ELECTRONIC STABILITY CONTROL (ESC)
2025 Chrysler Voyager
Recalls, owner-reported complaints, investigations and safety data
Overview
Our database contains no NHTSA owner-reported complaints for the 2025 Chrysler Voyager. 6 safety recalls have been issued covering this model year; and 204 manufacturer communications are on file.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Safety recalls
6 campaigns cover this model year
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govAIR BAGS:FRONTAL
AIR BAGS:SIDE/WINDOW:CURTAIN
Recent owner complaints
Reports submitted to NHTSA, shown in the owner's own words
No owner complaints recorded for this model year
Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.
Manufacturer communications
A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.
BACK OVER PREVENTION: REARVIEW SYSTEM BRAKING
Rear View Camera This part requires manual claim review. If a DID-I of the failure condition is not uploaded, even for claims falling outside of 3 months in service, then the claim will be rejected. For claims related to blurry or poor image quality refer to SOL S2208000045, the content of which has also been added to the service manual, needs to be followed to generate the DID-I for review.
ELECTRICAL SYSTEM
FUSE BLOCK UNDERHOOD - PWR DIS A/C Blowing hot air or not working. A/C relay clutch not operating, dealers are unnecessary replacing PDCs. Battery disconnection is required to reset PCM. Please follow SOL S2624000004.
POWER TRAIN
DIFFERENTIAL Rear Axle Some AWD Chrysler Pacificas are exhibiting a grinding noise coming from the PTU when it's shifting from 2WD to AWD. C1477-48 may also be present. To engage AWD, the DTCM energizes the hydraulic pump inside the RDM to apply the torque transfer clutch. This allows the propeller shaft to spin up to speed and match the front axle speed allowing the shift fork in the PTU to engage without clashing. The DTCM utilizes the pressure sensor on the RDM to determine the amount of hydraulic pressure applied to the clutches. If that pressure sensor fails, there can be inadequate pressure, preventing the driveshaft from coming up to speed when going into AWD. This will cause a grinding noise in the PTU. If the vehicle comes in with a grinding noise coming from the PTU, prior to replacing the PTU or RDM, replace the RDM pressure sensor 68227790AD and verify whether the concern has been resolved.
ELECTRICAL SYSTEM
Inspect wiring harnesses, connectors, terminals, power and ground circuits, and verify proper system signals before replacing RU Blower motor, with PN#68308952AD
ELECTRICAL SYSTEM
Note: Document released 10/2/2026. Multiple Warning Indicators On In The IPC. ESM - PRNDL Flashing. And The Vehicle Will Not Shift Into Gear. The Wipers May Be On, With An Electric Parking Brake Unavailable.
ELECTRICAL SYSTEM; POWER TRAIN
Shifter/ESM PRNDL Indicators Remain Off After Drained Battery Event And Jump Start
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Compare model years
Complaint and recall counts across every year of this model
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.