2009 Hyundai Azera

In a letter dated August 9, 2013, Hyundai-Kia America Technical Center, Inc. (Hyundai) notified NHTSA that Hyundaiis conducting a safety recall (13V-354) involving approximately 239,000 vehicles involving model year (MY) 2006 through 2010 Hyundai Sonata vehicles (approximately 215,000)produced beginning on March 1, 2005 through January 21, 2010 and model year (MY) 2006 through 2011 Hyundai Azera vehicles (approximately 24,000) produced beginning on September 27, 2005 through November 22, 2010 that are registered in and operated or originally sold in the following 20 salt belt states and the District of Columbia: Connecticut, Delaware, Illinois, Indiana, Iowa, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, West Virginia, and Wisconsin.Hyundai will also inform dealers to inspect/repair vehicles that were previously registered in salt belt states but are currently registered elsewhere. Hyundai is conducting the recall to remedy a defect involving internal corrosion of the rear sub frame that may lead to separation of the rear upper/lower control arm(s) at their respective mounting points and/or separation of the axle from the transaxle where they meet.This could result in a loss of vehicle control and/or vehicle disablement which may increase the risk of a vehicle crash.In response to NHTSA?s Information Request (IR) letter, Hyundai stated the Azera vehicles utilizes the identical cross member and upper/lower rear control arm components as the subject (Sonata) vehicles.In analysis of both Vehicle Owner Questionnaire (VOQ) data submitted to the Office of Defects Investigation (ODI) and consumer complaint data submitted to Hyundai, ODI identified 19 non-duplicative reports alleging excessive corrosion of the rear sub frame. All of the complaint vehicles were either originally sold or registered at the time of the incident in one of the salt belt states.Of these 19 reports, 9 alleged either a suspension component separation or a fracture of the vehicle's rear cross member assembly.Similarly, ODI identified 8 warranty claims of rear sub frame replacement in data submitted by Hyundai due to excessive corrosion, all of which involved vehicles originally sold or operated in a salt belt state. Based on Hyundai's decision to conduct a safety recall, (13V-354) this investigation is closed.The VOQs cited above can be viewed at www-odi.nhtsa.dot.gov/owners/SearchNHTSAID under the following identification numbers: 10535115, 10534110, 10525976, 10524726, 10521520, 10508368, 10505463, 10490073, 10486752, 10486435, 1048354, 10473922, and 10437887.

Good afternoon, my name is [XXX] . I purchased my 2009 Hyundai Azera limited edition in 2019 used with 98385 miles after I had the car for 9mths the car stopped running and the company I purchased the car from uses a repair company called Silver Rock which maintained the car I was told a belt popped after receiving the car back 2 days later the engine blow. They replaced the engine and from there The check engine light stayed on the Diagnostics check stated the O2 sensor needed attention repaired that light went off for a week after a week the check engine light returned had it checked again and the O2 sensor showed up again so I had someone else change them again light went off 2 days later the check engine Light appeared again but with ABS on ESC off TPMS on had another Diagnostics completed and it still shows O2 senors And ABS failure and to constantly replace the issue and it's not working properly afterward has a little upset. Now I saw that Hyundai has a recall on My 2009 Hyundai Azera for the ABS and the interior light which has stopped as well from my understanding but when I called to get help I was told my car is not a part of that recall which is confusing because I am very much having problems with those systems and from what I've read in the manual multiple chain reactions occur With an ABS stops. My car is now not allowing my keyfob to work, the drunk switch on the door and inside the clove box has stopped, and the release for the back seats is not responding I was never given a master key so I can't access the trunk, and the system will unlock the driver door but none of the others there is an issue where the main power box under the hood is not responding to fuse 3,4,17,18,19,20,21,22,23,24 and the same issue is happening to my fuse connection on the inside of the car and when you turn the engine everything is in reverse meaning: door usually lock now the unlock, the AC comes on, the radio comes on, the back window curtain moves. This is unfair to m INFORMATION REDACTED PURSUANT TO THE FREEDOM OF

