2020 Dodge Challenger

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

My steering was locked up when I started my car in the cold then on my first turn, it completely locked up and it did this several times and it makes a grinding noise. I am assuming one of the bearings has failed in it, but it failing on me the rack locking up is something different I believe.

NHTSA ID

11734903

Incident

Feb 19, 2026

In your own words, tell us what happened. Cro I have an urgent and safety issue with my 2020 Dodge Challenger Hellcat. I was driving on road from work. When I was approaching a red light coming to a complete stop. I pressed the clutch to engage the gear into neutral. Suddenly I heard a loud snapping sound, I lost all pressure to the clutch and almost hitting the vehicle in front of me because I couldn't get it out of gear. Nearly causing multiple car accident with all the cars infront and behind me on the road. I had to shut off the engine so the vehicle would come to a complete stop. Vehicle was towing into the closest Dodge dealership (Sahara CDJR in Las Vegas). After 2 days in the shop, the service advisor just called me and stated that it's the clutch pedal push rod that snapped and the entire pedal assembly need to be replaced, which would not be covered. I asked him and he confirmed it's not a common thing to break at the low miles (14741 miles on the vehicle) but I need to reach out to Dodge Customer Service to see if it would fall under "defective parts" claim. Please help me open a case and take care of this issue. It is a very serious safety issue if the rod would just snap like that during normal vehicle operation. This could have needed very badly. Thank you!

NHTSA ID

11698843

Incident

Nov 7, 2025

I have an urgent and safety issue with my 2020 Dodge Challenger Hellcat. I was driving on road from work. When I was approaching a red light coming to a complete stop. I pressed the clutch to engage the gear into neutral. Suddenly I heard a loud snapping sound, I lost all pressure to the clutch and almost hitting the vehicle in front of me because I couldn’t get it out of gear. Nearly causing multiple car accident with all the cars infront and behind me on the road. I had to shut off the engine so the vehicle would come to a complete stop. Vehicle was towing into the closest Dodge dealership (Sahara CDJR in Las Vegas). After 2 days in the shop, the service advisor just called me and stated that it’s the clutch pedal push rod that snapped and the entire pedal assembly need to be replaced, which would not be covered. I asked him and he confirmed it’s not a common thing to break at the low miles (14741 miles on the vehicle) but I need to reach out to Dodge Customer Service to see if it would fall under “defective parts” claim. Please help me open a case and take care of this issue. It is a very serious safety issue if the rod would just snap like that during normal vehicle operation. This could have needed very badly. Thank you!

NHTSA ID

11698840

Incident

Nov 7, 2025

Air conditioning system failed. Stopped blowing cool air. Leak developed in system and it was traced to the evaporator core

NHTSA ID

11687485

Incident

Aug 1, 2025

Cooling fans exploded an went through radiator, making the car inoperable!

NHTSA ID

11674304

Incident

Jul 15, 2025

Good afternoon, my right headlight wiring harness had rubbed on the frame down to the wires, actually meta l to metal and caused my head light to blow out and my turn signal to malfunction and there is no warning light for the headlight being out, I called the dealership and they said there's no recall and they want a lot of money to fix this problem, I'm afraid it may cause a fire, I've noticed this for about a week, I ordered a new light on 8/22 and that's when I noticed the bare wires

NHTSA ID

11611574

Incident

Aug 21, 2024

Seat belt starting to unlock on its own-Driver Airbag malfunction-Passenger seat Reverse gear malfunction -code. Tsb 21-039-24

NHTSA ID

11604477

Incident

Jul 10, 2024

On 11-Jul-24 about 3:45 pm I was driving on the highway appox 70 mph and my sunroof exploded. There was only one car near me and not in a position to throw up any rocks.

NHTSA ID

11601579

Incident

Jul 11, 2024

Backup Camera Poor Image Quality Inspection

Flash: Powertrain Control Module (PCM) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must SYMPTOM: exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● **P0111-00 - Intake Air Temperature Sensor 1 Circuit Range Performance Bank 1. (In Active or Stored status) ● P0071-00 - Ambient Air Temperature Sensor Performance. (In Active or Stored status) ● P0072-00 - Ambient Air Temperature Sensor Circuit "A" Low. (In Active or Stored status) ● P0073-00 - Ambient Air Temperature Sensor Circuit "A" High. (In Active or Stored status) ● P0011-00 - Bank 1 Camshaft 1 Position Timing Over Advanced Or. (In Active or Stored status) ● P25E4-00 - B Camshaft Position - Unable To Achieve Locked Position Bank 1. (In Active or Stored status) ● P05BD-00 - Stop-Start Mode Switch Range/Performance. (In Active or Stored status) ● P0116-00 - Engine Coolant Temperature Sensor 1 Performance. (In Active or Stored status) ● P062B-00 - Internal Control Module Fuel Injector Control Performance. (In Active or Stored status) ● P0604-00 - Internal Control Module Random Access Memory Ram Error. (In Active or Stored status) ● P060C-00 - Internal Control Module Main Processor Performance. (In Active or Stored status)** ● P018B-00 - Fuel Pressure Sensor "B" Circuit Range/performance. **(In Active or Stored status)** ● P1CEA-00 - Boost Side EVAP Purge System Performance. **(In Active or Stored status)** ● P06DD-00 - Engine Oil Pressure Control Circuit Performance/Stuck Off. **(In Active or Stored status)** ● P00C6-00 - Fuel Rail Pressure Too Low - Engine Cranking. **(In Active or Stored status)** ● P0300-00 - Multiple Cylinder Misfire. **(In Active or Stored status)** Customers may also experience one or more of the following: ● **Oil Level High Warning in the Instrument Panel Cluster (IPC).** ● Fully Autonomous Parking Assist (FAPA) is not deactivated when accelerator pedal is pressed. ● Vehicle is not heating up fast enough at freezi

Backup Camera Poor Image Quality Inspection

The vehicle will exhibit a service transmission/check engine warning indicator for the following transmission models: 845RE, 8HP45, 850RE, 8HP50, 8HP70, 8HP75, 8HP75-PHEV, 8HP75-LCV, 8HP90, 8HP95. Transmissions may exhibit the following diagnostic codes: P07E4, P1DB2, P0716, P1B14, P0733, P1D90, P1DB7, P1B13.

Active Diagnostic Trouble Code (DTC) B1A10-00, B1A11-00, B1A12- 00, B1A13-00-, B1A14-00, B1A15-00, B1A16-00, and B1A17-00 in The Radio Frequency Hub (RFH)

Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On