2023 Ford F-450 Sd

Notable brake application pressure without brake light illumination. See attached file for details.

NHTSA ID

11701774

Incident

Nov 26, 2025

Vehicle was being driven by a driver service to be delivered to the home garage after production was completed at the manufacturer. During transit, the operator reported that the low fuel pressure warning light came on immediately followed by flames in the engine compartment.

NHTSA ID

11661929

Incident

May 13, 2025

I was driving the truck and applied the brakes to slow down for a turn, the anti-lock brake system activated and I lost the power steering and power brakes. There is steering fluid all over the engine so apparently either a line broke or the reservoir broke. This truck has the hydro boost brake system which is why I lost the steering and the brakes.

NHTSA ID

11622435

Incident

Oct 28, 2024

Vehicle does not remember its previous settings: The following features may or may not be on, even if you have actively went through and turned them off or on. Local dealership has had this truck over 4 times and for days at a time. Nothing has been resolved of these safety functions. Rear automatic emergency braking Engine brake Lane departure warning (which actually jerks steering wheel if it is on and you get close to the edge of the lane) Lane centering assistance These safety sensitive functions turn themselves on and off, no matter the amount of computer updates through the dealer. Dealer has not been able to resolve this issue and the technician has not been able to get Ford to give her any answers as well.

NHTSA ID

11569079

Incident

Jan 30, 2024

The contact owns a 2023 Ford F-450. The contact received notification of NHTSA Campaign Number: 23V506000 (Electrical System) however, the part to do the recall repair was not yet available. The local dealer was contacted and determined that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. VIN tool confirms parts not available.

NHTSA ID

11552730

Incident

Oct 30, 2023

Some 2021-2026 Ford/Lincoln vehicles may exhibit various symptoms including but not limited to the auto start/stop system not operating as intended with a "Check Charging System" message in the instrument panel cluster (IPC) while the charging system is operating properly with no charging related diagnostic trouble codes (DTC) stored. This may be due to someone using an aftermarket programmer to change the body control module (BCM) configuration to disable the auto start/stop system or perform other unsupported programming modifications. To correct this condition on F-150 and Bronco vehicles, download and run the Ford Diagnosis and Repair System (FDRS) application titled "BCM-Charging System Configuration Correction". Running this application will determine if the BCM configuration was modified by the customer and if so, provide the option to return the configuration back to factory settings. For other vehicle models exhibiting concerns related to unsupported aftermarket BCM programming, submit a Technical Support Request (TSR) requesting support to revert the BCM configuration

Some 2023-2026 F-Super Duty vehicles equipped with a 10R100 or 10R140 transmission may exhibit an intermittent failure to engage forward or reverse gears and/or a loud whining noise. Additionally, the driver will be able to shift back to park. This may be due to PCM software being unable to command the transmission solenoid clutch actuators when the battery has a low state of charge (SoC) and/or the vehicle has been jump started. To restore proper transmission functionality, charge the battery as stated in the Workshop Manual (WSM), Section 414-01 Charging System > General Information. Cycle the ignition on then off and leave the vehicle off for 5 minutes to confirm the condition is no longer present. To prevent this issue from reoccurring, refer to the Owner's Manual > Storing Your Vehicle > Preparing Your Vehicle for Storage > 12V Battery. Replacement of transmission components will not resolve this condition. Inform the customer that the condition has no impact on transmission durability. For claiming, use causal part 12A650 and labor operations 12650D, 12650D45, and 12650D81.

Certain 2017-2025 F-450 – F-600 Chassis Cab Upfitted with an Aerial Bucket Frame Rail Crack

Quality improvements include: -Shows trailer brake settings when pressing the brake pedal -Updates the off-road screen to show wider steering wheel turns.

This article supersedes TSB 25-2572 to update the Parts List to correct the part number LC3Z-6006-L to LC3Z-6781-A, remove the flex plate bolts AL3Z-6379-BA from the parts list as these bolts are in kit LC3Z-6781-A, update the claim quantity of the part number W709771-S440 to 9 pieces (F-650/F750-Engine Replacement), W706447-S437 and W715068-S437 to 4 pieces, W712861-S439 to 8 pieces(F-Super Duty Pickup And Chassis Cab-Engine Replacement) / 8 pieces (F-53 Motorhome/F-59 Stripped Chassis Cab/F-650,F750 Engine Replacement) / W714286-S442 to 4 pieces (F-Super Duty Pickup And Chassis Cab-Camshaft and Tappet Repair / F-Super Duty Pickup And Chassis Cab-Engine Replacement), include LC3Z-6020-A for the Engine replacement lists, include 1 fuel injector seal kit to the Camshaft and Tappet repair lists, include 4 pieces of W520114-S440 to the E Series-Camshaft and Tappet Repair list, and update the engine oil part numbers XO-5W30-Q1SP and CXO-5W30-LSP6. Some of the vehicles listed in the Model statement above may exhibit an upper engine ticking or tapping noise at idle. Customers may also report experiencing ro

Some 2023-2026 F-Super Duty vehicles equipped with a 10R100 or 10R140 transmission may exhibit an intermittent failure to engage forward or reverse gears and/or a loud whining noise. Additionally, the driver will be able to shift back to park. This may be due to PCM software being unable to command the transmission solenoid clutch actuators when the battery has a low state of charge (SoC) and/or the vehicle has been jump started. To restore proper transmission functionality, charge the battery as stated in the Workshop Manual (WSM), Section 414-01 Charging System > General Information. Cycle the ignition on then off and leave the vehicle off for 5 minutes to confirm the condition is no longer present. To prevent this issue from reoccurring, refer to the Owner's Manual > Storing Your Vehicle > Preparing Your Vehicle for Storage > 12V Battery. Replacement of transmission components will not resolve this condition. Inform the customer that the condition has no impact on transmission durability. For claiming, use causal part 12A650 and labor operations 12651D, 12651D45, and 12651D80.