NHTSA ID

11556817

Incident

May 17, 2020

DEFECTIVE ENGINE COVER GASKET LEAKED OIL ON ALTERNATOR AND DESTROYED IT. SAME CONDITION AS RECENT HYUNDAI VERA CRUZ RECALL. I BELIEVE ENGINES ARE THE SAME BUT AZERA NOT INCLUDED IN RECALL

NHTSA ID

11414494

Incident

Aug 29, 2020

Mileage

44,440 mi

TL* THE CONTACT OWNS A 2009 HYUNDAI AZERA. THE CONTACT STATED THAT THE ENGINE FAILED TO START UP, THE CONTACT HAD TO USE A CABLE JUMPER TO START THE ENGINE UP. THE VEHICLE WAS TOWED TO A LOCAL MECHANIC FOR INSPECTION AND THE MECHANIC ADVISED THAT THE RADIATOR WAS FRACTURED, THE ENGINE EXHIBITED OIL LEAK, AND THE SERPENTINE BELT HAD SEPARATED. THE MECHANIC ADVISED THAT THE ENGINE NEEDED TO BE REPLACED. THE CONTACT ALSO STATED THAT THE VEHICLE ALSO EXPERIENCED WATER DAMAGE. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOT CONTACTED. THE FAILURE MILEAGE WAS NOT AVAILABLE.

NHTSA ID

11351888

Incident

May 1, 2020

EXTREME FIRE HAZARD WARNING - HYUNDAI - INSUFFICIENT WIRING INSULATION. 2009 AZERA STALLED AND DIED GOING 45 MPH DURING LIGHT RAIN 12/9/19. TOW TRUCK DRIVER TESTED BATTERY AND FOUND LOW ALTERNATOR OUTPUT. REPLACED ALTERNATOR AND VALVE COVER GASKET WHERE OIL WAS LEAKING ONTO ALTERNATOR. ONCE REPAIRED, CONTINUED TO GET P0108 ERROR CODE AND STALLING AFTER 20 MIN OF RUN. REMOVED PAINT AND ADDED ELECTRICAL GEL TO ALL MAIN GROUND WIRE TO BODY/FRAME POINTS (ALL WERE PAINTED, UNSURE HOW IT WAS GROUNDED IN FIRST PLACE). PROBLEM PERSISTED WITH NEW CODES NOW P2106, P1295, P0122, P0222, P0123, P0108, P2173, P161B. LIMPED CAR TO LOCAL SHOP AND CALLED HYUNDAI, WHO ASSIGNED CASE #16592407. SHOP SAID MAP SENSOR WAS BAD, REPLACED WITH NEW SENSOR. PROBLEM PERSISTED WITH P0108 CODE IN DRIVEWAY IDLING. DID VACUUM CHECK ON TUBING BUT FOUND BARE WIRES ON WIRING RUN THAT HOLDS OIL PRESSURE, MAP SENSOR, ENGINE TEMP SENSOR AND OTHERS ON 1/1/20. UNDER FABRIC WRAP AROUND WIRE BUNDLES, ALL WIRING INSULATION HAS DISSENTIGRATED CAUSING SHORT CIRCUITS AND BAD MAP SENSOR VOLTAGE. ALL WIRING IS BAD THAT RUNS ACROSS ENGINE TOP HAS BAD INSULATION ALMOST TO ALTERNATOR. EXTREME FIRE HAZARD. ATTEMPTING TO CONTACT DEALER. INSULATION ON WIRES CANNOT HANDLE ENGINE TEMPS AND DISINTEGRATES LEAVING BARE WIRES. 2009 HYUNDAI AZERA WITH 3.3 L V6, 123,000 MILES.

NHTSA ID

11292479

Incident

Jan 1, 2020

Mileage

123,000 mi

ELECTRICAL FIRE

NHTSA ID

11203336

Incident

Feb 22, 2019

Mileage

100,752 mi

THE VEHICLE WAS PARKED IN OUR DRIVEWAY AND HAD NOT BEEN DRIVEN FOR ABOUT 12 HOURS. WE WERE TOLD BY THE FIRE DEPARTMENT THAT THE ENGINE SMOLDERED FOR HOURS AND BROKE THROUGH THE FIRE BARRIER INTO THE CAR AND IGNITED THE INSIDE.

