2013 BMW 328I

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

In a letter dated September 26, 2013, BMW Group submitted a safety recall notice to NHTSA identifying a defect condition in the vacuum pump oil supply that may result in loss of power assist braking in 76,191 model year (MY) 2012 through 2014 BMW 3-Series, 5-Series, X1 SAV, X3 SAV, and Z4 vehicles equipped with 4-cylinder engines (NHTSA Recall 13V-454).According to BMW, movement of the seal disk within the camshaft may result in blocking of the oil supply to the vacuum pump, resulting in improper pump operation and loss of power assist braking.On July 11, 2013, BMW initiated a change to the camshaft geometry that prevented the seal disk from blocking the oil port.BMW has not received any braking complaints related to loss of power assist after the design change was implemented in production.The owners of all affected vehicles will be contacted by mail and asked to take their vehicle to a BMW dealer who will install a locking ring into the camshaft to keep the seal disk in its proper location.BMW expects to begin dealer and owner notification in November 2013 and complete dealer and owner notification in December when the remedy is expected to be available.Based on the actions taken by BMW, this investigation is closed.

I was at the John Wayne Airport, going from the arrivals to departures. I had a lot of stop and go traffic, and when I was going down toward the bottom, my brakes failed. I kept pumping them to try and stop but they were not working. I saw an empty area where the car rental returns were and I was able to pull over and come to a stop. I was very lucky that there was a spot to pull over, I used the emergency brake as well when I finally came to a stop. I want the brake system to be looked into. After seeing the other complaints regarding the exact situation, I do not understand why this was not looked into before I got this car.

NHTSA ID

11754330

Incident

Aug 1, 2026

The contact owns a 2013 BMW 328I. The contact stated that while driving at an undisclosed speed, the accelerator pedal was depressed; however, the vehicle failed to accelerate as intended. The drivetrain and passenger’s side air bag warning lights were illuminated. The vehicle was driven to the shoulder of the road. The contact turned off and restarted the vehicle; however, the failure reoccurred. The contact stated that the vehicle failed to accelerate above 25 MPH and the vehicle was shaking erratically. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The manufacturer was not made aware of the failure. The failure mileage was approximately 174,775.

NHTSA ID

11753235

Incident

Jul 28, 2026

Mileage

174,775 mi

2013 BMW 328i, N20 engine. Timing chain guide assembly and oil pump drive chain failed catastrophically. Vehicle is available for inspection, however the authorized BMW dealership has already made clear they will accept no responsibility, and I would bear the expense of towing it two hours to their facility. The failure is a known issue with a class action case, but BMW took no responsibility, and falsified information stating the vehicle showed no signs of an issue when I brought my vehicle in for inspection. Eighteen months before failure, steam came from the engine compartment on a humid day, later connected to the water pump electrical connector recall. Following this, the vehicle ran consistently hotter than normal and lost noticeable power. Twelve months before failure, an intermittent oil pressure warning began triggering under load at highway speeds, particularly on inclines above 70mph. I brought the vehicle to Sandia BMW in Albuquerque, NM and reported all symptoms when I was contacted by them for the recall. The service advisor falsely claimed elevated operating temperature was optimal, suspected a faulty sensor, and returned the vehicle without offering further diagnosis or making me aware of the impending issue, all classic signs of the engine faults. Eight weeks later, the oil pressure light activated on a highway, followed immediately by a drivetrain malfunction warning, a violent grinding sound, and complete loss of power. The vehicle was towed and has not restarted since. I contacted BMW of North America's recall line. A case was opened and an advocate stated BMW would accept no responsibility because the class action was closed and I'mpast 70K miles. I raised the dealership's direct culpability. The advocate stated a dealership representative would contact me. No call was ever received. This failure is consistent with BMW Service Bulletin SI B11 03 17. A engine safety recall is warranted regardless of age to protect the public.

NHTSA ID

11723979

Incident

Dec 15, 2025

The contact owns a 2013 BMW 328I. The contact stated that while driving at an undisclosed speed, an unknown warning light illuminated. The vehicle was taken to the dealer, where it was diagnosed with a hole on top of the fuel tank. The contact was informed that the fuel tank needed to be replaced. In addition, the contact was informed that the failure was a known failure with the vehicle. The contact stated that the manufacturer had previously initiated an extended warranty coverage for similar vehicles; however, the repair was not covered under the Extended Warranty. The manufacturer was made aware of the failure but provided no assistance. The failure mileage was approximately 56,910.

NHTSA ID

11713400

Incident

Dec 26, 2025

Mileage

56,910 mi

The contact owns a 2013 BMW 328i. The contact stated that while driving at an undisclosed speed, the engine overheated, and multiple warning lights were illuminated. The contact then stated that the vehicle lost power and would not restart. The vehicle was towed to an independent mechanic, where it was diagnosed that the water pump and electrical plug connector had failed and needed to be replaced. The vehicle was repaired. The contact later received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System). The vehicle was taken to the dealer, where it was not diagnosed or repaired. The contact requested reimbursement for the cost of the repair that was performed prior to the safety recall, but the dealer informed the contact that the reimbursement claim was denied. The manufacturer was made aware of the failure, and the manufacturer also denied the reimbursement claim. The approximate failure mileage was 89,565.

NHTSA ID

11704595

Incident

Dec 11, 2025

Mileage

89,565 mi

See attached document for complaint. I am writing in reference to the recall on my 2013 BMW-328xi. The vin number is. The recall is for the water pump electrical connector. My water pump failed May 2024. I went to an independent repair service center that specializes in BMW repair, which in turn was the closest service center to where the vehicle broke down. I paid out of pocket for the repair. Now there is a recall on this part, I would appreciate reimbursement for the charges. I am enclosing a copy of the invoice.

NHTSA ID

11699384

Incident

Oct 16, 2025

Passenger Restraint system malfunction for the front passenger seat. This may not trigger the airbag for a passenger sitting in the front if a collision occurs and can seriously injure someone. This problem appears to be very common with BMW models within this timeframe. All over car forums and youtube videos, some videos with over 100k views per video. I am not sure how BMW has not recalled this safety issue as it seems to linger throughout many of their models for many years. As soon as the malfuction occured\, the warning sign and lamp lights did flash on.

NHTSA ID

11686437

Incident

Sep 10, 2025

The contact owns a 2013 BMW 328I. The contact’s daughter stated that while driving at an undisclosed speed, there was smoke coming from the engine compartment. There was no warning light illuminated. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); and the vehicle was taken to the dealer to have the water pump replaced. The contact was informed by the dealer after the repaired that the valve cover gasket had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 123,000.

NHTSA ID

11675730

Incident

Jul 23, 2025

Mileage

123,000 mi

The basic conditions for initializing the power windows are not met.

The electrical system of BMW vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This document covers important information for the dealer on how to handle “discharged battery” complaints.

After programming the head unit (HU-H2), activating the FSC (German word Freischaltcode) Enabling Codes repeatedly fails.

Upon opening and closing the tailgate, a creaking/groaning sound can be heard from tailgate actuator.

Exterior rear lights do not work.

The 3G network in the US has been shut down. This means that only the 4G network will be available. In the 4G network, voice calls will be transferred via the Voice over LTE (VoLTE) function. For this purpose, the SIM card must perform an IMS registration in the mobile communication network. Due to a production error, the telematics control units were delivered without an IMS configuration. The Connected Drive voice services (Concierge Call, BMW Assistance, and emergency call voice) can no longer be used regionally in the US in vehicle with telematics control units ATM-1 and TCB-4G. Voice control of the vehicle and all other telephone (paired mobile devices) functions are not affected. Emergency call location data is unaffected.