delay of patient treatment.In response to this investigation, Ford Motor Company agreed to conduct recall 19V-432. Owners will be notified by mail and instructed to take their vehicle to a Ford or Lincoln dealer to have the coast clutch cylinder replaced and to replace the single-engaging coast one-way clutch with a dual-engaging one-way clutch. With recall action 19V-432 taken by Ford Motor Company this investigation is closed. Further use of agency resources does not appear to be warranted.The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist on other model or MY vehicles outside of the recall scope. The agency reserves the right to take further action if warranted by the circumstances.

SSM 48619 - Various Vehicles - Perimeter Alarm Armed And Original Vehicle Keys Cannot Be Accessed to Enter Vehicle - CAN Protection Strategy Some 2013-2016 Model Year Vehicles may exhibit a concern in which the Perimeter Alarm is active and the original keys cannot be accessed to disable the perimeter alarm. This concern would most often occur when a customer loses keys and the dealership is attempting to program new keys to the vehicle. The Workshop Manual (WSM), Section 419-01A Perimeter Anti-Theft Alarm - System Operation and Component Description has been updated to inform of the Controller Area Network (CAN) Protection Strategy. Follow the procedure outlined to prevent replacement of the Body Control Module (BCM) on CAN Protection Strategy equipped vehicles when original keys are lost and perimeter alarm is active. Refer to the WSM for further detail on the CAN Protection Strategy. Lost keys and replacement of BCM for lost keys is non-warrantable.

In the affected vehicles, the single-engaging coast one-way clutch (OWC) inside the transmission may experience a weld concern. If this weld fails, it can affect the ability of the transmission to transmit torque. Loss of vehicle mobility in this application may result in the need to transfer passengers if the vehicle is immobilized.