NHTSA ID

11115591

Incident

Jul 28, 2018

Mileage

140,000 mi

ON HIGHWAY HEADING TO HUTCHINSON RIVER PARKWAY FROM THROGS NECK BRIDGE IN THE BRONX AND THE ENGINE STOPPED RESPONDING TO THE PRESSURE ON THE PEDAL. WE WERE IN HEAVY TRUCK AND CAR TRAFFIC BUT WERE ABLE ,BY LUCK TO GET INTO A STRIPPED AREA TO STOP. WE LOOKED IN THE MANUAL AND FOUND WE COULD RESTART THE ENGINE BY TURNING THE IGNITION ON AFTER SHUTTING IT DOWN. THIS HAPPENED 3 KMORE TIMES UNTIL WE WERE ABLE TO GET TO A SAFE PLACE AND WERE ADVISED BY A LOCAL HYUNDAI DEALER NOT TO DRIVE THE VEHICLE . WE EVENTUALLY GOT TOWED TO OUR HOME ON LONG ISLAND BY AAA . LOCAL HYUNDAI DEALER SENT US TO ATLANTIC HYUNDAI FOR REPAIR.

NHTSA ID

11102545

Incident

Jun 16, 2018

Mileage

26,700 mi

WHEN TURNING THE BLINKERS DO NOT MAKE AND AUDIBLE SOUND WITH BLINKER WORKING AND BLINKER INDICATING ON DASH. DEALER CONFIRMS THAT FAULTY PART IS IN INSTRUMENT CONSOLE AT COST OF APPROX $2500. THIS PART SHOULD BE CONSIDERED A CRITICAL SAFETY ITEM AND TESTED TO FAILURE FOR THE LIFE OF THE VEHICLE. FAILURE OF THIS PART CAN LEAD TO ACCIDENTS RESULTING IN INJURY OF DEATH.

NHTSA ID

11088355

Incident

Feb 6, 2018

Mileage

125,000 mi

The National Highway Traffic Safety Administration (NHTSA) has issued an urgent safety advisory regarding dangerous, counterfeit driver‑side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN), that have been identified in U.S. vehicles following prior crashes, theft, or non‑certified airbag replacements. These inflators are not approved for use, may rupture during deployment, and have caused serious injuries and fatalities. Please see attached announcement, provided by NHTSA, for more details.

The National Highway Traffic Safety Administration (NHTSA) has identified the presence of substandard and dangerous driver’s-side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN). These inflators were not supplied, approved, or authorized by the vehicle manufacturers and have primarily been found in vehicles that previously experienced a crash and underwent airbag replacement using non-genuine parts. These dangerous inflators have ruptured during deployment, posing a serious risk of injury or death due to metal fragments entering the vehicle cabin. To date, Hyundai is aware of three people who have died while driving a Hyundai vehicle with one of these substandard replacement airbag inflators that deployed in what likely would have been a survivable crash. NHTSA has issued a public advisory urging vehicle owners and service professionals to have vehicles inspected if there is reason to believe that a non-genuine replacement airbag may have been installed. Vehicles with salvage or rebuilt titles, prior airbag deployments, or unknown repair histories may present a higher risk. NHTSA strongly cautions against self-inspection by vehicle owners and recommends inspection by trained technicians.

This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.

This TSB provides a procedure to diagnose and replace, if necessary, an automatic transmission with Incorrect Ratio DTC (transmission clutch slip in gear above limit) listed on Page 2.

This bulletin contains information about the proper removal of the windshield wiper blade protective cover on all models. If the protective cover is not removed correctly, there is a possibility of the rubber insert and rail spring becoming partially separated on the inner side of the wiper blade, which could lead to poor wiping performance and/or possible scratching of the windshield glass. Follow the procedure in this bulletin to properly remove the windshield wiper blade protective cover on all new wiper blades.

This bulletin provides important checkpoint guidelines when performing engine oil and filter change services.