2014 Dodge Challenger

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

: The vehicle’s steering wheel intermittently hardens or "locks" while in motion, making it extremely difficult to maneuver and creating a severe safety hazard. This issue remains unresolved despite two separate professional repair attempts. The first attempt cost $600.00, and the second attempt at a different facility cost $1,500.00. Despite a total expenditure of $2,100.00, the steering failure persists. The defect appears to be a systemic failure within the Electric Power Steering (EPS) or associated control modules/wiring that is not being corrected by standard repair procedures. The vehicle remains dangerous to operate.

NHTSA ID

11734553

Incident

Feb 9, 2026

Subject VIN sits in database as completed for Takata Airbag replacement completion during previous Passenger Air Bag NHTSA Recall; however, recent "Do Not Drive" warnings that include this year model now state that Driver Side Airbag has also been determined to now need replacement. Having been on the telephone for numerous telephone calls over this past week with Dodge's Takata Airbag Team, Dodger Service Departments, and NHTSA to inquire about what next actions I should take with the well-advertised "Do Not Drive" warning through a variety of media channels to include my 2014 Dodge Challenger have been frustrating at best. The ineptitude and inaction to move on this recall, reclassify vehicles as having an outstanding recall if both Passenger Airbags Assemblies (Driver- and Passenger- sides) have not been replaced. A requirement for the manufacturer (in this case, Dodge) to streamline complimentary towing of the unsafe vehicle to a dealership with a service department (while also ensuring respective Airbag assemblies are in repair parts inventory with technicians trained to conduct replacement maintenance correctly), and afford a complimentary temporary vehicle to use during day-to-day living until the reparations are executed to render the vehicle safe again and that vehicle is returned to the owner. The ineptitude to date by manufacturer (Dodge) and NHTSA to this juncture is unfathomable. All parties need recalibration and competency should be paramount in this safety crisis of the Takata Airbag debacle. Wake up . . . . immediately, if not sooner and get it all in one sock folks! The vehicle was taken to Southpoint Dodge in Austin, Texas under recall in March 2019 and had the Passenger Side Airbag replaced under the recall at that time; however, the Driver Side Airbag was not of concern when that recall was executed and the Driver Side Airbag is still stock from the manufacturing assembly line when the vehicle first became available for sale in late 2013.

NHTSA ID

11719451

Incident

Feb 13, 2026

Steering wheel locks up at while driving making it very hard to turn. The dealerships, wants $200/300 for a diagnostic fee and $3k to repair it. This has been reported for years now as you can se with the other complaints. Dealerships must be held accountable for such safety hazards. Thousands of these cars are on the road and millions of lives are in danger. You are our voice please speak up for the consumer. Thanks

NHTSA ID

11706014

Incident

Jan 2, 2002

On August 7, 2025, at approximately 11:30 PM, my 2014 Dodge Challenger caught fire in the trunk area where the battery is located. I had just parked at my location and was about to get out of the car when I noticed a strong burning smell and smoke coming from the rear. Flames were visible inside the trunk. The fire damaged the trunk interior, wiring, and surrounding components, but the battery still functioned afterward. There were no warning lights or prior issues before the incident. This poses a serious safety hazard and could have caused injury or further damage if it had occurred while driving.

NHTSA ID

11679511

Incident

Aug 7, 2025

Was driving out of the parking lot when I started to drive I felt the car shifted then the engine light came on.Took it to auto zone the next day and they said it’s an incorrect gear rotation on their scanner. The car feels fine when I drive and it’s not shaking at all.

NHTSA ID

11634174

Incident

Jan 4, 2025

There is a fuel leak in the vehicle.

NHTSA ID

11627618

Incident

Nov 7, 2024

UNKNOWN

NHTSA ID

11595824

Incident

Oct 28, 2023

The ABS system has failed on my 2014 Dodge Challenger SXT and has caused major electrical issues within the vehicle. The ABS part/computer module (part number 68210118AB) has been on back order for months with no estimate of when the part will be available from a Dodge/Chrysler/Ram/Jeep dealership. I have been without my vehicle for 4 months because nobody has this part available. This is a major issue affecting many vehicles under Dodge/Chrysler/Ram/Jeep. My safety was at risk because while I was driving the vehicle, every single light on my dashboard appeared and my brakes stopped working. Thankfully I was leaving my neighborhood and was only going 15MPH. The key fob is not detectable, the windows will not roll up, and the vehicle cannot hold a charge while in drive. There was an ABS warning lamp on prior to this all happening.

NHTSA ID

11595269

Incident

Feb 25, 2024

Aluminum Body Panel Corrosion Repair Aluminum corrosion or bubbling along the leading edge of hood, hinges or other exterior surface areas of the hinges, doors, fenders, swing gates or liftgates.

Aluminum Body Panel Corrosion Repair Aluminum corrosion or bubbling along the leading edge of hood, hinges or other exterior surface areas of the hinges, doors, fenders, swing gates or liftgates.

Aluminum Body Panel Corrosion Repair Aluminum corrosion or bubbling along the leading edge of hood, hinges or other exterior surface areas of the hinges, doors, fenders, swing gates or liftgates

"Aluminum Body Panel Corrosion Repair Aluminum corrosion or bubbling along the leading edge of hood, hinges or other exterior surface areas of the hinges, doors, fenders, swing gates or liftgates. NOTE: Verify current warranty policy to determine if digital imaging pre-authorization is required or pre-approval is required from the Regional Office; depending on market. This bulletin involves inspecting and if necessary removing corrosion and refinishing the suspect aluminum panels on the vehicle, hood, door, fenders, hinges, swing gates or liftgate panels."

Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On

LIFTER, Hydraulic Roller Deactivating Please do not replace MDS lifters because the disconnecting pin is not lined up, this is normal and not a defect.